Question about Cars & Trucks

1 Answer

How do you clean a sealed vapor canister from a 2001 bonnevile ssei?

Just found out that the vapor canister of a2001 bonneville is sealed.how do you clean it or just replace it new?

Posted by on

Ad

1 Answer

They are just replaced
The question is what is the problem
with it? Why do anything?

Posted on Jul 28, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: 1996 Toyota Previa code p0441

P0441 is Evap Emission Incorrect Purge Flow; the repair you are describing is easy, and should correct the P0441 restricition...I would anticipate no large problems.

Posted on Oct 07, 2008

leirob007
  • 5 Answers

SOURCE: 1997 bonneville ssei

Grab yourself a cable type hose clamp tool.. a long pair of hose removal pliers. drain the radiator and remove the hose clamps and hosed from the passenger side firewall ( hidden behind the A/c acumulator ).
from the passenger side remove the end cap from the heater box under the dash. take it out and put it back together in the reverse order.

Posted on Nov 16, 2008

customcan
  • 113 Answers

SOURCE: location of a vapor canister on a 2001 pontiac

do you mean evap canister it should be around the gas tank.

Posted on Jul 25, 2009

  • 1 Answer

SOURCE: How do I install a replacement side view mirror -

my mirror broke offf in a car accident and i still have most of the mirror tho it hangs off the door and i am wanting to know if anyoine can help me out is all

Posted on Jun 20, 2010

  • 1 Answer

SOURCE: Serpentine belt diagram for a 2001 Pontiac Bonneville SSEI

these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact goldenvegasart@gmail.com

Posted on Aug 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the neutral safety switch on my 2001 pontiac bonneville ssei?


Look down, behind the the air filter box. It is under the shift cable going to the transmission.

Jun 30, 2016 | 2001 Pontiac Bonneville SSEi

1 Answer

I need timing mark on 2001 Pontiac Bonneville supercharged ssei


find it on the HArmonic And Look For No 1 on the top and ther Done and you will have it be carefull you are not out cause big problems then turn over by HAnd Not with the Starter to make sure your on it

Mar 22, 2015 | 2001 Pontiac Bonneville SSEi

1 Answer

Ponitac bonneville 2001


it sounds like the idle air control sensor or the BCM/ Body Control Module

Sep 02, 2014 | 2001 Pontiac Bonneville SSEi

1 Answer

Vapor canister location


I bought a automatic transmission filter kit to fix the leak but it's still dripping from the pan

Jan 16, 2014 | Pontiac Cars & Trucks

1 Answer

Were is left turn signal flasher for 2001 pontiac bonneville ssei


there is only one flasher unit and it is part of the 4 way hazard flasher ununit located in the vent on the passenger side near the radio. it costs around 149 dollars. I would replace all bulb on the left side first unless the 4 way flashers work.

Apr 06, 2013 | 2001 Pontiac Bonneville SSEi

1 Answer

Replaced the codes that the ECM was throwing out and car still runs the same


You Cleared all data in the pcm

You didn't replace any codes

The canister & the 3 cop coils were tested HOW?

They failed a test & thus needed replacing?

Apparently not as you still have the came OBD 2 Codes

So you now need to start over & I suggest a repair shop

If that work was done by a shop,chose an other as you paid
for nothing as you know.

Bottom Line----Never diagnosed the fault codes or found
the real issues.

Dec 08, 2012 | 2001 Pontiac Bonneville

1 Answer

1996 Ford Aerostar 3.0 L V-6 Constant check engine light ON Ran codes. Code says vacuum leak on fuel canister. I'd like to change all the vacuum lines. Don't have a good schematic. Haynes manual only...


what codes?

The vacuum lines run from the canister to the intake manifold. One is the purge hose to deliver stored fuel vapor to the intake to be burnd when engine is warm and you are crusing at part throttle. The other line is the vacuum line to operate it.

Fuel Vapor Valve, Aerostar (4.0L Engine) The evaporative emission valve (9B593) uses a small orifice, 1.83mm (0.072 inch), that allows vapors to pass into the vapor line running forward to the evaporative emissions canister (EVAP canister) (9D653). This evaporative emission valve mounts directly into the fuel tank (9002) using a fuel vapor separator seal. Fuel vapors trapped in the sealed fuel tank are vented through the orificed evaporative emission valve. The vapors from the fuel tank leave the evaporative emission valve through a single vapor line and continue to the evaporative emissions canister in the engine compartment for storage.
-----------------------------------------------------
Fuel Vapor Canister Purge Regulator Valve, Aerostar, Ranger Removal and Installation
  1. Disconnect wire harness from evaporative emission canister purge valve (EVAP canister purge valve) (9C915).
  1. Disconnect wire harness from thermistor.
  1. Disconnect evaporative emission canister purge valve assembly from fuel vapor canister and throttle body.
  1. To install, reverse removal procedure.
-----------------------------------------------------------------

snorkelbobby_48.gif

Mar 25, 2011 | Ford Aerostar Cars & Trucks

1 Answer

I need a new PCM computer. I have a 2001 Pontiac Bonneville SSEi. Can you tell me where the PCM is located?


Powertrain control module is inside air cleaner housing in left side of engine compartment, )

Nov 23, 2010 | 2001 Pontiac Bonneville

1 Answer

A repair shop told me that my EBCM was bad and needs replacing. The Brake, Tracktion control idiot lights are on. I have a 2001 Pontiac Bonnevile SLE. The dealer wants $700+ just for the EBCM module. Does...


Look on www.car-parts.com. This is a network of salvage yards from all around the country. Most will ship to you at reasonable cost. Once, a dealer quoted me $700 plus for an TCM, and I got it through this website for $75 from a salvage yard in California. Good luck.

Mar 28, 2010 | 2001 Pontiac Bonneville

2 Answers

Control arms for 2001 pontiac bonneville ssei


Try the Salvage yard, you can get then around $45.00 each if you pull the parts your self. Call around though, different Salvage Yards have different price and will always try to beat the price of another Salvage yard. They pull parts for you too if you don't fell like getting your hands dirty twice. Good luck.

Nov 16, 2009 | 2001 Pontiac Bonneville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...