Question about 2007 Honda Odyssey

Open Question

Code P0966 Honda Odyssey 2007

Where is Transmission control solenoid A located on engine/transmission?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 43 Answers

SOURCE: Transmission fluid/filter change in 2000 Honda Odyssey

I would not recommend using Dexron III. Honda Odysseys are prone to transmission problems. A drain and fill with Genuine Honda Fluid is Recommended. The drain plug can be removed with a 3/8 ratchet at the bottom of the trans. The fill hole is at the top of the trans. You remove it with a socket on a long extension. The capacity is close to 3 quarts

Posted on Apr 07, 2009

Ad
emissionwiz
  • 76132 Answers

SOURCE: 2000 Honda Odyssey - P1739

P1739 Automatic Transaxle Concernsthis is from the Honda manual, what does this mean? it means there is an electronic shift solenoid fault in the transmission and it need to have the Honda dealer hook up there dealer only test equip to pin down the exact issue with the trans controls.

Posted on May 20, 2009

techbuster
  • 5081 Answers

SOURCE: 2007 honda odyssey oil change and

Have supplies ready(long stem funnel to reachfill hole, 4 qts honda genuine atf-z1, rags for drips)
1. First, park the car while its hot on a flat surface and turn the engine off. Locate the yellow transmission dipstick and remove it and wipe it clean.
2. Look for the the ATF fill plug and washer(below and to the left of the brake fluid reservoir) 17mm marked "ATF" and remove it.
3. Locate the drain plug(not the one on pointing towards the drivers front tire but its located on on the drivers side of the transmission pointing towards the passengers side and lying horizontally) and remove it along with the washer. Its blue and is a standard 3/8 square drive plug and remove it. Drain completely. (wait 15 min or so until ALL is gone and replace the plug after throughly cleaning the magnet that is attached to it).
5. Replace atf fluid(honda says 3.3 qts- but mine took 3.8 to bring to first hole in dipstick level-check while running(use honda z-1 fluid only-yes- its expensive).
6. Replace fill bolt and washer and tighten.
7. Replace dipstick, let engine get hot and recheck. Recheck again after driving a day or so.
Your done-good work, you saved a $100 dollars...

It can be changed for every 60000 miles..

Posted on Dec 19, 2009

ftw1952
  • 10319 Answers

SOURCE: 1999 Honda Accord have a code p0730 all solenoids

Down load a service manual for your vehicle from this website


http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

Posted on May 02, 2010

  • 17 Answers

SOURCE: Does the 2007 honda crv have a transmission Filter?

no the cr-v does not have a replaceable filter check the owners manual for the recomended fluid and capacity

Posted on May 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Got p0748 p0108 code on my 04 honda odyssey. Car sat for about one year. Replaced fuel pump yesterday and it started right up. Can I get info on locations of where sensors are?


PO 748
service the transmission .....check solenoids

- Dirty transmission fluid - Low transmission fluid level - Faulty line pressure solenoid valve 'A' - Line pressure solenoid valve 'A' harness is open or shorted - Line pressure solenoid valve 'A' circuit poor electrical connection

Read more: http://www.autocodes.com/p0748.html

P0108
is the code for a problem with the MAP electrical circuit sensor having too high voltage input to the Engine Control Unit (ECU). This means that the voltage input to the ECU is too high and that it is not in the correct range for proper engine operation to work with inputs from the Mass Air Flow Sensor (MAF) and Throttle Position Switch (TPS). P0108 OBD II Trouble Code Manifold Air Pressure MAP Barometric Pressure...


odyssey map sensor is on the throttle body

Map sensor


26349763-lyuervfxp0xfzshzuykucxk0-2-0.jpg

Nov 10, 2016 | Honda Cars & Trucks

1 Answer

Had starter replaced yesterday now tcs and check engine lights on and the d is flashing hooked up code reader and got code p0798 whats that how do i fix.not having this problem till fixed starter


- Low transmission fluid level
- Dirty transmission fluid
- Faulty pressure control solenoid valve 'C'
- Pressure control solenoid valve 'C' harness is open or shorted
- Pressure control solenoid valve 'C' circuit poor electrcial connection

Read more: http://engine-codes.com/p0798_honda.html#ixzz3YiQY8JvC

The Engine Control Module (ECM) uses signals from the vehicle speed sensor to detect the actual gear position (1st, 2nd, 3rd, 4th or 5th gear). Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical troubles of the shift solenoid valves and valve body.

