Have changed coil crank sensor and distributer pick up and fuse into panel under the hood and computer with a new one and still no spark towed it home found blowen master fuse under the hood changed started rite up and run for two days and Quite and now fuse is blown again and seems to have a short some place because soon as you touch another fuse to the same slot it blows it where does the other end of this circit go to ita a red wire with white stripe. the CDL will not read well this is going on niether. whaere to start at now after all this work has been done no spark still
SOURCE: No Start, No Spark, for Grand Caravan 3.8L
we get remans bad out of the box......... good luck
SOURCE: 1990 dodge shadow wont start no spark from coil
THERE IS A STATOR IN THE DISTRIBUTOR, THIS IS THE SAME AS A CRANK SENSOR, HAVE YOU CHANGED IT?
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
SOURCE: 1996 Ford E150 econol, 5.8 L 351 Stalls sporadically, runs great.
Did you check your fuel pump to see if it is functioning right or not .
SOURCE: Need a wiring diagram for a 1969 Ford F250.
there should be a slot for each wire on back of ignition play with them till you get it right cant hurt anything
35 views
Usually answered in minutes!
×