Question about Cars & Trucks

1 Answer

Coloado turn signal problems

It was first just no right rear turn signal then month later no left rear turn now there are no rear emergency flashers . I do have a factory installed trailer light package.

Posted by on

Ad

1 Answer

That Vehicle had so many problems & I was
going to buy one, if it were not for all that
I would check manufacture bulletins & after market
ones, before doing a thing
I would bet their is a solution for most things
You may have to go to a repair shop & look in alldata,
indentix to find them
I wouldn't even start to diagnose that vehicle without
doing that first,they had many issues,more than any product
I have seen, not just vehicles, all products

Posted on Jul 26, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 187 Answers

SOURCE: 2006 Ford Escape - Right side flashers (turnsignals) not working

Check the wires at the connection point and follow them back up to the tail light look for any disconnected wires or grounds. Good luck.

Posted on May 14, 2009

pops296
  • 174 Answers

SOURCE: Factory Trailer tow package - fuses?

Look in the owners manual first. I have seen some of the fuse boxes under the back seat on the drivers side. Also try http://www.etrailer.com/faq-wiring.aspx. This should help. Mike

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i turn the signal lights for left or right turn the emergency flasher start flashing all four turn signal lights. the emergency flashers work ok


ck your turn signal switch wiring connector because it is more than likely has been hot and melted some connections.

Oct 18, 2014 | 2000 Kia Sportage

2 Answers

Flasher relay location Pontiac Bonneville 2004 removal and installation.


If the right side works it's not your flasher, Its your left side bulb, either front turn signal or rear tail light bulb.

Aug 02, 2014 | 2004 Pontiac Bonneville

1 Answer

I have no signal lights, left or right, on my 2000 Oldsmobile Intrigue. I was having a problem with a front bulb not contacting properly making the right signal flash rapidly. I left it flashing while


Check if your emergency flashers still work. You possibly need a new flasher. Some cars have separate flashers for turn signals and emergency flashers, but some they are both together. If your emergency flashers still operate leave them on and find the flasher (follow the clicking noise the flasher makes) and see if there is another flasher right next to it. swap with the emergency flasher and see if your turn signals work again. If so, replace the faulty flasher.

Jul 26, 2014 | 2000 Oldsmobile Intrigue

2 Answers

1998 olds intregue flasher problems


Sounds like it's a problem in the turn signal switch. Are you sure you used the right bulbs when replacing them?

Nov 22, 2011 | 1998 Oldsmobile Intrigue

1 Answer

No brake lights of blinkers 1990 dodge dynasty


While not likely, it is possible that the light bulbs in both sides are have bad filaments. Turn on ignition key (but don't start engine). Then turn on parking lamps (first detent or "click" on headlamp switch). Walk around car and look for illumination on front parking lamps and rear tail lights. Turn on the right turn signal. Are those (right hand) lamps now changing brilliance? Try the left turn signal in the same manner. Are those (left hand) front and rear lights changing briiliance? Take note of any positions that did NOT change briliance when the turn signals were activated. If NONE changed briliance, you either have a bunch of bad bulbs (unlikely) or a bad flasher (more likely) or a bad turn signal switch (most likely) or perhaps wiring problems (possible if the car has been in a collision or has been "worked on" by some "non-expert" mechanic). Check the action of the emergency flasher control switch located on the steering column (facing up). Pushing it in (down) should result in the button going to two different heights alternately (low, high, low, high). You could just have bad flashers or corroded flasher contacts! Good luck!

Nov 15, 2008 | 1993 Dodge Dynasty

3 Answers

Blinkers stopped working


Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.

Oct 20, 2008 | 1996 Ford F150 Regular Cab

1 Answer

2000 Accord turn signal problem


either the front or the rear turn signal bulb is blown, that is why the flash frequency is high. replace the bulb and the problem will be solved. best to replace both the front and rear turn signal bulbs. good luck.

Aug 29, 2008 | 2000 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...