Question about Cars & Trucks

Open Question

Where do I fill gear oil from - mazda etude 1999 model

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Mazda Etude 160ie timing

I have a problem with the mazda etude 160ise, the crank shaft sensor was damages and replaced it ad now the car cant tart. Note that the timing was afected in that the two sealings were replaced. Could one please provide information as to how I can get in timing and get it going again.

Posted on Nov 27, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda Etude 1.8 sportswagon 2001 model. Replaced cambelt-cambelt not running true. Partly running off top gear pulleys & rubs on belt cover. What could be cause as mechanic repaired-still happening.


This is caused by one of your pullys being out of line with the others, posiblly because of a bad bearing or one just not assembled correctly. I'd check this with a straight edge on the front of the pullys.

Jul 10, 2017 | Mazda Cars & Trucks

1 Answer

Hi my Mazda etude 1999 model is overheating oil the water is boiling in side the cooler once you switch off the engine but inside the deshboard the heat gaurd its normal so I don't know what wrong


Sounds like you may have a blown head gasket. If there is oil in the coolant, and musty brown look and smells bad that's the culprit. I would do a rad flush and oil change and see what happens next...

Dec 21, 2016 | Mazda Cars & Trucks

1 Answer

Hi i got a 1996 mazda etude when i change gears it got a gerk some times when i stop at a robot and want to pull away it just die


if this is a clutch transmission, sounds like the clutch is sticking..may need a new disc in there..need to have it looked at at a transmission shop..rust or dirt/oil etc on disc..

Dec 14, 2013 | Cars & Trucks

2 Answers

Mazda Etude 160ie timing


I have a problem with the mazda etude 160ise, the crank shaft sensor was damages and replaced it ad now the car cant tart. Note that the timing was afected in that the two sealings were replaced. Could one please provide information as to how I can get in timing and get it going again.

Jan 02, 2009 | 2004 Mazda 3

1 Answer

Mazda etude alternator genarting excessive heat


1st off you would give everything a good visual examination. Look for loose alternator belt. Also look for wires that could have become disconnected or cut that leads to the alternator.

Then you would hook up a volt meter to the battery cables and check the voltage.
After this you would start the engine and recheck the voltage. The voltage on a charged battery should read around 12.5 volts. While the engine is running turn on a few accesories and speed up the idle a little the voltage should read around 14.5 volts.

If the voltage does not increase suspect either a faulty alternator or regulator.

Sep 09, 2008 | 1999 Mazda 626

1 Answer

Problem with Altenator belts Etude


the problem is not the altenator. you should have a idler pully and a self adjusting idler tensioner. if thes e go bad the bearings tend to seize up and break belts i would check these first chance you get the tensioner should be spring like and be hard to move back and forth the pulley part of it should spin freely with out makeing a noise. please rate this

Sep 01, 2008 | 1999 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...