Question about Cars & Trucks

1 Answer

2007 mazda 3, car locked and key fob broke. Now I can't open the doors without the horn going off and cannot start the car. Tried unplugging thw battery and plugging it back in with no luck. Is therea fuse for the immobilizer that I can just pull? Any solutions would be greatly appreciated

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Expert
  • 38 Answers

If it's a factory system you may be able to pull an "acc" fuse. Just a powered accessory.

Posted on Jul 28, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: key fob wont open doors or boot or lock them

you need to reprogram keys with the module. there could be a problem with the module though , you need to check it out

Posted on Aug 13, 2009

  • 2 Answers

SOURCE: my renault laguna 1999 rt remote key fob wont work?

IF YOU TYPE 1999 RENAULT LAGUNA REPROGRAMME KEY INTO A GOOGLE SEARCH, YOU WILL BE ABLE TO PRINTOFF INSTRUCTIONS TO REPROGRAMME THE KEY TO THE KEY READER.THE IGNITION NEEDS TO BE OFF TO DO THIS

Posted on Dec 02, 2009

  • 67 Answers

SOURCE: 99 dodge Durango security bypass key fob broke

Try unlocking the the door with the key and then lock and then unlock again the may disable the security system

Posted on Jan 31, 2010

  • 1 Answer

SOURCE: Ignition is locked

I had the same exact problem tonight. My key would not turn the ignition. I could not start by pulling the steering wheel and the tow company could not tow it out of the garage, BUT before this happened as I was driving the car earlier in the day, I noticed it was very difficult to drive and got concerned.

Posted on Feb 26, 2010

  • 1 Answer

SOURCE: 1997 C200 Key Fob Failure

Max, how did you fix your problem? The same thing happened to me today and I have to call the dealership I assume. Thanks, Judy

Posted on Jul 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi A6 2007 avant.key fob will not open or lock the car. Lock's ok using key


Hello first have you changed the batteries ?
second have you tried putting key in ignition and turned to number 2, and pressed the fob to lock unlock door ?
3, your fob maybe damaged and will need repairing if it has been dropped a lot the parts inside can get damaged and will not fully work, you can check this at some garages to see if a signal is being sent. for a price. only other part that can go wrong is the receiver, this is coded to your key for opening etc doors, you will need a code reader designed to cover your model of vehicle to check this is still working.

Jan 22, 2017 | Audi Cars & Trucks

1 Answer

How to turn off the pro alarm


I would start by replacing the FOB. Sounds to like the electronics inside it are bad. The only reason the horns would go off is if you hit the panic button. There is a slight chance the receiver is bad. But Fobs are cheaper to replace than the receivers. If you have two FOBs and they both react the same, then replace the receiver. Or just ditch the system. The keys (in the door locks) should still activate the alarm system.

Aug 07, 2014 | 2011 Chevrolet Silverado 1500

1 Answer

What should I do my 1998 toyota Camry would not start and when I tried to open the door the horn started blowing


I'm pretty sure you triggered your vehicle alarm / immobilizer. Surely you know how to reset it, right? Is there a button on your key fob that does that?

Jul 30, 2014 | 1998 Toyota Camry

1 Answer

Reset key fob


Unlock all doors, foot on brake, all doors closed. Cycle key quickly but carefully on-off appr 10 times until the car honks one time.

Do not turn the key far enough to start the car, just to the 'on' position so the dashboard lights up.

When the horn honks, open and close the driver's door, press any remote button and that's it.

Program another remote? Quickly open and close the driver's door again and push a button on the 2nd remote. That's it.

When you're done, remove the key and the horn should honk 3 times. You're all set.
Sometime it takes more than 10 on-offs to set program mode. Open/close the door, lock/unlock etc, wait 10 minutes, then try again

Jul 22, 2014 | Subaru Outback Cars & Trucks

1 Answer

Mazda mx3 japanese import 94 reg key fob died, i changed the battery but it will not now unlock the car, the doors are deadlocked so the key wont unlock the doors either, can i re-sync it from outside? Or...


Whether your key fob is damaged or just has a dying battery, there is a way for you to unlock your vehicle and start the car. Just follow the steps below:
  1. Press and hold the auxiliary key release button on the underside of the key fob.
  2. Grab the looped end at the top of your key fob.
  3. Pull out the auxiliary key.
  4. Use the auxiliary key to unlock the driver's side door.
[Read more: What to do when you're locked out of your car]

HOW TO START THE MAZDA 3 WITH A BROKEN OR DEAD KEY

Now that you've managed to enter the vehicle with the auxiliary key, you're going to need to know how to start your Mazda 3. At this point, the auxiliary key can be put back into the key fob, as the key fob can still be used to start your vehicle. This will only take a few extra steps.
  1. Make sure the shifter is in the Park (P) or Neutral (N) position.
  2. Depress the brake pedal.
  3. The light on the engine start button should flash green.
  4. Take your key fob and touch the back of it to the push button start.
  5. When the green light on the engine start button stops flashing and remains continuously illuminated, press the push button start normally to start the engine.
  6. It is recommended you allow the vehicle to idle for about 10 seconds.

Mar 03, 2018 | Mazda Cars & Trucks

1 Answer

Key doesn't go into door lock


open the other door to get in.
spray some WD-40 to loosen lock.
if key won't go in there might be something jammed in lock.
I might try a tiny drill to see what is in there.
drill size of .0040 or smaller.

Jan 31, 2013 | 2007 Pontiac Grand Prix GXP Sedan

1 Answer

Bought a clicker for my son's used 2003 Hyundai Tiburon (base) we just purchased. He keeps the clicker, I went to open the door with my key, and the car went into crazy mode. I put the key in th


It happens a lot for the Tiburon apparently....what you have to do is put the key in the ignition whilst the horn is going nuts, turn the key to the "on" position and wait a minute or so for the horn to stop blowing. Then press the "unlock" button on the fob until you see the turn signals flash. try turning the key over and see if it will start up. If it doesn't, try again, same thing only turn the key all the way off and try starting as normal again. I can't remember if it's the "unlock" or "lock" button you're supposed to press, but one of them does it. Test it while in the car and see if it locks when you hit lock on the fob.....oh, and also make sure all the doors are shut while you are doing this. It recalibrates the fob to the car's computer and resets your security system and keyless entry.

Jan 11, 2013 | 2003 Hyundai Tiburon

1 Answer

2007 yaris door wont lock when driver door is open


sounds like the ignition lock is worn out.

Mar 01, 2017 | 2007 Toyota Yaris 1.4

1 Answer

99 dodge Durango security bypass key fob broke


Try unlocking the the door with the key and then lock and then unlock again the may disable the security system

Jan 31, 2010 | 1998 Dodge Durango

4 Answers

Program a remote key for 03 A6


I have an A4 and did this to re-program my key:

1. used the key to start the car...then turned it off
2. put the key in the driver door (door closed)
3. pressed the lock button on the key fob once
4. turned the key to lock the door.

This is basically the steps in the owners manual, but the car must be started with the key first, and the key must be in the door lock before pressing the lock button.

Dec 10, 2008 | 2003 Audi A6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...