Question about Cars & Trucks

Open Question

2001 mazda mpv instrument cluster

Gas gauge speedometer odometer not working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 48 Answers

SOURCE: 2000 Chrysler Voyager Instrument Cluster is dead

have you got a dimmer switch on your model to dim the dash lights. if you have it may be faulty. link the cables together if the lights work the switch is faulty. if you have not got a dimmer switch
your printed circuit on the back of the dash may be faulty or the plug in the back of the dash is not pushed all the way in. hope this helps

Posted on Apr 16, 2009

  • 1 Answer

SOURCE: instrument panel cluster gauges and odometer has stopped working

I had all my analog instrument panel gauges stop working after they did the state emissions test. I found the proper fuse in the fuse block located under the hood. Simply unplugged the fuse, noticed it was still good, and plugged the same fuse (10A) back in and all the gauges started working again. Guess it needed a reset atfer they plugged in for the emissions.

Posted on Aug 14, 2009

  • 523 Answers

SOURCE: the odometer speedometer gas gauge and heat gauge do not work

There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
I hope this may have helped,
Tom
PS: I have helped several persons with this issue, please review my profile; good luck with it (also often times with this issue the ABS light stays on)

Posted on Oct 20, 2009

Testimonial: "thank you you are the only person who had an answer I will try and let you know"

  • 1 Answer

SOURCE: speedometer, gas gauge, odometer, rpm gauge not working

My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Posted on Oct 21, 2009

  • 81 Answers

SOURCE: Dashboard Instrument cluster does not work.

there are 2 large terminal plugs with the wiring for all the instruments that are plugged into the back of that panel. make sure they are snug and in place. You reach in and under but it may easier to "simply" remove the cluster. 4 screws hold it in place accessible form underneath and with a long phillips screwdriver and lighting.

Posted on Oct 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998'Ford Explorer and half the dash lights are out and all pod a sudden my speedometer just quit. Need to know what fuses would go to these, so I can try that. Ty


Sorry but it's not a fuse problem . There is not a fuse just for the speedometer . The microprocessor inside the instrument cluster determines where the speedometer needle points , just like the fuel gauge , tachometer etc... Having the vehicle checked for DTC'S would be the proper step to take .
Vehicle Speed Signal
The vehicle speed signal is generated by the rear anti-lock brake sensor and sent to the 4-wheel anti-lock brake system (4WABS) module. The 4WABS module sends the vehicle speed signal via circuit 679 (GY/BK) to all systems which require a vehicle speed signal input.
Speedometer
The electronic speedometer receives a speed signal from the 4WABS module.

  • The Speedometer/Odometer Is Inoperative
  • Circuitry.
  • Speedometer.
  • GO to Pinpoint Test E .

No where in this factory diagnostic step does it say to check a fuse !

PINPOINT TEST E: THE SPEEDOMETER/ODOMETER IS INOPERATIVE CONDITIONS DETAILS/RESULTS/ACTIONS E1 CHECK THE VOLTAGE TO THE INSTRUMENT CLUSTER
Instrument Cluster
Measure the voltage between instrument cluster C288-7, circuit 1001 (WH/YE), and ground.
  • Is the voltage greater than 10 volts?
Yes GO to E2 .

No REPAIR circuit 1001 (WH/YE). TEST the system for normal operation.
E2 CHECK THE INSTRUMENT CLUSTER PRINTED CIRCUIT
Instrument Cluster
NOTE: Measurements must be made to the speedometer gauge pins that are inside the instrument cluster printed circuit clips.
    Measure the resistance between the speedometer pins (which can be seen in the middle of the instrument cluster printed circuit clips) and the corresponding instrument cluster terminal. Refer to the table for the pin and terminal assignments.
    Instrument Cluster Terminal Speedometer Gauge Pin C286-13 C287-1 S C287-2 G C288-7 BATT
    .

  • Are the resistances less than 1 ohm?
Yes GO to E3 .

No INSTALL a new instrument cluster printed circuit. REFER to Instrument Cluster Printed Circuit . TEST the system for normal operation.
Your best bet , take it to a qualified repair shop

Mar 30, 2017 | Cars & Trucks

3 Answers

My speedometer works but my digital odometer does not work on my 2003 old alero


This is one guy's advice: Replace the speedo head, that should take care of the problem."

