Question about 2008 Volvo C30

Open Question

Radiator removal condenser - 2008 Volvo C30

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How is the a/c condenser attached to the radiator on a 2006 impala


According to Mitchell On Demand, you need to remove the radiator first. Remove cooling fan assembly and then the radiator. The condenser just rests on the radiator mounts with 4 mounting pads. You lift the condenser off these to just replace the radiator leaving the condenser in place. Of course after removing the radiator, you disconnect the condenser lines and remove it at that time.

Oct 27, 2014 | 2006 Chevrolet Impala

1 Answer

Radiator removal


IF the condenser is mounted by bolts through the radiator fins / cores simply undo and remove the bolts. Mostly the condenser is mounted on the front of the radiator panels while the radiator is mounted on the rear of the panels with separate bolts

Dec 21, 2013 | 2006 Chevrolet Malibu

1 Answer

Replace raditor 2001 chrysler 300 M


1. Remove or disconnect the following:
  • Disconnect negative battery cable.
  • Drain cooling system.
  • Upper radiator hose .
  • Upper radiator closure panels.
  • Radiator fan assembly .
  • Radiator fan electrical connector.
2. Raise the vehicle

3. Remove or disconnect the following:
  • Lower splash shield.
  • Lower radiator hose.
  • Lower condenser mount bolts
4. Lower vehicle.
5.Remove or disconnect the following:
  • Upper radiator mounting brackets and bolts.
  • Upper condenser mounting bolts.
6. Separate condenser assembly from radiator.
7. Tilt radiator toward engine and remove radiator from vehicle.

Clean radiator fins are necessary for good heat transfer. The radiator and air conditioning fins should be cleaned when an accumulation of debris has occurred. With the engine cold, apply cold water and compressed air to the back (engine side) of the radiator to flush the radiator and/or A/C condenser of debris. The installation of the new radiator is the opposite of the removal. Please upvote if this was helpful. :)

May 04, 2011 | Chrysler 300M Cars & Trucks

2 Answers

How to remove radiator from my 2000 chrysler 300


Radiator Removal & Installation To Remove:
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Disconnect negative cable.
  3. Drain cooling system.
  4. Remove or disconnect the following:
    • Radiator upper crossmember
    • Upper and lower coolant hoses from the radiator
    • Transmission hoses from cooler
    • Engine oil cooler lines (if equipped)
    • Radiator fan electrical connector and fan assembly
    • Condenser mounting screws located at the front of the radiator
    • Transmission cooler line bracket from left side of radiator
  5. Lift condenser upward enough to disengage upper mounting clips. Allow condenser to rest on lower radiator crossmember.
  6. Lifted radiator from engine compartment.
To Install:
  1. Seat the radiator assembly lower rubber isolators into the mounting holes in radiator lower support.
  2. Attach air conditioning condenser to radiator
    • Torque to 45 inch lbs. (5 Nm)
  3. Install or connect the following:
    • Radiator lower hose
    • Transmission cooler line bracket and transmission hoses
      1. Torque to 28 inch lbs. (3 Nm)
    • Radiator fan and electrical connector
    • Engine oil cooler lines (if equipped)
      1. Torque to 160 inch lbs. (18 Nm)
    • Radiator upper hose
    • Radiator upper support crossmember
    • Negative cable
  4. Fill cooling system with coolant.
prev.gif next.gif

Aug 03, 2010 | 1999 Chrysler 300M

1 Answer

How to remove and replace radiator on 1998 ford taurus


  1. Disconnect battery ground cable.
  2. Remove the battery.
  3. Remove clip retaining constant control relay module and position module aside.
  4. Remove battery tray.
  5. Remove radiator cap.
  6. Raise vehicle on hoist.
  7. Remove radiator splash shield.
  8. Drain engine cooling system.
  9. Remove radiator mounting bracket assembly.
  10. Remove lower radiator hose.
  11. Partially lower vehicle.
  12. Remove upper radiator hose.
  13. Remove radiator overflow hose.
  14. Remove upper A/C condenser core retaining bolts.
  15. Remove upper A/C transmission oil cooler tube clips.
  16. Remove upper transmission oil cooler tube (7C410) using 3-8 inch fuel line disconnect tool 310-041 (T90T-9550-C).
  17. Raise vehicle on hoist.
  18. Remove lower transmission oil cooler tube clips.
  19. Remove lower transmission oil cooler tube using 3/8 inch fuel line disconnect tool 310-041 (T90T-9550-C).
  20. Remove transmission oil cooler bracket and position transmission oil cooler aside.
  21. Remove lower A/C condenser core bolts and position A/C condenser core (19712) aside.
  22. Remove radiator support bracket.
  23. Remove radiator.

