Question about Cars & Trucks

1 Answer

Why am I not getting any gas to throttle body

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Have u checked fuel filter?

Posted on Jul 29, 2013

  • marcus norsworthy Jul 30, 2013

    Yes replaced it yesterday still same problem?

  • Travis long Jul 30, 2013

    Is ur spring to your throttle body rusted or need to be loosened a little.. Sometimes ur spring can stick or not be getting enough exsese wire to keep it in throttle and without holding down constant gas the wiring or spring won't pull the throttle pulley enough do to sticking or not enough slack in wire..

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pittmanc
  • 194 Answers

SOURCE: gas is flooding thru throttle body when trying to start

eather o-ring is bad or throttle body injecter is cracked

Posted on Dec 15, 2008

Molson02536
  • 3854 Answers

SOURCE: car will not say running

You may have a bad fuel pump, First thing is to change the fuel filter since that's the cheaper of the two and you can find the filter under the driver's side  inside frame rail.
Once that's been changed and you still have the problem then it's a good chance that it's your fuel pump has gone bad. Try doing a fuel pressure test and there should be a think 44 psi at idle, but please dubble check that it is 44 psi for your blazer.
Good luck and the fuel pump is in the gas tank, if your going to have to change the fuel pump, don't forget to change the wire harness from the frame rail to the pump since you have it apart. The harness is only $12.00 and that's a good investment if the wries are getting brittle and a broken wire will get you to drop the tank again.

Posted on Apr 19, 2009

soc21610k
  • 215 Answers

SOURCE: only starts when pouring gas in throttle body

Tried changing the fuel filter? If that's not it it could be a bad pump

Posted on Jun 02, 2009

xxCARxx
  • 76 Answers

SOURCE: My 1998 S-10 is not getting gas to the throttle

when you first turn the key on you should hear the fuel pump run for about 10 seconds . this primes the fuel system .If you do not hear the pump run then you need to check the circuits for the pump
the fuel pump has a fuse and a relay that is use to power up the pump . you should check the fuse and if they are ok then switch the fuel pump relay with a like one in the fuse box (horn relay is the same as the fuel pump relay ) I think the fuse and the relay are both in the under hood fuse box on your truck . If these all check out ok then you need to check for power and ground at the fuel pump connector . if this checks out all good then replace the fuel pump . some times if you think the pump is not working you can bang on the gas tank with a rubber mallet this may move the pump winding off of the dead spot and the truck will start ... but this is not a fix .. just a way to get it started to move it or take it to a shop

Posted on Apr 07, 2011

  • 186 Answers

SOURCE: throttle body not giveing gass to motor

blockage

Posted on Jul 29, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 honda civic. car wouldn't start. thinking need gas. get gas. prime throttle body (maybe a little too much accidently) however, waited a day.(battery was dying from all the attempted starting. put an...


The only matter there should be in the throttle body is air. The throttle body in no way has anything other than "nothing" in it. The liquid you see could be the gasoline you threw into the throttle body.

Getting back to your problem. Do NOT have someone looking down the throttle body while you are trying to start the engine. That person may receive a haircut he will never forget! Get the battery charged. Try to start the engine because even though you think you put too much gas in the throttle body, it may start.

The tricky part. If the engine starts and runs for a few seconds, then you are having a problem with fuel delivery and that is the fuel pump most of the time but not always.. If it does not start at all, try one more time to pour gasoline into the throttle body, hold your foot about 1/2 way down on the pedal and then try again to start it. If it still doesn't start, it's time to check for spark.

Apr 04, 2014 | 1998 Honda Civic

1 Answer

1987 jeep comanche will stay runnning only when spraying carburetor cleaner in carburetor or when you pump throttle rapidly


Hello
It sounds like a glogged fuel filter or throttle body problem. Disconnect gas line at carb get a small jar or can to catch gas, hold gas line in jar and have someone crank engine, If you have good gas flow to carb then Its a throtle body problem, (Throtle body and carb are same thing just in case you did not know)could be electrical or mechanical problem at throttle body, Its usually electrical, fuel flow meter. Hope this helps

Oct 23, 2012 | 1987 Jeep Comanche

2 Answers

Gas pedal is hard to depress


Do you baby your car ...if so usually the throttle body gets caked up with gunk i would recommend to take off the TB and clean it ...this should solve your problem ...