This site is also interesting because the guy said
General Motors cars had instrument cluster problems from 2003 through 2006. When I researched instrument cluster problems on the Internet what I found raised concerns in me. Many of those vehicles had problems that began with the instrument cluster, but eventually led to the engine refusing to start.
(an electronic instrument cluster, digital instrument panel or digital dash for short, is a set of instrumentation, including the speedometer, that is displayed with a digital readout rather than with the traditional analog gauges. Many refer to it simply as a digital speedometer.)

http://www.instructables.com/id/Erratic-Instrument-Panel-on-GM-Cars/

Feb 12, 2017 | 2003 Oldsmobile Alero

2 Answers

2001 Buick Century Limited speedometer problem, Speedometer not working but odomitor ok. Is there a fuse?


if the odometer is working then the problem is with the speedometer head unit as the odometer gets its information from the same source as the speedometer. you can have the speedometer head checked and fixed if its fixable.

Aug 22, 2015 | 2001 Buick Century Limited

1 Answer

Speedometer, odometer,and gas gauge not working


Sounds like you have a bad Instrument Cluster (Also called a Speedometer) and the easiest thing to do is to go to a Salvage Yard and replace it. You can also go to EBAY or www.car-part.com and there is a locator for cars by Price/Distance and you can get a used one. I just checked and there are 12 between the price of $15 - $40 on Car-Part.com.

Apr 05, 2013 | 1996 Plymouth Voyager

2 Answers

Where is cluster for speedometer lights


The "cluster" means all of the things you see under the plastic cover in front of the driver, the 'gauges'. The term is a reference to the 'instrument cluster' including speedometer, tachometer, fuel gauge, idiot lights, temperature gauge, everything.
Get a second independent opinion since this is very unusual. Most likely you have a blown fuse.

Aug 26, 2012 | 1998 Cadillac DeVille

1 Answer

My gas gauge works intermittently and speedometer reads 60 mph at idle


I am about to buy an 01 Silverado 1500. The gas gauge wasn't working and the whole odometer display was blank. The dealer checked it out and said it needs a new instrument cluster. You might check into that.

Feb 10, 2011 | 2003 Chevrolet Silverado 2500HD

3 Answers

Speedometer, gas gauge, odometer, rpm gauge not working


My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Jul 29, 2009 | 1998 Nissan Frontier

2 Answers

1995 Cougar Odometer/trip-meter inop


Section 13-01: Instrument Cluster—Conventional 1995 Thunderbird, Cougar Workshop Manual REMOVAL AND INSTALLATION Instrument Cluster Removal and Installation
  1. Disconnect battery ground cable (14301) .
  1. Remove screws holding instrument panel reinforcement (017A28) .
  1. Remove screws holding instrument panel lower shield (045G02) .
  1. Remove fasteners holding steering wheel column as outlined in Section 11-04 . Gently lower steering column.
  1. Remove fasteners holding the instrument panel finish panel (044D70) and gently pry off.



  1. Remove four instrument cluster retaining screws. (Do not remove screws from the instrument cluster main lens (10887) and instrument cluster mask (10890) ).
  1. Slide the instrument cluster (10849) to the right of the instrument panel opening and unhook the instrument panel harness from the back of the instrument cluster .
  1. Remove the instrument cluster from the instrument panel (04320) .
-----------------------
Speedometer/Odometer Federal law requires that the odometer in any replacement speedometer (17255) must register the same mileage as that registered in the removed speedometer . Since the speedometer mileage cannot be reset on this unit, affix odometer sticker to driver's door pillar and record original vehicle mileage. Removal
  1. Disconnect battery ground cable (14301) .
  1. Remove the instrument cluster (10849) as outlined.
  1. Remove seven screws retaining the instrument cluster mask (10890) and instrument cluster main lens (10887) .
  1. Remove speedometer assembly.
Installation
  1. Position the speedometer assembly to the instrument cluster back plate (10848) and install.
  1. Position the instrument cluster mask and instrument cluster main lens to the instrument cluster back plate and install the seven retaining screws.
  1. Install the instrument cluster as outlined.
  1. Connect battery ground cable and check the operation of the speedometer .
please rate if this helps

Mar 24, 2009 | 1994 Mercury Cougar

1 Answer

Speedometer/ Fuel Gauge & Tachometer not working


check for loose connection at the instrument cluster.

Jun 28, 2008 | 2001 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...