Question about Buick LeSabre

Open Question

Fuel filter location 1996 buick lesabre - LeSabre Buick Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: location of blower resistor

The 96 LeSabre Custom and LeSabre Limited use an electronic module in place of a blower resistor.
It is under the hood on the firewall on top of the heater plenum, but below the relay rack.
They tend to short and run on high until the module burns out and then it quits.
The same part is used on many high-end GM cars from 92 to 96. The electronic module has two connectors on it. (If yours has only one plug it is a real resistor pack and not electronic.)

Posted on Nov 05, 2008

c17hydro
  • 2984 Answers

SOURCE: who do I locate the fuel filter for my buick lesabre 99?

Fuel Filter Removal & Installation To Remove:

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Disconnect the negative battery cable.
  3. Relieve the fuel system pressure.
  4. Raise and support the vehicle.
  5. Disconnect the plastic quick connect from the fuel filter inlet.
  6. Unthread the fuel filter from the outlet pipe.
  7. Drain remaining fuel into a gasoline container
86a9bf2.jpg
To Install:
  1. Remove the new fuel filter protective caps.
  2. In the same position as on the old fuel filter, install the new plastic connector retainer on the fuel filter inlet.
  3. With clean engine oil lubricate the new fuel pipe O-ring and install it on the outlet pipe.
  4. Connect the fuel filter inlet to the quick connect fitting.
  5. Thread the fuel filter into the fuel outlet line, and using a back-up wrench prevent the nut from turning torque to 22 ft-lb (30 Nm).
  6. Lower the vehicle.
  7. Install or tighten the fuel cap.
  8. Connect the negative battery cable.
  9. Check for leaks using the following procedure:
    1. Turn ON the ignition for 2 seconds.
    2. Then OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
  10. Install the fuel injection sight shield.

Posted on Apr 02, 2009

  • 599 Answers

SOURCE: Crankshaft Position Sensor

the dual crankshaft position sensor is secured in an aluminum mounting bracket and bolted to the left side of the timing chain cover, partially behind the crankshaft balancer, hope this helps get back to me if you need mre help. please rate my fix as i strive to be the best

Posted on Apr 29, 2009

bluelightnin
  • 35 Answers

SOURCE: Fuel relay placement 1991 Buick LeSabre. Replaced pump & filter still won't start

Your vehicle's fuel pump relay is located on the relay center, behind the glove box, 2nd column of relays, 2nd one from the top.

Posted on May 23, 2009

AutoDoc
  • 169 Answers

SOURCE: where is the fuse box location 1989 buick lesabre

Hi J_livezey,
Your fuse box is located behind the right side of the dash,to the right of the glove box.Here is a diagram to better expalin.If you need anything else,let me know. Thanks,Chuck.1da4d0d.gif

Posted on Mar 10, 2010

Testimonial: "thank you chuck very much worked great now if you can help me with my radio. posted you are great"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuel filter located on a 1994 buick lesabre


look under pass.rear door under car it will be attached to a fuel line



Dec 10, 2010 | 1994 Buick LeSabre

2 Answers

Where is the fuel filter located on a 2000 Buick LeSabre, 3.8 engine?


The fuel filter would be located right around the gas tank underneath the vehicle but I do believe that it is electronic and is in the gas tank.

Apr 19, 2010 | 2000 Buick LeSabre

2 Answers

Locate fuel filter for a 1991 buick lesabre limited


fuel filter should be in the tank with the fuel pump.

Jan 04, 2010 | 1991 Buick LeSabre

1 Answer

Where is the fuel filter on a 2000 buick leSabre


The fuel filter is located in the fuel feed line attached to the underbody, directly in front of the fuel tank.

Check the link below:

http://www.2carpros.com/forum/automotive_pictures/261618_0900c1528021796a_1.jpg

Have a great day!

Sep 07, 2009 | 2000 Buick LeSabre

1 Answer

Where are my fuel filters?


Fuel Filter 1994 Buick Lesabre 3.8L SFI OHV 6cyl The Fuel Filter is located: There are two possible locations for this component due to variation in production under vehicle, passenger side, front of fuel tank, mounted on frame in fuel line or under vehicle, driver side, front of fuel tank, mounted on frame in fuel line


hope this helps thank you jm

Aug 10, 2009 | 1994 Buick LeSabre

1 Answer

1996 buick LeSabre runs rough at 50 mph


Sounds like low fuel pressure. i.e. fuel pump, fuel pressure regulator, or fuel filter.

Jun 02, 2009 | 1996 Buick LeSabre

1 Answer

Fuel relay placement 1991 Buick LeSabre. Replaced pump & filter still won't start


Your vehicle's fuel pump relay is located on the relay center, behind the glove box, 2nd column of relays, 2nd one from the top.

May 23, 2009 | 1999 Buick LeSabre

2 Answers

Fuel filter location on car.need to change


Passenger side, rear of engine compartment, attached to lower rail. clearpixel.gif

Nov 02, 2008 | 1996 Buick LeSabre

1 Answer

2000 buick lesabre stall after starting or after running for 30 minutes


I have a 1996 Lesabre. I had a similar problem that slowly got worse. I brought it to two different mechanics that did diagnostic checks and could only "suggest" what to replace to fix the problem. Their problem was that it wouldnt stall out while they had the mv. After replacing a bunch of sensors and the fuel pump/ filter, I solved the problem by replacing the Crank Sensor. Its located behind the lower crank pulley on the 3.8 lt motor. Hope this helps!

Oct 21, 2008 | 2000 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

661 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...