Question about Cars & Trucks
This is a small bulb on the fender side of the main headlamps
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in. (I say clamps, but they're more like glorified paper clips on either side of the fixture.) Press in on each side, pushing the clamps towards each other and pull the fixture out.
Posted on Dec 04, 2008
i think there are two flat guide pins that hold the headlight assembly in .. just pull them straight up ..and the assembly should come out ..hencse replace the bulbs.
Posted on Jan 25, 2009
once you pop the hood, there should be a cover behind the light housing that you twist to open the backing.. inside the housing will be a spring lever that secures the bulb down... unhook the spring and disconnect the harness connecting to the bulb...
Posted on Sep 03, 2009
SOURCE: headlamp replacement
1. Unplug the three-prong electrical connector.
2. Pull off rubber boot on back of headlamp
3. A spring clip holds the bulb in the assembly. Un-hook one side and swing the clip back.
4. Slide the old bulb straight out.
5.Wearing disposable gloves so that skin oil doesn't get on the new bulb, open the new bulb's package and insert the new bulb straight into the holder, making sure it goes all the way to the front. The middle electrical prong should be up.
6. Swing the retaining spring back and re-clip.
7. Slide the rubber boot back on the rear of the assembly, making sure that the electrical prongs are exposed.
8. Re-connect the three-prong electrical connector.
9. Turn on lights and make sure it works.
Posted on Oct 14, 2009
Tips for a great answer:
Dec 10, 2015 | Saturn Cars & Trucks
Apr 01, 2011 | 2007 Pontiac G5 Gt Coupe
you want to change the headlight bulb, or the whole headlight assembly? The bulb is easy. There is a round rubber boot, about 3 inches in diameter, on the backside of the headlight assembly under the hood. Behind the rubber boot is the headlamp , secured by a wire clip that holds it secure in place. You pop that wire clip open. Its sort of triangle shaped and clips on to the headlight Assembly. The clip doesn't normally come , just unclip it, and the headlamp will then pull out. Unplug it from the plug by pushing on the release tab. Take the lamp to the auto parts store and buy a replacement. Install in reverse procedure, but make sure not to touch the glass on the bulb. These bulbs get very hot and even slight oil from your finger tips can cause the glass on the bulb to burst. The one on the passenger side is harder to get to because of the battery location. The easiest way to change bulbs is usually to ask the person at the auto parts store to do it for you. Many times Auto Zone and Advance Auto stores will put them in for you.
The headlight assembly is a different story. That is the whole plastic headlight and side marker light that must come out. There are 2 ) 6mm bolts ( 10 mm head) located at the top of the headlamp , sticking in the radiator core support. That's the big piece of metal that goes from inner fender to inner fender which the radiator attaches too. Then there are 2 more bolts on the bottom of the headlamp assembly that bolt to tabs on either side. For the side marker light there are 2 screws in the backside of them against the fender, and a bolt on the bottom. You have to pull the plastic cover inside the wheel well. Might be easiest to pull the tire to get more room. There might be another bolt or screw in there, not sure as its been a while since Ive replaced them. If you replace a headlight assembly, they will cost you around $100 used at a salvage yard or e bay. The side marker lights you can get new for under $40 all over the internet. Hope this helps some
Feb 23, 2011 | 1997 Honda Odyssey
Remove the bolts from the front bumper fascia at the fender
Remove the 3 bolts which secure the composite headlamp
Oct 12, 2010 | 2003 Pontiac Vibe
Apr 02, 2010 | 1996 Ford Explorer
Jul 25, 2009 | 2000 Lexus RX 300
Mar 30, 2009 | 2002 Buick Regal
Mar 18, 2009 | 2000 Lexus RX 300
Jan 03, 2009 | 2001 Audi A4
31 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: