Question about Cars & Trucks

Open Question

Kubota engine wiring diagram

BX2360 won't shut off with key

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: Trunk lid won't electrically open

Its possible that your problem isnt electricla, maybe mechanical (physical); check the next procedure about Trunk Lid Lock Cylinder REMOVAL & INSTALLATION to confirm and adjust...

zjlimited_1482.jpg

Fig. 1: Pull the trunk lid lock cable upward from the bracket and slide it out of the lock cylinder plate

zjlimited_1483.jpg

Fig. 2: Pull the lock cylinder retaining clip upward

  1. Pull the trunk lid lock cable upward from the bracket and slide it out of the lock cylinder plate.
  2. Pull the lock cylinder retaining clip upward to release the lock cylinder plate.
  3. Remove the lock cylinder plate.
  4. Installation is the reverse of removal.

Add WD40 oil to lubricate all components; about the fuses, you are right, isnt showed in the manual, but could test and check position 25 and 30 in passneger fuse panel (alarm and locking system).

Keep us updated.

Posted on Jun 24, 2011

ginko
  • 19396 Answers

SOURCE: karlachey@yahoo.comLooking for wiring diagram of

Hi.

Below the engine wiring diagram for 1984-1986 5.0L engine installed on your F150. Click on the picture to enlarge:

ginko_18.jpeg

Below also the diagram for instrument cluster and sending unit:

ginko_19.jpeg

Note: Clicking on pictures will open the diagram page with the big picture. Click on the page that will open again to enlarge the picture. The diagrams' size is quite big you may need to print them out in order to read them.

Regards.

Ginko

Posted on Sep 09, 2011

  • 978 Answers

SOURCE: kubota 9540 starter diagram

check battery check to make syre you are getting power to small starter wire when key is turned

Posted on Oct 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Honda Accord Won't Start


Park neutral safety switch maybe be the reason for the no crank ! Try putting the vehicle in park ,then try to crank the engine . Testing the electrical circuit is the best way to trouble shoot this problem , along with do a voltage drop test on the starter circuit ! This will test the battery cables an connections .
Starter Voltage Drop
How to voltage drop test starter motor circuit
Does it have a manual or automatic transmission ? Manual ? clutch switch . Looking at a wiring diagram I also see a starter cut relay !
http://www.bbbind.com/free_tsb.html Free wiring diagrams . Enter vehicle info. year , make , model and engine size . Under system click engine , under subsystem click starting . Then click the search button , then click the blue link ! Check the starter cut relay also . Videos on youtube showing how to test a relay controlled circuit !

May 29, 2017 | 1998 Honda Accord

1 Answer

Kubota 9540 starter diagram


check battery check to make syre you are getting power to small starter wire when key is turned

Oct 18, 2012 | Cars & Trucks

4 Answers

Why won't the fan motor shut off on my 1991 acura legend?


Hey chandralebea,

Try first by replacing the cooling fan engine temp sensor switch, as this may be the cause.



Good Luck

Jul 29, 2012 | 1991 Acura Legend

1 Answer

Horn, cig. lighters, and key remote won't work. Fuses good. Any idea what's wrong?


Ifg you`re a do it yourselfer, that sound electrical, it might be a relay issue, go fiverr and punch in wiring diagrams

Mar 27, 2012 | 2005 Chevrolet Equinox

1 Answer

Wiring diagram mazda premacy car wont startput key in turn over engine wont kickin


Autozone.com has free digrams in the repair section.
What won't "kickin"? The starter does not turn? If that is the case,
Go to the starter, there will be a large battery cable and a smaller wire on a seperate terminal. Put a test light to the small terminal/wire and have a helper turn the key as if to start the car. If the test light comes on then the starter/solenoid is bad. No light, may be ignition, nuetral safety switch, fuses, etc..

Oct 10, 2011 | Cars & Trucks

1 Answer

Hi, I have a problem with a 1999 Dodge Ram 1500 series 5.2 Liter. It will crank over but won't start every once in a while it will start and run for about 20 seconds, then it dies and won't start...


check all your vacuum lines. if there is a vacuum leak, the truck will crank, but not start. if you need a vacuum diagram, go to www.autozone.com create a profile it's free, add vehicle. put in the info of your dodge ram. then from the main screen, where it says select a category, select vehicle repair guide. on the next screen select emission controls. on the next screen where it says select a chapter, select vacuum diagrams. as you scroll down just click on the diagram for your engine. hope it helps. good luck.

Sep 03, 2011 | 1999 Dodge Ram

2 Answers

My hhr will not turn off, where is the battery so i can disconnect it


Unplugging the battery won't shut it down I don't think.

Get into your fuse box under the dash or in the engine compartment and pull the fuse for the fuel pump.

Jul 02, 2011 | 2009 Chevrolet HHR

1 Answer

1998 Ford Windstar Minivan: 1. I sometimes get an extended crank when trying to start engine after I've made a short trip. 2. My interior lights won't go out after I turn the engine off, so I...


YOU MAY HAVE A BAD DOOR AJAR SWITCH. HOWEVER, YO HAVE A TIMER THAT SHUTS OFF THE INTERIOR LIGHTS AFTER 300 MINUTES. IT'S CALLED A BATTERY SAVER FEATURE. TEST IT OUT.

THE EXTENDED CRANK MAY BE A CHECK VALVE IN THE FUEL PUMP IN THE TANK, ALLOWING PRESSURE TO DROP WHEN YOU TURN THE ENGINE OFF.
OR A BAD FUEL PRESSURE REGULATOR ON THE ENGIEN FUEL RAIL.

TRY THIS TEST, TURN KEY TO "ON" POSITION, WAIT 5 SECONDS, SHUT OFF KEY FOR 30 SECONDS. TURN KEY ON, WAIT 5 SECONDS, THEN START ENGINE. IF IT STARTS RIGHT UP, YOU ARE LOSING FUEL PRESSURE WITH ENGINE OFF.

THIS BUILDS UP PRESSURE IF IT DROPPED DURING SHUT DOWN.
REPORT TEST RESULTS.

PLEAE RATE, THANKS

May 16, 2011 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...