Question about Cars & Trucks

1 Answer

Volvo s60 integrated phone

My phone used to work but now sits saying 'please wait....' This is since I put in a new payg sim in. It previously worked with my actual mobile sim. Anyone know how to reset the phone as I can't access menu while it has this message.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,326 Answers

Try putting the old sim back in and then see if the phone is open or tied to a network.Other than that try the dealers they will have the software to sort it thats for sure

Posted on Jul 26, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 102 Answers

SOURCE: emission system

you have a code in the emission system comp telling you you have a fault, you will need to have the codes read by volvo

Posted on Oct 21, 2008

repairpal
  • 128 Answers

SOURCE: Problem with 2002 Volvo S60 automatic Gearbox

Make sure that you have the transmission software updated. Volvo has had many upgrades on their transmission's control software to address these exact symptoms.

Bret
RepairPal.com

Posted on Nov 20, 2008

  • 36 Answers

SOURCE: Message board states "Bulb Failure Position Light: What is this>

Hello mtsign

This a problem with "A" bulb, no real way to find the problem one unless you test the output of each bulb. You will have to replace them one or two at a time. Start with the rear bulbs as they get the most use i.e. brake lights. Sounds strange but, over time a bulb will lose it's strength and the computer picks it up as a bad bulb and sends the message, quite common with these vehicles. I would use quality replacement bulbs or you could be chasing around weak cheaper bulbs for a while. Hope this helps and good luck.

Posted on Feb 12, 2009

  • 18 Answers

SOURCE: Volvo S60 sensor ?

Sounds like an oxygen sensor (there are two). I had a recent problem where I had a rough idle and my S60 continued to stall out. Turned out to be the rear oxygen sensor. After replacement, car idles nicely and car drives normally.

Posted on Jun 30, 2009

Mustgo
  • 2359 Answers

SOURCE: How do I reset the SRS-Airbag SERVICE URGENT Fault

Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Did my center dash lights short out


oops, you blew up something with bad wiring,
why not let a pro wire your car, with out hacking it.
that tape is mark of a NON PRO work.
it's doomed,

Jan 29, 2015 | 2013 Toyota Tundra

1 Answer

97 S90 Volvo with original radio per Previous owner. Radio worked before Battery replaced. Called dealer and Got code, put it in and got rpt message. Several attempts- still no Working radio! HELP...


ok rpt stands for repeat. when it says that it is the wrong code that you are putting in. you only get three trys on this. after the third time it will say off. you must wait 2 hrs with the stereo on until you can try putting a code in. you need to find the right code for that stereo.inside your manual book there should be a credit card size card that has a four digit code on it. that is your stereo code. put that in and your stereo should be up in running. good luck

Dec 07, 2013 | Cars & Trucks

1 Answer

2002 volvo s60 headlights are not working,scanner said module problem


2002 volvo s60
Don't waste your money on unnecessary sources and unwanted repairs. Get this manual online under $10-15 and get complete guide on whether to repair or not, service it, and how to repair etc

Jan 25, 2018 | 2002 Volvo S60

1 Answer

Bentley continental GT engine stops all power turns off (even hazard warning) key won't come out of ignition


need to check the charging system..when a car sits for a long time the battery should be disconnected or compl,etely removed..sounds like operating voltage is too low check the alternator for stuck brushes or malfunctioning regulator..should show around 14.5 -16 volts..

Feb 24, 2013 | Bentley Continental GT Cars & Trucks

1 Answer

2007 VOLVO S60 2.5T, KEY DOESN'T TURN PAST POSITION #1?


wiggle steering wheel, step on the brakes, wiggle the shifter see if any of the safety interlocks are not working properly.

Feb 09, 2013 | 2007 Volvo S60 2.5T

1 Answer

1996 Saab 900 Radio Won't Accept Code


unhook the battery for an hour or so to fully clear any previously bad entry attempts. hook battery back up and try the code again

Dec 23, 2012 | 1996 Saab 900

1 Answer

I have a Chevy blazer and my handle of the sit its broken well not actually broken cause I can put it on, but it won't release or adjust my sit if u can help thanks!


If there is enough room to put a pair a vice grips on it you could clamp them on that and adjust the seat that way. It's not pretty but may work. I had to do that on a Chevette once while driving the gear shifter broke off and reached in the tool box and clamped the grips onto the nub so I could shift to get out of traffic'

Oct 17, 2012 | Cars & Trucks

1 Answer

Oldsmobile alero intermittant prime


The way the system works is fairly simple.
The computer grounds the pump relay for 3 or 4 seconds when the key switch is turned on. If the engine does not produce oil pressure the pump power is cut.
If you have changed the relay and the problem persists, I would expect the problem to be in the computer.
The pass key system prevents the starter and fuel injectors from working. I don't think it controls the fuel pump relay.
Did you mean to say you had to wait 10 min before turning the key switch on a second time, or did you leave the key switch on for 10 min ?
You could probably use a low voltage tester or VOM to check the signal from the ECM, but the tool you use may cause the relay to come on in place of the signal.
The other three circuits are power from the battery, power from the key switch, and the line out to the pump. One of those could be faulty, especially the one from the key switch. But other things should be not coming on too if that were true.

Jul 23, 2012 | 2001 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13735 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...