Question about Cars & Trucks

Open Question

Grand marquis brake light problem 93 - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fyrebyrd1
  • 121 Answers

SOURCE: no brake lights

Sounds like it has a bad brake lamp switch. It's possible that if you have a third brake lamp and that works, but the others don't, it is a bad multifunction switch. The brake switch is located on the brake pedal. The multifunction switch incorporates your turn signal/ hazard/ high beam lever mounted on the steering column. As confusing as this sounds, I hope this helps.

Posted on Dec 07, 2008

  • 2 Answers

SOURCE: turn signals don't flash when braking 99 grand marquis

Check all earth wires on all lights.
most lights in cars run in series so if u loose one you loose the other mainly caused by bad earth on globe holders or corrosion where bulb sits.
little sand paper goes a long way.

Posted on Mar 07, 2009

billshoff
  • 23 Answers

SOURCE: turn signals dont work brake lights dont work

You didn't mention your rear brake lights. If they don't work either then you probably have a bad light control module (LCM). This is a common problem with big Fords. You can buy a replacement part ($250) or have yours rebuilt (www.autoecu.com). The module is located under the dash to the right of the steering column and is fairly easy to replace.
Do the turn signals work? If not it may be the turn signal switch. The aftermarket parts are cheaper than a Ford factory part; check the guarantee before deciding.
Worse case scenario? You need both parts.

Posted on May 01, 2009

teemossinmia
  • 265 Answers

SOURCE: The brake light comes on, on the dash. Brakes work

Make sure your emergency brake pedal is all the way up, because sometimes if it goes down one notch, that can trigger that light to come on..It wont be enough to drag or slow the sar down, but it will be enough to turn that light on...Also even though your brakes are good..double check your break fluid level...

Posted on Dec 08, 2009

ftw1952
  • 10319 Answers

SOURCE: brake lights/turn signals,work but not tail lights

Faulty head lamp switch is your problem

Posted on May 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

While driving my cockpit lights goes out. Causing a blank dashboard. Vehicle does not stop when this happens. I pull over and turn off engine and then the dashboard lights come back on.


Mercury Grand Marquis Questions - why am i have no lights ...

www.cargurus.com > Questions > Mercury > Grand Marquis
CarGurusDec 31, 2014 - why am i have no lights on my dash - I only have the parking lightsthat ... My 2002 Grand Marquis' brake light on the dash comes on when I ...

Mercury Grand Marquis Questions - What fuses effect ALL ...

www.cargurus.com > Questions > Mercury > Grand Marquis
CarGurusFeb 12, 2014 - No dash lights ,no turn signals, no headlights, no brake lights, no stop lights,no dash lights, no 4 ... 2002 Mercury Grand Marquis LS Premium.

Nov 04, 2015 | 2002 Mercury Grand Marquis

1 Answer

1997 grand marquis won't shift out of park brake


could be the park pin is broken at the transmission. trans has to come out if that is the problem. sorry for sad news

Sep 19, 2013 | 2001 Mercury Grand Marquis

1 Answer

93 Grand Marquis: head lights work but no lights come on in back when head lights get turned on. ANY IDEAS????


Change headlight switch. Had Same Problem. Its easy just remove panel, remove 2 bolts and put new one back like you seen it.

Oct 06, 2011 | 1993 Mercury Grand Marquis

1 Answer

I have a 93 4-door grandmarquis.The brake lights dont work and the gear shift is loose,are they tied together? How do i get the brake lights fixed ?I already tried fuses...


You can check the brake light bulbs by removing the covers in the trunk, which may or may not be hidden behind a trunk lining. If there is a lining, simply pull it back and remove the protective cover and pull each bulb out and check for broken bulb wires or black burnt marks on the tips of each bulb.

Jan 15, 2011 | 1993 Mercury Grand Marquis

1 Answer

Abs light stays on what does that mean? 93 grand marquis


This means you have something worn out in the brakes. It is usually an accurate indicator. You could be low on Brake fluid, but then something is leaking and that is not good.

You need to check the Brake pads, Rotors, and take off the rear Rotors to check the Emergency brakes. Remember to clean the debris off all the sensors you see with Electrical wires on them. Remember to tell the Brake place if you have someone work on it, that you want the Emergency brakes checked.

I have had some clients go to both a Dealer and a Brake place and both places failed to find the bad Emergency brakes.

Jun 14, 2010 | 1993 Mercury Grand Marquis

1 Answer

I have a 1998 Grand Marquis and the brake lights and the turn signals stopped working. I checked the fuses and they look ok. Any suggestions??


I have a 93 4-door grandmarquis and everything works but the brakelights.
I was told that the gear shift is possably tied into this because the gear shift is loose.Is that true?
And what do you suspect is the reason the brake lights dont work?

Jul 02, 2009 | 1993 Mercury Grand Marquis

1 Answer

How to compress calipers on rear of 93 mercury grand marquis


No a 93 model just presses in like the front.

Apr 03, 2009 | 2006 Ford Freestyle

1 Answer

Turn signals don't flash when braking 99 grand marquis


Check all earth wires on all lights.
most lights in cars run in series so if u loose one you loose the other mainly caused by bad earth on globe holders or corrosion where bulb sits.
little sand paper goes a long way.

Mar 07, 2009 | 1997 Mercury Grand Marquis

1 Answer

No brake lights


Sounds like it has a bad brake lamp switch. It's possible that if you have a third brake lamp and that works, but the others don't, it is a bad multifunction switch. The brake switch is located on the brake pedal. The multifunction switch incorporates your turn signal/ hazard/ high beam lever mounted on the steering column. As confusing as this sounds, I hope this helps.

Dec 07, 2008 | 1993 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...