Question about Lexus RX 330

Open Question

Replace bulb overhead console - RX 330 Lexus Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: Replacing map light bulb- How do you do it?

try auto zone and if you buy the bulb from them they will print out a diagram of how to install

Posted on Jan 05, 2009

Ad
  • 3 Answers

SOURCE: 2007 Chrysler TOWN AND COUNTRY.. OVRHEAD MAP

I had the same problem on my 07 and it turned out to be caused by the bulbs getting too hot and melting the surrounding plastic which opened the circuit powering them. I was able to fix the problem by removing the bulbs and cleaning the sockets allowing the bulbs to seat correctly. The lenses snap off to give you access to the bulbs. If you are not familiar with how interiors of cars come apart, I would not suggest doing it as you may crack the lens.

Posted on Oct 13, 2009

  • 9 Answers

SOURCE: I have a 2007 Chrysler Town and Country overhead mamap lite

I very gently pried on the outer curve of the clear cover. It snapped out easily. Then I noticed it only clips in to place on the left and right side of the widest part of the cover. I was then able to simply twist the bulbs out socket and all.

Posted on Dec 19, 2009

sscullys
  • 984 Answers

SOURCE: How do I remove the overhead console in my Ford

With the overhead console ( non rail system ), open the sun glass bin, and grab each corner in the back, and pull down.

The overhead is held on with 4 or 6 spring clips, and pulls straight down.

The bulbs are 1/4 twist sockets installed from the back of the overhead console.

Posted on May 17, 2010

Testimonial: "Your solution worked like charm. I appreciate your help."

  • 15 Answers

SOURCE: over head console dodge 2008 se removal

Open up the sunglasses holder and there might be a screw holding it in place there. There is also another screw underneath the main body, just unsnap the cover plate to access it.

The entire console slide back away from the windshield about 1/2" once the screws are removed, then drops away.

Posted on Aug 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 Honda Pilot overhead console removal


If you just want to replace the dome lights the clear buttons on the console can be removed carefully, The buttons will snap out from the console and the bulbs will be underneath.

Jan 30, 2013 | 2009 Honda Pilot EX-L

1 Answer

Changing the interior map light


The bulbs is replaced from the back of the overhead console with 1/4 turn bulb holders.

the overhead console ( non rail version ) is held up with spring clips.

Open the rear compartment, and grab the rear corners and pull down 1 at a time. They are very hard to pull the 1st few times. Once you have the read released, there is another set of spring clips in the front, so be careful how far down you pull the rear, until the front is released.

Once you can see the back of the overhead console, you will see the 1/4 turn bulb holders for the map and interior lights.

Sep 18, 2011 | 2005 Ford F-150

1 Answer

I need to replace the bulbs in my overhead console on my 1999 F350


Pull the front of the overhead console down to remove the console

Mar 30, 2011 | Ford F-350 Cars & Trucks

1 Answer

Replacing the front dome light


The front dome lamp & map lamps are replaced from the back, they are 1/4 turn bulb holders.

The overhead console ( non rail ) is held on with spring clips. Open the rear compartment, and in each corner grab the console with your thumb and index finger and pull down. The 1st time you remove it, it is very hard to pull down, the springs are very stiff.

The rail system, the service manual says to pull the overhead bins 1st, then pull the consoles out ( also spring clips )

Feb 19, 2011 | 2006 Ford F-150

1 Answer

How to change cab interior map light


Open the rear compartment ( on the non rail overhead ) grab and pull down in each rear corner. The overhead is held on with 4 or 6 spring clips.
Once you have the overhead console down, the bulbs are installed from the rear with 1/4 turn bulb holders.

Jun 20, 2010 | 2006 Ford F-150

1 Answer

How do I remove the overhead console in my Ford 1-50 to change a light bulb. I ordered the bulb from the Ford house, but they want a small fortune to replace the bulb


With the overhead console ( non rail system ), open the sun glass bin, and grab each corner in the back, and pull down.

The overhead is held on with 4 or 6 spring clips, and pulls straight down.

The bulbs are 1/4 twist sockets installed from the back of the overhead console.

May 17, 2010 | 2006 Ford F-150

1 Answer

How to change burnt out bulb on overhead console


popthe clear plastic cover off and pull the bulb out.

Nov 12, 2009 | 2008 Ford F 250 Super Duty 4WD

1 Answer

How do I REPLACE THE DOME LIGHT IN OVERHEAD CONSOLE IN A 300M


take screw out of front of overhead console , squeeze from end to end and pull down, see if bulbs are replacable, if not repl assembly.

Oct 31, 2009 | 1999 Chrysler 300M

1 Answer

HOW CAN I CHANGE THE BULBS FOR THE MAP LIGHTS AND THE CIGAR ASH RECEIVER WITHOUT BREAKING ANYTHING.


To change the bulbs for the map lights you need to first remove the screw located on the overhead console which is towards the front of the console (towards the front window). Then you need to pry down on the rear of the console. Once the console is removed you then need to remove the map light bulbholders and replace the bulbs.

As for the bulbs for the ashtray I am not sure if there is one.

Apr 02, 2009 | 2000 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...