Question about Cars & Trucks
I have a 1999 Cadillac Deville, when I try to start it I get a message reading starting disabled remove key, and it wont start! How can I fix this problem?
Use the ignition switch master key. turn the ignition switch for ten minutes until LED ignition warning light go off.then turn off ignition switch wait 5 seconds then try to start engine. if this procedure starts your engine have dealership or garage to check out theft security system.
Posted on Jul 28, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Most common cause of this is the blower fan (proper name for the fan you refer to) continuing to run is a shorted out Electronic Climate Control Module. This solid state device replaces the older style fan speed resistor block (at about 4 times the price) This unit is found on the top of the HVAC box under the hood. (HVAC means heating, ventilation and air conditioning) The HVAC box is found on the passenger side of the firewall. Look behind the A/C's accumulator. It will have an electrical wiring plug on top of it. It will be fastened to the HVAC box with a few 7mm hex head screws. Very easy to change.
FYI, do yourself a favor and replace the blower fan motor at the same time. The Electronic Climate Control Module usually fails because the motor is drawing to many amps of current. This is because it's bushings are worn out or the brushes are worn out.
This is very common on Cadillacs and Buicks.
PS Not sure why car won't start. Either you drained the battery or blew a fuse which controls starting the engine. Need more info regarding the "no start" condition.
Posted on Jun 14, 2009
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
Posted on Aug 14, 2009
SOURCE: cadillac seville won't start
I've got an even cheaper and easier solution, instead of buying a new cylinder, find that plug and snip the orange wires going to the old cylinder.Then remove the resistor chip from the key and solder each of the the wires to each side. this will fool the car into thinking the correct resistor chip is in place, allowing you to use the original key or any copies with or without resistor chips. i just did this to my caddy and it roared to life! :)
Posted on May 20, 2010
Tips for a great answer:
Sep 10, 2014 | 1998 Cadillac DeVille
Sep 13, 2010 | 1999 Cadillac DeVille
Aug 24, 2010 | 1999 Cadillac DeVille
Feb 27, 2010 | 1999 Cadillac DeVille
Dec 16, 2009 | 1999 Cadillac DeVille
Sep 05, 2009 | 1999 Cadillac DeVille
Aug 14, 2009 | 1998 Cadillac DeVille
Dec 14, 2008 | 1999 Cadillac DeVille
Jul 23, 2008 | 2001 Cadillac DeVille
173 people viewed this question
Usually answered in minutes!