May 07, 2010 | 1998 Ford Taurus

2 Answers

How do i replace the radiator on my vw golf mk4 1.9tdi year 2000


  • Drain coolant from bottom hose through a valve
  • Disconnect coolant hoses from radiator
  • Remove front body section and move lock carrier to service position
  • Remove retaining clamps from A/C hoses near condenser
  • Unbolt A/C condenser from radiator and support condenser with wire or heavy duty tie wraps Note: Do not discharge the A/C refrigerant. Support the A/C condenser with wire and avoid stretching or kinking the hoses.
  • Remove radiator mounting bolts from both sides and slide radiator slightly to the rear
  • Remove radiator and fans together from below
  • Installation is the reverse of removal

Jan 15, 2010 | 2000 Volkswagen Golf

2 Answers

How to remove a radiator from a ford taurus


Disconnect battery ground cable. Remove battery. Remove battery tray. Remove clip retaining contant control relay module and position module aside. Remove radiator cap. Raise vehicle front end as high as possible. Remove radiator splash shield. Drain radiator. Remove the radiator mounting bracket assembly. Remove lower radiator hose. Partially lower vehicle. Remove upper radiator hose. Remove radiator overflow hose. Remove upper A/C condenser core retaining bolts. Remove upper transmission oil cooler tube clips. Remove lower transmission oil cooler tube. Raise vehicle. Remove lower transmission oil cooler tube clips. Remove lower transmission oil cooler tube. Remove transmission oil cooler bracket and position transmission oil cooler aside. Remove lower A/C condenser core bolts and position A/C condenser core aside(be careful not to loosen the AC condenser lines. Remove radiator support bracket. Remove radiator out through the bottom of the vehicle.
Installation
Position radiator. Position radiator support bracket and tighten nuts. Position A/C condenser core and tighten lower A/C condenser core bolts. Position transmission oil cooler tube and install transmission oil cooler tube bracket. Install lower transmission oil cooler tube. Install lower transmission oil cooler tube clips. Install lower radiator hose. Install radiator mounting bracket assembly. Tighten bolts. Install radiator splash shield. Lower vehicle. Install upper tranmission oil cooler tube. Install upper transmission oil cooler tube clips. Install upper A/C condenser core retaining bolts. Tighten bolts. Install radiator overflow hose and tighten clamps securely. Install upper radiator hose. Position constant control relay module and clip securely. Install battery tray. Install battery. Connect battery ground cable. Fill and bleed cooling system. Start engine and inspect for leaks.

Nov 25, 2009 | 1998 Ford Taurus

1 Answer

How to remove and refit a golf radiator


  • Drain coolant from bottom hose through a valve
  • Disconnect coolant hoses from radiator
  • Remove front body section and move lock carrier to service position
  • Remove retaining clamps from A/C hoses near condenser
  • Unbolt A/C condenser from radiator and support condenser with wire or heavy duty tie wraps Note: Do not discharge the A/C refrigerant. Support the A/C condenser with wire and avoid stretching or kinking the hoses.
  • Remove radiator mounting bolts from both sides and slide radiator slightly to the rear
  • Remove radiator and fans together from below
  • Installation is the reverse of removal

Oct 03, 2009 | 2000 Volkswagen Golf

1 Answer

How do i replace the radiaor? on this 2005 Hyundai do i remove the intake cover, then the cooling fan, the the motor mount? what?


Below are instructions and a diagram for removing the radiator from your Santa Fe. There's nothing involving the motor mounts. Best of luck and please post back with any questions or just to rate the solution. Greg

  1. Drain the cooling system. Remove the radiator cap to speed draining.
  2. Remove the inlet hose from the radiator.
  3. Remove the transmission oil cooler lines from the retainer clip at the bottom of the cooling fan shroud.
  4. Remove the fan shroud clip from the condenser tubes.
  5. Remove the bolt that connects the fan shroud to the condenser hold down bracket.
  6. Remove the air deflectors from the top of the radiator.
  7. Remove the cooling fan shroud bolts.
  8. Remove the coolant reservoir hose from the radiator overflow neck.
  9. Remove the radiator upper support brackets and bolts that connect to the fan shroud.
  10. Disconnect the engine cooling fan motors electrical connectors.
  11. Remove the cooling fan motors electrical harness from the fan shroud clips.
  12. Remove the cooling fan shroud.
  13. Remove the outlet hose from the radiator.
  14. Disconnect the transaxle oil cooler pipes from the radiator.
  15. Tilt the top of the radiator rearward.
  16. Remove the condenser hold down bracket from the radiator.
  17. Lift the condenser from the mounting tabs on the radiator and position the condenser aside.
  18. Remove the radiator.
6db9db4.gif

Aug 11, 2009 | 2005 Hyundai Santa Fe

2 Answers

How to replace a radiator in a chrysler concorde 1998 3.2


drain radiator.. remove upper and lower radiator hoses ,,remove transmission lines..remove bolts from cover on top of radiator.. lift out radiator.

Dec 06, 2008 | 1998 Chrysler Concorde

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...