Question about Ford Cars & Trucks

Open Question

How to remove exhaust pipe and hanger on a 1995 ford f150 extended cab

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75817 Answers

SOURCE: 1995 Ford F150 Acceleration Issues

I THINK THEY MAY HAVE DAMAGED THE PLUG WIRE BOOTS, TAKE A LOOK AT THEM AND SEE IF THE RUBBER BOOTS ARE TORN OR DAMAGED, CHEAP TUNE-UP SHOPS ARE FAMOUS FOR CAUSING THIS KIND OF DAMAGE, THERE IS A SPECIAL TOOL TO REMOVE THE WIRES WHICH GET STUCK TO THE PLUGS, MANY YOUNG KIDS DO THE WORK BUT DON'T EVEN KNOW THE TOOL EXISTS.

Posted on Nov 05, 2008

  • 35 Answers

SOURCE: 1995 Jeep YJ Exhaust / Muffler / Cat Conv on Hangers

use a jack to force the muffler into position, or you may have to move the hANGERS accordingly

Posted on Mar 30, 2009

  • 1 Answer

SOURCE: # 15 fuse keeps blowing on a Ford f150 2003 model

try a #20 amp fuse

Posted on Apr 23, 2009

  • 1129 Answers

SOURCE: 1995 ford f150 4.9 how to remove a/c clutch

remove drive belt then aquire the clutch removal tool from Auto zone or Napa, there is a specific puller designed to remove this clutch,in some cases in order to hold the pulley while removing center nut or bolt you must use a chain wrench with an old leather belt wraped around the pulley to protect the v-ribs on pulley in order to get the pulley bolt or nut loose the clutch will just turn when trying to loosen center nut if you don't use the chain wrench to hold it, after removing said nut or bolt attach the puller to the clutch and while holding it stationary with the chain wrench proceed to turn the shaft of the puller to remove the clutch, it should pop free after a couple of turns with a socket wrench of the appropriate size. PS use the chain wrench ($22.00 Auto zone) only in the corerect direction it does not clamp effectively either direction. also sometimes there is special holding tool for certain clutches, consult Napa or the dealer before buying the chain wrench it may not be effective in holding the clutch while trying to remove center bolt.

Posted on Jul 08, 2009

jeepguyracin
  • 2011 Answers

SOURCE: where is the fuel pump relay on 1999 ford f150 extended cab four wheeled drive

It is located on the passenger side under the dash where the floor and bottom of the dash meet.(sit in the passenger seat and look where your left foot is).Now lay down and look up in that area.There is a small black box with a white button you need to push in.

Posted on Jan 19, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace front fuel pump on a 1995 ford f150 5.0litre extended cab dual tanks how do i remove tank


May be easier to loosen rear box bolts,remove the
front bolts & tip up the bed, rather than lay on your back
& have to drop the tank & that way you don't have the
fuel removal issue,can stand there & just work on top
of tank

Oct 06, 2012 | Cars & Trucks

1 Answer

I have a 1994 Ford F150 extended cab 5.0 v8. I need to change the exaust manifold gaskets, how can I do this and what tools and what will I need to do?


Hi! Here are some guides on removing and replacing the exhaust gasket:
- You may need a 12mm and 14mm closed and opened wrench
- Make sure that the engine and exhaust is cooled down before performing the procedure to prevent injuries.
- The exhaust manifold may have a cover, please remove it using the wrench
- Once opened, remove the nuts of the exhaust manifold
- Support the exhaust before pulling it out for it may hit the ground
- Place the new exhaust gasket in place
- PUt the exhaust manifold and tighten the nuts evenly
Hope this helps and good luck!

Apr 07, 2010 | Ford F-150 Cars & Trucks

1 Answer

I have a 1999 ford f150 exhaust pipe and muffler


did the flange come apart or did the pipe break, if the pipe broke then you will have to replace the system fron the flange back, these exhaust systems look good but corrode from the inside out, get a new system i will probably come in three pieces, and new hangers, its pretty straightforward

Nov 26, 2009 | 1999 Ford F150 Regular Cab

1 Answer

Need to know where heat gauge sending unit is locatad on engine block of a 300 ci ford f150 is.


should be between the exhaust ports on the cylinder head, or int he intake manifold on the front of the engine near thermostat

Oct 29, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

2004 f150 lariat cilinder 1 misfire...


most likely the sensor on the exhaust pipe

Jul 15, 2009 | 2002 Ford F150 Regular Cab

2 Answers

1997 F150 manifolds are glowing red


Sounds like cat convertors are clogged.

Jun 18, 2009 | 1997 Ford F150 Regular Cab

3 Answers

1997 ford f150 cyliner 7 misfire


sme problem had to have it put on computer and codes reset

Feb 05, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Change head light 1998 ford f150 extend ed cab


it's done from the inside of the passenger compartment... you may have to remove the battery first if it's on that side. oh and don't touch the bulb with your fingers ... it shortens the life of the bulb.

Robert

Please take a moment to rate this solution thanks

Jan 28, 2009 | 1998 Ford F150 Regular Cab

1 Answer

1995 Ford F150 Acceleration Issues


I THINK THEY MAY HAVE DAMAGED THE PLUG WIRE BOOTS, TAKE A LOOK AT THEM AND SEE IF THE RUBBER BOOTS ARE TORN OR DAMAGED, CHEAP TUNE-UP SHOPS ARE FAMOUS FOR CAUSING THIS KIND OF DAMAGE, THERE IS A SPECIAL TOOL TO REMOVE THE WIRES WHICH GET STUCK TO THE PLUGS, MANY YOUNG KIDS DO THE WORK BUT DON'T EVEN KNOW THE TOOL EXISTS.

Nov 05, 2008 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...