Question about Cars & Trucks
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
1.Flywheel - 61 to 69 Foot Pounds
2.Pressure Plate - 25 to 33 Foot Pounds
3.Bell Housing - No specs found. I would say 25 to 35 foot pounds should be sufficient.
Bolts clean on ->flywheel to crank, ->pressure plate to flywheel, and ->bell housing to back of engine, I would use TWO drops of Loctite Red threadlocker, on ALL of these bolts.
Hope you have an alignment tool for your clutch disk when you install it. Auto parts stores sell the plastic one's cheap! Saves a LOT of headaches!
Tighten the pressure plate EVENLY! Snug the bolts down until they just TOUCH, then go in a criss-cross pattern when tightening. Do the tightening in incremental stages! You turn one bolt one thread, you go across to the opposite side, and turn that bolt one thread. Keep criss-crossing so the pressure plate goes down EVENLY. (YES, it's a pain in the keister!)
If NOT, you'll have a warped pressure plate, and it will be junk!
Thanks for letting me say that, I feel better.
Posted on Jul 07, 2009
Tips for a great answer:
Dec 05, 2016 | 2006 GMC Canyon
Dec 29, 2015 | Hyundai Cars & Trucks
Dec 18, 2015 | Ford Cars & Trucks
Nov 19, 2015 | 2000 Cadillac Escalade
Nov 07, 2015 | Cars & Trucks
Jul 16, 2014 | Volkswagen Golf Cars & Trucks
Oct 04, 2010 | 1997 Mitsubishi Eclipse
Oct 03, 2010 | 1982 Chevrolet El Camino
May 17, 2010 | Ford Mustang Cars & Trucks
Jun 17, 2009 | 2004 Kia Sorento
Apr 20, 2018 | Nissan Cars & Trucks
26 people viewed this question
Usually answered in minutes!