Question about Hyundai Sonata

1 Answer

Pass 3000 rpm

No passing gear --motor just rivs

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 352 Answers

CHECK:
1. FLUID LEVEL
2. REPLACE TRANS FILTER AND FLUID IF NOT OR NEVER DONE, (WHICH IS 90% THE CASE MOST OF THE TIME)

Posted on Jul 26, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 26 Answers

SOURCE: vacuum hose routing diagram for 1989 mazda truck B2200

vacume hose routing is under the hood on a white lable.

Posted on Jan 01, 2009

  • 160 Answers

SOURCE: problems wont pass 4000 rpm's

Depending on the model of accord. It may be a VTEC malfunction in the computer. If it's an EX it is a VTEC

Posted on Jun 16, 2009

  • 68 Answers

SOURCE: Driving a 2003 Ford windstar. Went to pass and

Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.

Posted on Mar 01, 2010

  • 5 Answers

SOURCE: honda accord doesn't pass 3000 rpm and start

crank angle sensor located in the distributor.. buy a whole distributor from a junk yard. you will save a lot of money

Posted on Mar 03, 2010

  • 100 Answers

SOURCE: my jaguar x type wont

Vehicle is in a restricted performance mode, limits the engine revs to below 3,000. Need to scan the vehicle and see what codes are present. could be a problem with the throttle body.

Posted on May 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my honda wont let me rev it up pass 3000 rpm..


will it go over 3000 when driving. if so then when not in gear it is hitting the rev limiter, there is nothing you can do as its built into the program to keep the engine from damage when not driven.

Jul 16, 2015 | Honda Cars & Trucks

1 Answer

2003 polo revs iinconsistent , loses power


Clean air filter and check vacuum lines.

Apr 18, 2014 | Volkswagen Polo Cars & Trucks

1 Answer

Engine surges


try fuel filter if doesnt work check fuel pressure sounds like fuel pump if not filter

Jan 10, 2014 | Cars & Trucks

1 Answer

Losing power going up hills


sounds pretty normal. what speed do you try out the passing gear? anything above 35-45 mph and it will feel like neutral. Passing gear is actually only 1st gear. When you press down the pedal, it forces the transmisson to shift into low gear.

Dec 16, 2013 | Oldsmobile Alero Cars & Trucks

1 Answer

96 chevy 2500 hd 5.7 v8.Replaced 3 bad 02 sensors and mass airflow sensor...when get to 3000 rpm it loses power... Especially when in passing gear...took to mechanic and said was wrong or bad mass...


Remember, they don't hire rocket scientists at Auto Zone, ask your local dealership for the right part and then purchase the part at another auto store.

Jul 02, 2013 | Cars & Trucks

1 Answer

Pathfinder 2001 could not pass 3000 rpm


I had that same issue with my 2004 Pathfinder and it was the fuel filter. (Was supposed to have been replace during a service, but obviously wasn't when I changed it)

Jul 04, 2012 | 2001 Nissan Pathfinder

1 Answer

1998 SC2 ,5 speed I get to right at 3000 RPM in


IfI suggest ckg the maf sensor. It tells the ecu how much fuel is needed to keep the air fuel ratio proper.by measuring the amout of air passing into the intake duct from the air cleaner.. First ck the connector. the maf sensor is the first in the duct coming from the air cleaner... Good luck.

Jun 09, 2009 | 1999 Saturn SL

1 Answer

I cannot see at what speed I am travelling and cannot pass 3000 r


there is a either a engine vacuum problem maybe caused by the oxygen sensor not working properly or your fuel filter needs to be replaced.

Apr 10, 2009 | 2005 BMW X5

2 Answers

Vacuum hose routing diagram for 1989 mazda truck B2200


vacume hose routing is under the hood on a white lable.

Jan 01, 2009 | 1989 Mazda B-Series

1 Answer

Can't pass 3000 rpm


need to check codes and see if it has oil in it. and go from here.
if the computer sences low oil pressure it sets a rev limiter to try and save the engine. code P1259 i think. 4 or 6 cyl?

Dec 18, 2008 | 2000 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...