Question about Cars & Trucks

Open Question

1999 chevrolet cavalier cranshaft sensor location

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 299 Answers

SOURCE: 1999 Chevy Cavalier Horn Relay Location

should be in underhood junktion block.

Posted on Jun 17, 2009

Ad
motor1258
  • 6674 Answers

SOURCE: 2001 Cavalier throttle position sensor

Look where your throttle cables etc are attached at throttle body, it should be at opposite end of the shaft that operates throttle plate in front of throttle body opening. Usually held on with Torx screws

Posted on Jul 01, 2009

ZJLimited
  • 17970 Answers

SOURCE: I need to change my thermostat on a 1999 chevrolet

Fig. 1: The thermostat is located in the lower radiator hose on the 2.2L engine

3e9958f.gif


c3d1794.jpg


When adding coolant, it is important that you use GM Goodwrench DEX-COOL® (orange colored, silicate free) coolant meeting GM specifications. On these vehicles, if silicated coolant is added to the system, premature engine, heater core or radiator corrosion may result. In addition, the engine coolant will require change sooner; at 30,000 miles or 24 months.

  1. Disconnect the negative battery cable.
  2. Properly drain and recover the coolant until the level is below the thermostat.
  3. Unfasten the coolant outlet-to-inlet manifold attaching bolt and nut, then remove the outlet.
  4. Remove the thermostat. Clean the inlet manifold and outlet mating surfaces.

To install:
  1. Install a new O-ring onto the thermostat
  2. Place the thermostat in the inlet manifold.
  3. Attach the coolant outlet to the inlet manifold, using the bolt and nut. Tighten to 89 inch lbs. (10 Nm).
  4. Refill the engine cooling system.
  5. Connect the negative battery cable, then start the engine and check for coolant leaks.
Hope this help (remember rated and comment this).

Posted on Mar 13, 2010

ZJLimited
  • 17970 Answers

SOURCE: where is the iat sensor located on a 1999 chevy cavalier 4cyl

The Intake Air Temperature (IAT) sensor determines the air temperature inside the intake manifold. Resistance changes in response to the ambient air temperature. The sensor has a negative temperature coefficient. As the temperature of the sensor rises the resistance across the sensor decreases. This provides a signal to the PCM indicating the temperature of the incoming air charge. This sensor helps the PCM to determine spark timing and air/fuel ratio. Information from this sensor is added to the pressure sensor information to calculate the air mass being sent to the cylinders. The IAT is a two wire sensor, a 5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature.

a8b6fbb.jpg

Fig. 1: The IAT sensor is located in the air cleaner outlet tube-2.2L engine and 2.4L engine

Hope helped.

Posted on Apr 11, 2010

  • 973 Answers

SOURCE: change oxygen sensor 1999 chevrolet malibu

First locate it and get a wrench and unscrew it from the exhaust pipe and unplug it from the wiring harness and re-install the same way.

Posted on Jun 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to find the temp sensor location of an '05 cavalier


look for the thermostat and there should be a wire going to it and that is your temp sensor!

Mar 25, 2013 | 1999 Chevrolet Cavalier

1 Answer

Weres cranshaft sensor for 02 cavlier


it is located on the back of the engine next to the oil filter

Dec 08, 2012 | 2002 Chevrolet Cavalier

1 Answer

My daughter has a 1999 Chevrolet Cavalier Z24. Yesterday, when she was driving it up a hill, the car wouldn't accelerate even when pushing the gas. She stopped and put it in park for a few seconds...


The cavalier 2.4L engine had a problem with the crank sensor intermittently going bad. Sometimes it will run sluggish for a few minutes or even stall but eventually crank back up and run fine. The sensor is about $30 and can be changed in 10mins. It is located directly above the starter.

Jun 06, 2011 | 1999 Chevrolet Cavalier

1 Answer

Speedometer quit working on 1999 Chev Cavalier. Tthin it is the output sensor. Where is this sensor located ??


It on the back of the instrument cluster circuit board but, these clusters are faulty sooner or later all of the gauges will quit working replace the cluster

May 01, 2011 | 1999 Chevrolet Cavalier

1 Answer

Where is the iat sensor located on a 1999 chevy cavalier 4cyl


The Intake Air Temperature (IAT) sensor determines the air temperature inside the intake manifold. Resistance changes in response to the ambient air temperature. The sensor has a negative temperature coefficient. As the temperature of the sensor rises the resistance across the sensor decreases. This provides a signal to the PCM indicating the temperature of the incoming air charge. This sensor helps the PCM to determine spark timing and air/fuel ratio. Information from this sensor is added to the pressure sensor information to calculate the air mass being sent to the cylinders. The IAT is a two wire sensor, a 5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature.

a8b6fbb.jpg

Fig. 1: The IAT sensor is located in the air cleaner outlet tube-2.2L engine and 2.4L engine

Hope helped.

Apr 11, 2010 | 1999 Chevrolet Cavalier

1 Answer

Where is the camshaft sensor on a cavalier


2.2 ohv engines its on the back side of the engine below the throttle body 

on 2.4 its on top of the valve cover right below the t on twin

Apr 11, 2010 | 1999 Chevrolet Cavalier

2 Answers

1999 Cavalier abs sensors


there are located at the center of hub in the rear, and the front is also near center onthe side of were the axle goes into the hub, good luck.

Nov 24, 2009 | 1999 Chevrolet Cavalier

1 Answer

Cranshaft position sensor


it is located on top of the tranny in behind the exhaust manifold..

Jun 26, 2008 | 1999 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...