Question about Hummer Cars & Trucks

Open Question

1996 hummer h1 wiring diagrams

Starter soliond wire has power at all times...why?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


SOURCE: 1996 chevy express van audio wiring diagram

go to

Posted on Aug 31, 2008

  • 93 Answers

SOURCE: i need 1996 honda accord speed sensor plug wiring diagram

Diagram is courtesy of honda


Posted on Dec 09, 2008

  • 1114 Answers

SOURCE: radio wiring diagram 1996 ford contour

Go to auto wreckers lots in cars out their

Posted on Dec 23, 2008

  • 50 Answers


Hello chk614, my name is JShreader. Thank you for choosing

Here is a picture showing the Wires connecting to the Starter...
If you are looking for the formal Wiring Diagram...see below...
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

Posted on Apr 01, 2009

  • 2050 Answers

SOURCE: Wiring Diagram 1998 Chevy S-10 starter replacement

The starter has one large cable from the battery positive, and a wire that goes to the solenoid (Part of the starter) that becomes hot when the key ignition is turned to start. This also passes through the neutral safety switch. (So it wont start in gear) Not sure if this is what you need, a little vague.

Posted on Jul 06, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

H2 hummer starter/solinoid diagram

follow your positive battery cable. it attaches to the starter. once you've located it you see usually 2 bolts hold it in place. take them out undo the wires on the back of it. reverse removal directions to install the new one. pay attention to where each wire came off of the old starter so you know where they go on the new one

Jul 16, 2012 | 2003 Hummer H2

2 Answers


Dear sIR:
pLEASE see the electrical-electronic diagram for ignition and proceed with common sense.


May 15, 2012 | 2002 Hummer H1

1 Answer

Location of fuel water seperator on a 2002 h1 hummer / vehical dies out./ cranks but will not run long, idles in park no problem till you drive it around time varies when it cuts out. milage 33,000 thanks...

The fuel/water seperator is located under the hood, driver's side, against the firewall. Black cap and 2 wires going to the bottom. The pump uses an optical sensor so yes, if there was fuel, it would really screw with the system. However, the PMD on these were problematic. This is the control module that is mounted to the side of the injector pump. They have a kit you can purchase to get it away from high heat and will comew with the harness and all to extend it. Would you like a 2003 shop manual for this?

May 07, 2011 | 2002 Hummer H1

1 Answer

2001 ford f350 disel starts by it self why

it has 2 b geting power 2 the starter soliond check power line 2 the starter 4 a bare spot hiting another wire it hase 2 b the wires going 2 the starter someware disels run hot and melt plastic coating if 2 close

Apr 04, 2011 | 2001 Ford F350 Super Duty SuperCab

3 Answers


You can test power to the starter, or to starter relay, or to any component with a voltmeter.

Jun 16, 2010 | Cadillac Eldorado Cars & Trucks

1 Answer

Hi want to install a aftermarket stereo in a 99 hummer h1 with a monsoon factory radio in it anybody have a wiring diag?

it is very common to do so however as a h1 tech myself i do not recomend such. it was by design that these monsoon systems drown out some of the decibles created by the diesel engine. if you still decide to do so i can get my manual out of storage and tell you which one are which. email me at

Oct 26, 2009 | 2004 Hummer H1

1 Answer

What is the adverage time to replace H1 brakes 1998 hummer

Depends on your driving habits. One of the best indicaters if you have never added brake fluid is the level in your master cyclinder. Rotors: if you feel a pulsation in the brake pedal under normal breaking.

Sep 06, 2009 | 2002 Hummer H1

1 Answer

Replaced motor on h1 hummer 6.5 diesel,we are not able to get the ac working.jumping compressor activates the system.does not use wiring from gm truck.need a print for hummer hvac

check all of your fuses and give this website a try fix trouble shoot heating & A/C and another one is www.directgardening and i hope i have been some help to you Michigan Man.

May 22, 2009 | Hummer H1 Cars & Trucks

1 Answer

Replacing rear brakes on a hummer h1 2000

ase labor chart shows 3.6 hours normal time for these repairs. avg actual time is 3.5 to 4 hrs and this includes pressure bleeding system.

May 09, 2009 | Hummer H1 Cars & Trucks

1 Answer

Charging system problem.

go to or Both have an extensive data base of tech info

Feb 10, 2009 | 2002 Hummer H1

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides