Question about Cars & Trucks

Open Question

Ford Expedition 2001 the ABS EHCU is vibrating a noise

The EHCU is making a noise

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: 2001 ford expedition spark plug location

That's because they are hidden quite well. If you look at the engine, you'll see yellow plastic prongs (?) that look like spark plugs, but hook up to the silver tubing.  That's the fuel injectors.  BUT, right behind the yellow plugs, are black ones.  The black one is the connector to the spark plug.  The plug itself sits about 4 inches down into the block of the engine.  They are a real pain, and from what I can tell, you only have decent access to the first 2-4 of them, then they get too far back and start going under the dash (you'll see what I mean when you get there).

Posted on Aug 06, 2008

  • 119 Answers

SOURCE: Vibration and steering issues in 2001 Ford Mustang 3.8

1-have wheel blancing.
2-check front wheel rim any damage
3-have same front tire
4-check your drive shaft
5-also steering joints
6-check your suspention

Posted on Nov 13, 2008

  • 15 Answers

SOURCE: 2001 ford expedition

This is all electrical. Sounds like a fairly big job. Blinkers and ABS usually run from same fuse and therefore same wiring. Not sure of the 4x4 light. But Id say if you get a wiring diagram and folloe from the 3 items back there would be a common wore and id say in your case this wire is loose, or semi broken. However I think it would be less stress if you simply go to an auto electrician, Good luck, hope this helps.

Posted on Dec 31, 2008

  • 202 Answers

SOURCE: How do you change upper and lower ball joints on 2001 Ford Expedition?

i am not going to lie to you on this. if you do not have a very good mechanical back ground you should not attemp this procedure your self because it could result in serious injury. it should be brought to a shop because they do have the right tools to do this. alot of the time ball joints are pressed in under extream amounts of pressure

Posted on Apr 21, 2009

Frank97
  • 2 Answers

SOURCE: my 2001 ford expedition is making a humming noise

i have the same noise with my 2001 Expedition i have not fixd it but i do know its coming from the air intake,i think its the air filter making this noise try moving it around or take it out and see what happends,i took it out and it stoped but i out it back in and its still making it im gonna buy i new one and replace it.

Posted on Oct 18, 2009

Testimonial: "hey thanks, but I guess the idle control valve I bought was faulty, so I took it back replaced it and the noise is gone. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake pedal vibrates when pressed somethimes when turning and abs light is on 98 expedition.


possibly front brake rotors are warped,might be able to machine rotors or maybe have to replace them,

Dec 13, 2011 | 1998 Ford Expedition

1 Answer

2001 expedition horn only makes tiny squeak, fuses are ok


Of course the fuses are OK. The horn will not make any noise at all if the fuse is blown. It sounds like you have a defective horn assembly. - replace the horn.

Apr 17, 2011 | 2001 Ford Expedition

2 Answers

My 2001 ford expedition is making a knocking noise when I start it.


YOUR ENG IS GIVING YOU WARNING . MY FRIEND HAS THAT PROBLEM A NOISE DURING START AND AFTER START. NO DTC CODES OR CH. ENG LIGHT. IN SHORT HIS ENG WENT BAD. END UP CHANGING THE WHOLE ENG. ACCORDING TO THE MECH. SOME SAY THE OIL PUMP WORK AND DONT WORK CAUSING THE ENG TO BRAKE OR BROKEN. HAVE A SHOP TO LOOK AT IT DURING START AND AFTER START IT MIGHT SAVE YOU MONEY FOR LABOR AND ENG. HIS FORD SUV EXPEDITION COST HIM A LOT AND LOVE IT BUT THE COST IS HIGH. GOOD LUCK.

Aug 03, 2010 | 2001 Ford Expedition

1 Answer

After my 2001 Eddie Bauer Expedition warms up...


well i have heard that the front hubs are known to go bad in the 4x4 pickups,which should be the same parts as an Expedition,there may be metal dust on the ABS sensor or the flywheel it reads off from,thats if the hub and or bearings are bad.Jack it up with a jack under the lower control arm just behind the wheel and grab the wheel at the top and bottom and see if there is any movement,that should help explain if the hub is bad if there is alot of movement

Feb 15, 2010 | 2001 Ford Expedition

4 Answers

Ok well my 2001 ford expedition was running perfect until yesterday i get in it and it would not start so i tried to get a boost off but my battery is only two months old the radio works the lights and...


Do you happen to have more than one Ford Key on your key ring. The theft system on this is a transponder system and it could get the wrong signal from a key to a different vehicle.

Mar 14, 2009 | 2001 Ford Expedition

3 Answers

Speedo not working and tc and abs lights on


2000 vectra the dash light and fog lights dont work can you help

Nov 23, 2008 | 1997 Acura CL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...