Question about Cars & Trucks
Sevice fourwheel drive is on and fourwheel drive dosent work
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
check for leaks in the vacuum, Jeep used a vacuum switch for the front axle during that time on the dana 30, it may have a leak or just worn where its not fully engaging and lockign all the way. It may not be holding the air as well to keep it engaged. Its a small tube.
Posted on Dec 19, 2008
There is a TSB for replacing the IWE ( Integrated Wheel Ends ) solenoid, as the 1st design can ingest water and introduce it to the IWEs, causing low vacuum, and the gears for the IWE are grinding.
To cure this until you get the new IWE solenoid ordered and installed, pull the vacuum lines from the IWEs and plug them. This will leave the IWE gears engaged, so they are not trying round off the teeth.
There are 2 lines to the IWE, 1 is the vacuum line, the other is a vent line, that routes into the engine compartment, with an open end, make sure you pull and plug the correct line.
This will have the front hubs engaged to a dead axle, so it will decrease mpg, and you will feel a bit of loss of power, but better than ruining a set of IWEs that will cost ~500.00 to replace.
Posted on Jan 09, 2010
Tips for a great answer:
Jan 01, 2014 | Cars & Trucks
Aug 26, 2013 | Cars & Trucks
Jul 01, 2012 | Cars & Trucks
Oct 24, 2011 | Cars & Trucks
Dec 27, 2010 | 2007 GMC Yukon
Nov 24, 2009 | 1986 Chevrolet Chevy
Jun 27, 2009 | 1990 Ford F350
Dec 14, 2008 | 1992 Jeep Wrangler
82 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: