Question about Cars & Trucks

Open Question

Rexton xdi290 knocking sound after changing engine oil and.oil filter

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: 2003 Jeep Liberty. Changed oil, running very rough and dies.

Buy some Marvel Mystery oil from Auto Zone and add it to you engine oil. Keep an eye on your engine oil level everyday with the Marvel in there and change the engine oil every 3000 miles. Hope the Marvel will clean out the lifters for you and the rest of the sludge in the engine. Do Not Use Engine Flush!!!! There know to eat the seals and kill engine sensors.
The EGR could also be stuck with carbon build up and may need to be cleaned or replaced. Try doing this, turn your radio off and disconnect the battery for a min, turn the ignition key to the run position and re connect the battery then start the liberty. That should reset the air idle control valve
Let it idle down and then go for a test drive after it warms up. Good luck and keep me posted, while your at Auto Zone have them scan your liberty for any DTC codes. Be glad to help.

Posted on May 31, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Knocking than oil light on just change filter and oil


Your engine is gone. Replace or rebuild. If your car is old, junk it. Time for a new one.

Aug 10, 2015 | Cars & Trucks

1 Answer

Just had my oil and filter changed and almost immediately noticed a knocking sound. Two days later my check engine light began to flash and the knocking got louder


Have you called shop that did oil change? Have a different shop check oil and filter to make sure proper filter used especially.

Feb 04, 2014 | 2002 Chrysler PT Cruiser

1 Answer

Bottom engine knocking sound


should have done an engine flush before the oil change .as can be dirty filter at the oil pump. do it again ,but engine flush first. run the engine on tick over.but it sounds like the damage has been done .failed main bearings.

Dec 23, 2013 | 1995 Buick Regal

1 Answer

ENGINE KNOCKING


IS THE ENGINE REMAN OR SECONDHAND IT SOUNDS IT MAY HAVE RUN WITH OUT OIL, KNOCKING NOISE SEEM TO BE A BEARING KNOCK .WHAT I SUGGEST IS TO REMOVE ONE HT LEAD AT A TIME IF KNOCKING SOUNDS SOFTTER ON THAT CYLINDER THEN IS AS ABOVE

Jan 25, 2013 | Cars & Trucks

1 Answer

Engine knocking


engine knocking sound like worn engine bearings or low oil level. if oil level okay more likely oil pump has failed or engine bearings worn out or engine oil diluted with antifreeze or gasoline causing viscosity oil to be too thin.if oil and filter been changed.if you see check engine light flashing code scan for faulty knock sensor. if you see low oil light flashing engine knocking damaged to engine done.

Oct 13, 2012 | 2006 Chrysler PT Cruiser

2 Answers

Where is the oils filter located on a Diesel Sangyong Texton 2005 Merc DXi270


The oil filter for the diesel Rexton is behind the engine block on the passengers side. If you remove the plastic engine cover and stand next to the passengers mirror, you will see the casing next to the firewall.

Aug 17, 2012 | 2006 SsangYong Rexton 270

1 Answer

Can someone please advise the location of the oil filter in the engine bay and how to remove it. My husband has replaced many oil filters before but is having problem locating the filter on the ssangyong....


The oil filter for the diesel Rexton is behind the engine block on the passengers side. If you remove the plastic engine cover and stand next to the passengers mirror, you will see the casing next to the firewall.

Aug 02, 2012 | 2007 SsangYong Actyon 4x4

1 Answer

How do I change the oil filter on my ssangyong rexton 2006


El filtro esta en la parte derecha un poco mas arriba de la mitad con 3 mangueras conectadas que se pueden desconectar con la mano y esta en una base que se quita con un destornillador corriente, pero no he podido encontrar donde comprarlo...

Jun 23, 2012 | 2006 SsangYong Rexton 270

1 Answer

My engine has a knocking sound


i'm sorry! does the engine dipstick for the oil,is it full? has it been run low on oil lately? is the knocking sound like a real hard knocking,thumping with like deep base sound?if so,do not start it again. you may have a bad crankshaft bearing,or a bad crank,broken crank. if it's a tapping sound,that's different. it could be low oil pressure, just like the lower knocking,it may be bad oil pump.my advice is this, lower knock from oil pan where you drain the oil,do not start! upper,on top of the engine,just change oil 1st add a fram oil filter,if in cold weather recommend 5w30weight oil,in summer,30weight castrol with fram oil filter.is your oil light on? if not,then it'not low on oil,but CHECK your oil on dipstick,just to be sure thank you for choosing fixya.com

Jan 28, 2011 | 2000 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...