Question about 1993 Jaguar XJ6

1 Answer

Why is it not gainig speed whe exalerating at 20mp

Posted by on

Ad

1 Answer

If your going to ask a question provide some info
Would be nice if you or a shop actually worked on
the car to find a problem & a solution to it
How about an Exhaust Converter that has been on there
15 years or more & is blocking the exhaust out.

Posted on Jul 28, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power door locks won't work and the instrument pnnel lights won't turn on. I replaced blown fuse a 20mp one in position 14 I believe. worked ok till I tried to lock the doors, the fuse blew


Hello. Try looking at the black earth that goes from the drivers door and into the A frame which is covered in a rubber sheath. The wire can break after opening and shutting the door over several years and as it's normally the thicker wire is more prone to break. Also check the other wires visually for any chaffing and tugging on each wire. If more electrical parts start failing, air con blowers etc it will be an earth. Hope this helps

Nov 03, 2012 | 2002 Dodge Neon

1 Answer

95 Buick Lesabre fan motor wont run Have power to fan when fan switch is off and in low speed & medium but goes of whe put in high speed help


you need to look at the blower motor resister some times when they burn out it jumps to the other terminals

Jul 07, 2012 | Cars & Trucks

1 Answer

My car is pull off slow and want go 20mp


This is called "limp mode" you should have a mechanic diagnose the problem.

Sep 08, 2011 | 1995 Lexus ES 300

1 Answer

At 70 mph the abs and parking brake light turn on and the the transmission loose presion and stop working, whe you stop the engine looks like the problem is reseted and work again, but then the problem...


Rear speed sensor fails at higher speeds. ecm cant tell what gear to go to and abs looses rear wheel speed. When you start over it sees speed till it hits the higher speed. Been there done that. :-)

Jun 06, 2011 | 2002 Chevrolet Silverado 2500HD

1 Answer

2006 Chevy Silverado 4wd HD. Blower motor started running all the time even whe the key was removed. I removed the fuse under the hood and the fan stopped. It now works only on speeds 1-4. Is there a high...


there could be partial contact in the blower controls which has resulted in total loss of contact, in blower speed affected. replacement of the entire blower control switch should resolve it

Dec 26, 2010 | 2006 Chevrolet Silverado

1 Answer

My car has a problem where when i exalerate


it could be timing or it may be a bad speed control sensor. have someone check the timing. if the timing is ok then id try the sensor its not that expensive. should be under 50 dollars at auto zone.also when you say you had it serviced are you meaning a tune up as well if you havent had the car tuned up in the last 35-40,ooo miles id have that done as well.

Nov 14, 2009 | Nissan Pulsar Cars & Trucks

1 Answer

5 speed having truble exalerating


engine knocking is produced when when the pistons misfire. Try adding Octane 89 at the pump. if that fixes the noise then all set, if not then you have another problem much bigger.

Poor acceleration can be from drivers error. make sure you shift and the correct time and at the proper RPMs. Lets assume you are shifting correctly, the poor acceleration could be from a leaking head gasket.

Aug 09, 2009 | 1996 Pontiac Sunfire

1 Answer

Shudders and dies when braking


this is most likely caused by a dectective torque converter clutch soleniod not unlocking the torque converter clutch whe the brake is applied..

Jun 03, 2009 | 1993 Oldsmobile Cutlass Supreme

2 Answers

Exaleration problem


you have the drive by wire type you will need to get your speedsensors looked at by your local garage

Feb 13, 2009 | 1999 Volvo S80

Not finding what you are looking for?
1993 Jaguar XJ6 Logo

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...