Programming key fob 2005 cobalt - 2005 Chevrolet Cobalt

SOURCE: 2005 chevy cobalt lt fob programming

unfortunatly, that is usually a programming code that the dealer does not let out. that is one of there easy money makers. it cost me $180 at nissan to get mine done, because no one could help me there.

Jeffery Lewis

• 329 Answers
• Posted on Jun 04, 2009

SOURCE: programming used key fob for a 2000 tahoe

get in your truck close all the doors put your key in the ignition push and hold your unlock button on the door panel turn the key on then off then on then off release the onlock button at this time the lock should cycle lock then unlock by them self if they did push and hold your lock and the unlock buttons on your remote at the same time for 15 seconds the lock should cycle agian and you are programmed

SOURCE: 2005 chevrolet malibu

There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE questio - even if it is not the answer you wanted to hear :D

SOURCE: wireless key fob can't be programmed

you can call the dealer and give them your vin number they will be able to tell you if your vehicle came equiped with that feature or not

SOURCE: how to program key fob. I have the fobs.

Transmitter Programming Procedure
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the door unlock switch.
While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on the transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of the transmitter.
Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation.
Good luck