Read more: http://engine-codes.com/p0798_honda.html#ixzz3YiQOwwGc

Apr 29, 2015 | 2004 Honda Odyssey

1 Answer

What is honda diagnostic code P780


Code 780 means the transmission is not responding to the control module signals. In most cases the problem is a valve body, solenoid, or other mechanical component.

Jul 17, 2014 | 2001 Honda Odyssey

1 Answer

P0740 honda odyssey


P0740 Honda - Transmission Lock-Up Control System Fault Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness is open or shorted
- Torque converter clutch solenoid valve circuit poor electrical connection

Tech notes
On some Honda vehicles the P0740 code may be set by an overheating torque converter problem which is caused by an insufficient flow to the torque converter release circuit.

P0740 Honda Description
The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

Dec 04, 2013 | 2000 Honda Accord

1 Answer

I just got my car scanned and a few codes pop up


Error Code: P0130
Fault:
Oxygen Sensor (O2S) 1, Bank 1 - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
-Wiring harness.
-Oxygen sensor (O2S).
-Engine control module (ECM).

Error Code: P0505
Fault:
Idle Speed Control (ISC) System - Malfunction
Possible Cause:
-Wiring harness.
-Idle speed control (ISC) actuator/Idle air control valve (IAC) valve.
-Throttle motor.
-Throttle valve tight/sticking.
-Engine control module (ECM).

Error Code: P0100
Fault Location:
-Mass Air Flow (MAF) Sensor/Volume Air Flow (VAF) Sensor - Circuit --Malfunction
Possible Cause:
-Wiring harness.
-Mass air flow (MAF) sensor.
-Volume air flow (VAF) sensor.
-Engine control module (ECM).

Error Code: P1491
Fault:
Exhaust Gas Recirculation (EGR) Valve Insufficient Lift
Possible Cause:
-Wiring harness.
-EGR Valve.
-ECM

Error Code:P1607
Fault:
-Engine Control Module (ECM)/Powertrain Control Module (PCM)

Error Code: P0966
Location:
-Pressure Control (PC) Solenoid B - Circuit Low
Possible Cause:
-Wiring short to earth.
-Pressure control (PC) solenoid.
-Engine control module (ECM)/Powertrain control module -(PCM)/Transmission control module (TCM) .


Apr 30, 2013 | 2004 Honda Civic

1 Answer

P1740 code came up on my 2002 honda odyssey slipping going into upper gear should i replace shift solenoids and if so which one or ones


YOU NEED A TRANSMISSION REPAIR MANUAL. OR SOME TIMES SINCE YOU HAVE TO GO TO DEALERSHIP TO BUY THAT PART.THE PARTS DEPARTMENT SALESPERSON WILL SHOW YOU ON A COMPUTER THE PARTS LOCATION FOR SHIFT SOLENOIDS OR SHIFT SWITCHES ON THE TRANSMISSION VALVE BODY.

Apr 13, 2011 | 2002 Honda Odyssey

1 Answer

I have a 20001 Odyssey with 70,000. The check engine light and TCS light both came on. The TCS light has since gone out but the check engine remains. I went to an auto parts store and their computer came...


unfortunately it is. Contact your local dealership to see if it may still be covered under a warranty or not.

Customer Concern: The check engine light is on with the trouble code P0740 present. Tests/Procedures: 1. Test drive the vehicle and watch the tachometer. See if the automatic transmission locks up. If unable to see the RPM change, and the Engine Control Module (ECM) is turning on the lockup solenoids, then the problem has to be internal to the transmission. The transmission has an extended warranty from Honda for 7 years or 100,000 miles. Potential Causes: Automatic Transmission
Lock-Up Solenoid
Torque Converter
Tech Tips: TSB #02-062 Diagnostic Codes: P0740

Oct 10, 2009 | 2001 Honda Odyssey

2 Answers

2000 Honda Odyssey - P1739


P1739 Automatic Transaxle Concernsthis is from the Honda manual, what does this mean? it means there is an electronic shift solenoid fault in the transmission and it need to have the Honda dealer hook up there dealer only test equip to pin down the exact issue with the trans controls.

May 20, 2009 | 2000 Honda Odyssey

Not finding what you are looking for?
2007 Honda Odyssey Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...