Question about 2005 Toyota Camry XLE

Open Question

How cauld i fix fault p0758 shift solenoid "b" electrical

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 06 Corolla Pressure Control Solenoid D Electrical Fault

There is a technical service bulletin to correct this condition. Replacement of the car's Electronic Control Unit (the computer) will cure this. Take it to a Toyota dealer and have them replace it for free.

Posted on Jun 09, 2009

  • 333 Answers

SOURCE: Pressure Control Solenoid D electrical fault (P2716)

There is a Bulletin on this concern, and it is a warrantable condition for 8 years or 80,000 miles so you are still covered by the factory warranty.
The problem is a logic issue in the PCM. The correction is a new PCM with updated software.


Reference bulletin #TC015-07

The contents are below:

TRANSMISSION & CLUTCH
TC015-07 Title:
HARSH SHIFT AND M.I.L. "ON"
DTC P2716 Models:
'05 - '07 Corolla & Matrix (1ZZ-FE) September 20, 2007

Introduction
Some 2005 - 2007 model year Corolla and Matrix vehicles equipped with an automatic transaxle may exhibit a harsh shift condition and a M.l.L. ON" with DTC P2716 stored.
Improvements have been made to the Engine Control Module (ECM) (SAE term:
Powertrain Control Module/PCM) to reduce the possibility of this condition occurring.

Applicable Vehicles
^ 2005 - 2007 model year Corolla and Matrix (2WD) vehicles equipped with the 1ZZ-FE engine.
Warranty Information
Applicable Warranty*:
This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's in-service date.



** Please be sure to rate me if this free information has been helpful!

Posted on Sep 21, 2009

Testimonial: "Thank you so much!! "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 plymouth breeze transmission wont go into 2nd Gear


Have you check fluid level ? Is your check engine light on ? You have a bad shift solenoid inside the transmission ,more then likely . Have codes checked ,you mite have P0700 + code
  • P0750 - Shift Solenoid A
  • P0751 - Shift Solenoid A Performance or Stuck Off
  • P0752 - Shift Solenoid A Stuck On
  • P0753 - Shift Solenoid A Electrical
  • P0754 - 1-2 Shift Solenoid Intermittent
  • P0755 - Shift Solenoid B
  • P0756 - Shift Solenoid B Performance or Stuck Off
  • P0757 - Shift Solenoid B Stuck On
  • P0758 - Shift Solenoid B Electrical
  • P0761 - Shift Solenoid C Performance or Stuck Off
  • Nov 08, 2015 | Plymouth Cars & Trucks

    1 Answer

    2-3 shift solenoid circuit


    P0758 Chevrolet P0758 Chevrolet - 2-3 Shift Solenoid Circuit Electrical
    Possible causes
    - Low transmission fluid level
    - Dirty transmission fluid
    - Faulty 2-3 Shift Solenoid Valve
    - 2-3 Shift Solenoid Valve harness or connectors
    - 2-3 Shift Solenoid Valve circuit is open or shorted
    What does this mean? When is the code detected?
    When the Powertrain Control Module (PCM) detects a continuous open, short to ground or short to power in the 2-3 Shift Solenoid (SS) valve circuit, then DTC P0758 sets.
    Possible symptoms
    - Engine Light ON (or Service Engine Soon Warning Light)
    - Transmission will not shift gears
    P0758 Chevrolet Description
    The 2-3 Shift Solenoid (SS) valve controls the fluid flow acting on the 2-3 shift valves. The 2-3 SS valve is a normally-open exhaust valve that is used with the 1-2 SS valve in order to allow four different shifting combinations. The solenoid attaches to the control valve body within the transmission. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path.

