Question about Cars & Trucks
The BACKSIDE of the driver side fuse panel. The side opposite all the others. A bit tricky to weasel it down and work it out.
Posted on Jul 28, 2013
It should be behind the fuse box in the driver side of the dash. The fuse box is behind the panel you can see when you open the door. Sometimes you can get to the flasher relay by removing the panel under the steering column.
Check your owners manual for details.
Posted on Jul 28, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The flasher for a 2000 Jetta is in the hazard light switch in the middle of the dash. If you want to replace the flasher, you'll need to replace that switch.
Posted on Aug 15, 2008
SOURCE: 1994 devilles flasher location
Turn signal flasher module is behind dash left of steering column near chime module. I have a 94 Seville and I had that same problem you need a Turn Signal Flasher Moduel, I forgot the proper term for it but I had to get mine replaced too. When I hit the signals to turn the side light would come on but the signal light wouldn't. Its a little box you get from Cadillac it only cost like $20 - $25 and you get it installed and trust. It'll work again. I just got mine done this week and my car now has turn signals again.
Posted on Dec 15, 2008
The requirement is 10 QTS. I use 10 and check it cause some times they hold 11 QTS. I hope this helps. If you have more questions reguarding this or other conserns please ask me. Please remember high ratings are very important to me.
Posted on Aug 28, 2009
Testimonial: "Thanks very much for that Regards Bryan McRae New Zealand"
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Posted on Dec 01, 2009
Testimonial: "just what I needed, thank you so much."
Tips for a great answer:
Dec 21, 2014 | 2001 Chevrolet Silverado 2500HD
Nov 27, 2012 | Cars & Trucks
Jun 16, 2010 | 2002 Chevrolet Silverado 2500HD
Jun 13, 2010 | 2002 Chevrolet Silverado 2500HD
Nov 07, 2009 | 2002 Chevrolet Cavalier Coupe
Sep 23, 2009 | 2003 Chevrolet Silverado 2500HD
Dec 11, 2008 | 2005 Chevrolet Silverado
37 people viewed this question
Usually answered in minutes!