Question about 2002 Chrysler Town & Country

Open Question

What is code 400.1 on chrysler town and country van

I get the engine lite so I checked the code by pressing the trip/odometer and it comes up 400.1. What problem does code 400.1 indicate?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2001 Chrysler Town & Country mini-van stalling at all speeds

2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?

Posted on Aug 17, 2009

Ad
alicantecoli
  • 22219 Answers

SOURCE: Chrysler trouble code U110C on 2005 chrysler town

encrypted software ,dealer only----yes i know you are showing a reading but it doesnt mean anything or if it does it shows a different code .so your snap on or mac tools scanner is a waste of time and money.Nearly all new motors from 2005 are using encrypted software to stop general mechanics like me from working

Posted on Sep 12, 2009

  • 17 Answers

SOURCE: I have a 2004 Chrysler Town and Country and my

P0440:

  • Remove and reinstall the gas cap, clear the code, and drive for a day and see if the codes come back.
  • Inspect the EVAP system for cuts/holes in tubes/hoses
  • Inspect for damaged or disconnected hoses around the Evap purge solenoid
  • Check and/or replace the sensor
  • Check and/or replace the purge valve
  • Have a professional use a smoke machine to detect leaks

  • P0441:
    Bad vacuum switch
    • Broken or damaged EVAP line or canister
    • Open in PCM purge command circuit
    • Open or short in Voltage feed circuit to Purge Solenoid
    • Faulty purge solenoid
    • Restriction in EVAP solenoid, line or canister
    • Corrosion or resistance in purge connector
    • Bad PCM

    Posted on Dec 21, 2009

    • 1 Answer

    SOURCE: CHRYSLER town and country mini van turn signal/flasher

    I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

    Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

    If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

    Your going to replace it anyway, whats the harm?

    Posted on Jan 28, 2010

    • 1 Answer

    SOURCE: where can i find a owners manual for 2001 chrysler van

    1-800-890-4038
    M-F 8:00AM-8:00PM EST

    Posted on Mar 13, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    2004 Chrysler Town and Country won't start. Lights, radio and horn works just fine. Even put in a new starter and still get nothing. Ran a wire from battery to the starter and got a little kick.


    Chrysler Town & Country Questions - My van won't start ...

    www.cargurus.com > Questions > Chrysler > Town & Country

    CarGurusSep 29, 2008 - ckf2004 answered 4 years ago. I have a 96 chrysler town and countrylx and the engine died, turned over but wouldn't start, I researched and replace the flywheel .... My van sometimes won't start because it kills the battery.

    My town & country 2004 wont start sometimes - CarGurus

    www.cargurus.com > Questions > Chrysler > Town & Country

    CarGurusMy town & country 2004 wont start sometimes - My van start doing something really weird. it will ... Asked by TownCountryguy May 03, 2013 at 03:31 PM about the 2004 Chrysler Town & Country Base .... Sometimes you tap it & it won't work.

    Van won't start - Chrysler town and country - YouTube

    ? 1:01
    https://www.youtube.com/watch?v=mkEL2vlLZr0
    Jun 26, 2014 - Uploaded by Philip Walker
    We have the same issue currently...very randomly...with our 2008 Caravan at the moment. Wife just got ...

    2011 Chrysler Town & Country Engine Won't Turn Over, Will ...

    www.carcomplaints.com/Chrysler/Town_Country/.../engine_wont_turn_...
    The 2011 Chrysler Town & Country has 34 complaints for engine won't turn over, will not start. Average repair cost is $902.00 at 58178 miles.

    Jan 14, 2016 | Chrysler Cars & Trucks

    1 Answer

    My 2003 chrysler town and country just put up code p1698 through my trip odometer what is 1698 mean?


    1684= BATTERY DISCONNECTED WITHIN LAST 50 MILES.
    1698 PCM FAILURE EEPROM WRITE DENIED ALSO
    1698 NO CCD MESSAGES FROM TCM/ OR BCM

    Nov 09, 2013 | 2003 Chrysler Town & Country

    1 Answer

    1999 town and country illuminated numbers dont lite up van wont start


    you might have tampered with the security system which if activated would not allow your van to start.

    Oct 26, 2012 | 2002 Chrysler Town & Country

    1 Answer

    I cannot figure out how to switch the odometre reading from Trip back to Odometre. Where do I find the Trip odometre button on a 2002 Chrysler Town and Country?


    Hi, The button should be in the odometer it self (little black button) Push till odo changes trip and repeat to get it back. Good luck

    Aug 03, 2011 | 2002 Chrysler Town & Country

    2 Answers

    Check engine light comes on. odb2 code P2096 What does it mean


    WHAT EXACTLY MEANS THE CODE P2096 AND HOW I SHOULD FIX IT CRYSLER 300 2010

    Apr 24, 2010 | 2005 Chrysler Town & Country

    2 Answers

    2006 Town and Country, While driving the warning lights came on (air bag, oil presure, low fuel, check engine, etc...) Speedometer stopped working, fule gauge went to Empty (had just filled the tank 11...


    1)check the ignition switch is not loose.those things normally come on before starting.unless2) you have a main ground broken somewhere.rodents eat the wiring harness to build a nest and cause mayhem...i have seen that a few times .check the fusebox under the hood on the drivers side

    Jul 04, 2009 | 2005 Chrysler Town & Country

    1 Answer

    Missing flapper valve on an 06 town & country van's gas tank


    I doubt if that is the reason your check engine light is on. It is more likely an o2 sensor. However make sure your cap is tight when you add gas and don't leave the engine running while the cap is off. That can trigger the light

    Jul 03, 2009 | 2006 Chrysler Town & Country

    1 Answer

    2003 chrysler town & country speedometer stuck


    sit in the drivers seat close the door. with the key off hold the trip odometer button in then while holding the button in turn the key on. if done correctly this will put the MIC (mechanical instrument cluster) into a self test. if the speedometer does not move like the rest of the gauges during this test the MIC must be replaced. if the speedometer does move it is likely your problem will be fixed, however, if the speedometer does move but it does not start working properly then further diagnostic will be needed.

    Mar 19, 2009 | 2003 Chrysler Town & Country

    2 Answers

    The speedometer quit working on a 2001 town and country. I replaced the output sensor, but it still doesn't work. The check engine light is not on.... Any suggestions???


    Try pressing the trip odometer reset button for 5 seconds. It will flash2.gif an error code. Then the odometer lights will flash, a bunch of error codes2.gif flash. Let it finish.

    I found this on fixya before, and it worked for my van. I didn't replace anything.

    Feb 26, 2009 | 2001 Chrysler Town & Country

    1 Answer

    Speedometer


    Aha! Found a fix, at least to my problem.

    Try pressing the trip odometer reset button for 5 seconds. It will flash an error code. Then the odometer lights will flash, a bunch of error codes flash. Let it finish (my problem was that I tried to start the car the first time before it finished).

    Aug 23, 2008 | 2001 Chrysler Town & Country

    Not finding what you are looking for?
    2002 Chrysler Town & Country Logo

    Related Topics:

    101 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8518 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...