    Read more: http://engine-codes.com/p0758_chevrolet.html#ixzz3kcwzXFmK

    Jul 14, 2014 | 2000 Chevrolet Silverado 1500

    1 Answer

    I have 1998 volkswagon jetta with the check engine code P0758


    P0758 Volkswagen - Shift Solenoid 'B' Electrical

    Possible causes
    - Low transmission fluid level
    - Dirty transmission fluid
    - Faulty shift solenoid 'B' valve
    - Shift solenoid 'B' valve harness or connectors
    - Shift solenoid 'B' valve circuit is open or shorted

    Worst possible scenario is that the Transmission Control Module has noticed the solenoid is either taking too much current (a short circuit) or too little current (an open circuit). The problem could be in a few different places: wiring between the TCM and the tranny, wiring internal to the tranny, the TCM has gone bad, or the solenoid itself. You can narrow this down by checking the resistance of the solenoid coils at the TCM connector, then at the tranny connector on the tranny.
    Good luck, the mark 3 transmission is notoriously finicky.

    Sep 11, 2013 | Cars & Trucks

    1 Answer

    Trouble codes po758 p0758d


    P0758 Problem in Shift Solenoid Valve B Circuit
    Fault :
    Solenoid Valve 2 B - Open or Short to Earth or B+
    Cause:
    Wiring/Connectors from/to Solenoid Valve 2 Open or Short to earth.
    Solenoid Valve 2 (N89) faulty.
    Engine control module (ECM)/Powertrain control module (PCM)/Transmission control module (TCM)

    Solutions:
    Check/Repair Wiring/Connectors from/to Solenoid Valve 2.
    Check/Replace Solenoid Valve 2.

    May 22, 2013 | 1999 Honda Prelude

    1 Answer

    P0756 p0758 codes are showing on 03 chevy suburban. Do I need to change the 1-2 and 2-3 solenoids?


    The P0756 means Shift Solenoid "B" Performance or Stuck Off, and the P0758 means Shift Solenoid "B" Electrical. What you should do is clear the fault code with your tech 2, If the code still on, I think you should take your car to car repair shop.

    Aug 22, 2012 | Chevrolet Cars & Trucks

    1 Answer

    P0758


    The fault code "P0758" means "Shift Solenoid "B" Electrical.

    ________________
    autocom cdp pro for truck

    Jul 02, 2012 | 2002 Toyota RAV4

    1 Answer

    1997 Chevrolet Silverado Z71 p0758 Won't shift


    P0758 code is shift solenoid B electrical /2-3 shift solenoid circuit electrical, It better to inspect the wire going into the transmission they have a tendency to leak transmission fluid into the circuit make inspection for proper connection if you decide to replace the solenoid you still need to inspect the circuit for proper mating. If this solenoid fails and you wait to long to replace it you can loose the ECM due to the high power draw it takes from the ECM.

    May 06, 2011 | 1999 Chevrolet Silverado 1500

    3 Answers

    I have a code P0753 p0763 p0758 how to solve the problem


    P0753 Shift Solenoid A Electrical its inside of transmission not very easy to replace it controls the shifting of the transmission
    P0763 Shift Solenoid C Electrical its another transmission shift solenoid
    P0758 Shift Solenoid B Electrical another shift solenoid now my question to you is your transmission shifting normal have you had any work done to your car recently like changeing any seals on your transmission to have theses replaced by a mechanic its gonna be very expensive i could tell you step by step how to change them with theses codes you should be haveing serious shifting issues if you dont have shifting issues reset codes and see if they come back if they do then it could be in the wireing harness comeing from transmission hope this answers your question happy holidays

    Dec 16, 2010 | Volkswagen Jetta Cars & Trucks

    1 Answer

    1997 blazer sluggish in drive reverse is fine


    P0740 is TCC circuit malfunction P0753 is shift solenoid A circuit electrical P0758 is shift solenoid B P1406 is EGR pintle position and P01860 is TCC circuit.

    Feb 03, 2009 | 1997 Chevrolet Blazer

    Not finding what you are looking for?
    2005 Toyota Camry XLE Logo

    Related Topics:

    46 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    75051 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7726 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...