May 25, 2011 | 2003 Buick Regal

1 Answer

Durango starts sometimes. then acts like its getting no gas and dies. if i stomp on gas it will keep running till i let off. bad gas ? fuel filter ? fuel pump?


I would suggest starting with the less expensive solutions first. If you pull the air intake hose off the throttle body and open the throttle with the engine off look down inside if it is black try spraying it out with throttle body cleaner make sure to spray it out good. Afterwards start it you may have to keep your foot on the gas for a few minutes to make sure it doesn't stall then take your foot off the gas pedal and see if it stays running if it does your throttle body just needed cleaned. Note do not use carb cleaner use throttle body cleaner only, carb cleaner can damage the sensor in your throttle body.

Dec 12, 2010 | 1999 Dodge Durango

1 Answer

Gas pedal sticks


the throttle plate gets gunked up, you can clean around it and use vaseline and if that doesnt work you can clean the throttle body with brake cleaner on the outside and throttle body cleaner inside if necessary

May 15, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Gas pedal sticks.


DETACH CABLE FROM THROTTLE LINKAGE..MOVE CABLE IN AND OUT OF CABLE HOUSING..IF IT MOVES FREELY,YOUR PROBLEM IS MOST LIKELY IN THROTTLE BODY/PLATE..YOU CAN REMOVE THROTTLE BODY..FIRST REMOVE AIR CLEANER,UNPLUG TPS,IDLE MOTOR AND INTAKE TEMP SENSOR..USE BRAKE CLEANER OR THROTTLE BODY CLEANER AVAILABLE AUTO PARTS STORES..DO NOT LET AND CLEANER GET IN TPS..YOU CAN USE A PLASTIC OR WOOD SCRAPER..SO YOU DON'T SCRATCH THROTTLE BORE AND CLEAN DEPOSITS FROM THROTTLE BODY/PLATE..HAVE SEEN THIS CAUSE STICKING OF GAS PEDAL..I HOPE THIS HELPS..WHEN DONE CLEANING,REINSTALL THROTTLE BODY AND RELATED PARTS

Dec 28, 2009 | 2005 Chrysler Town & Country

1 Answer

2001 Galant won't stay on.


Looks like gum and carbon deposits have clogged some critical parts in the engine, such as injectors.
You would need to get to the 'throttle-body'.
1. Trace the big intake-air hose to where it ends on top of the engine. This is the throttle -body.
2. Loosen the clamp that's holding the big-intake air hose. Pull off the intake air hose from the throttle-body.
3. Spray some "Throttle Body & Carburettor cleaner into the throttle-body. You could use the entire can.
4. Wipe off excess gas from the throttle-body with a piece of rag.
5. Reconnect the intake air hose, and check if the
problem has disappeared.

Dec 16, 2009 | 2001 Mitsubishi Galant

1 Answer

Where is the throttle body on a 96 maxima... and what do I need to access. My car sometime cutt-off while idling and sometime cuts out while driving like its getting no gas. I already changed my fuel...


The throttle body is where the carburetor used to be, in the middle top of the intake manifold where the air intake tube ends.
Use a major brand "Fuel throttle body cleaner" in your gas tank every 6 months or so. Don't use store brand. Ther eis also a spray for the linkage, etc. Use that too... and spray into the throttle body with engine running. Don't let the engine die while spraying into the throttle body.

Sep 30, 2009 | 1996 Nissan Maxima

2 Answers

Car stuck accelerating


pedal may not be stuck but cable or linkage are have professionly check could be a dangerous

May 31, 2009 | 2004 Dodge Stratus

1 Answer

1988 nissan pickup engine rotates but does'nt start.


it sounds like the injectors are not opening up man.. replace the injectores and this should fix your problem..good luck keith....

Mar 21, 2009 | 1987 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...