Exhaust work 94 camaro - Cars & Trucks

All 4L60E /4L60/700R4 have the same gear ratio which can not be modified. ..swap the 94 internal harness into 95 and 96 transmission

You will have drop the header pipes from the exhaust manifolds, and disconnect the torque converter from the exhaust pipe. Then you will be able to reach the plugs from UNDERNEATH the car.

If you havn't got "spring compressors" forget it and take to Auto shop.

Try a higher octane fuel. If the popping is still heard a valve is burnt

this one isnt the funnest ...fuel tank must be removed which requires dropping rear end diff. and exhaust far enough to access tank. most helpfull if fuel tank is low or out of gas....even with this,lifting car and jacks required.

the exhaust system needs to be lowered so you can gain enough room to lower the fuel tank. not an easy job.

There is two(2) up top.Left-side of top engine.Right under the windshield level.The other one(1) should be on your right side of the engine,on the top.The other two (2) is in the rear,under the vehicle.One on both sides.

i'm not sure if its the same or not but for a 94 camaro i'm coming up with 4l60-e for the auto trans, i can confirm this by running a vehicle build if you send me the vin number, i work at a gm dealer so i can look things like this up

could be map sensor or mass air flow sensor.

http://www.autozone.com/az/cds/en_us/0900823d/80/0e/cc/fa/0900823d800eccfa/repairInfoPages.htm