Question about 2003 Chrysler Sebring

1 Answer

2003 chrysler sebring radio power locks and trunk

I need to know what fuse is for these three devices thank you in advance

Posted by on

  • Thomas Johnson
    Thomas Johnson Jul 25, 2013

    update: My horn, dome light, raidio, power locks, and trunk release do not work what do i need to do??

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 1,975 Answers

2003 chrysler sebring radio power locks and trunk  - 0dca3b02-2ac7-4340-af52-b9b4b8689b6d.jpgThis is the fuse panel inside the vehicle on the left side of the end of the dash. I think you have to open the door in order to see the cover to expose the fuses. The fuse I have marked is the only fuse I see in all the wiring diagrams for the circuits you described. hope this is it and a simple fuse change corrects the problem for you.

Posted on Jul 25, 2013

  • 1 more comment 
  • Thomas Johnson
    Thomas Johnson Jul 25, 2013

    Thank you so much that was exactly it.. the other night the car would not start we thought the battery was dead but when we went to turn it over it gave us a no bus code in the odomiter so we took it to a garage and they said our computer was dead so almost three hundred dollars later we got it running but to my suprise the radio, horn, trunk, and dome light did not work still the guy at the shop said it was because the computer they got was from the junk yard and some things just wernt going to work right and that there was another computer that might be bad because he already checked all the fuses in the car well he missed this entire set wow not going there again

  • Clifford Beard
    Clifford Beard Jul 26, 2013

    I would put money that they didn't even put a computer in it. I say this because really no good shop would go to the junk yard but besides that your vehicles computer would have to be what we call flashed to your VIN as well as the security would have to be programmed including each key. Your vehicle you just can't replace the computer and it runs. Just out of curiousity, did he say he needed every key you had for the vehicle ? If he didn't and you had other keys and they still start the car than I am 100 percent sure the computer wasn't replaced new or used. Your keys have a "chip" in them and they need to be programmed. I may be way off and they did do it and asked for the keys and flashed it but it does take some expensive diagnostic equipment in order to do this easpecially a Chrysler. I have been in the businees for 25 plus years. Don't know it all and never will but this is why my business is so hard cause so many people get ripped off because they don't know any better. I hope you didn't get ripped off but like I said am curious about the key thing which would be my way of knowing. In any case glad it was just a fuse and everything is going now.

  • Thomas Johnson
    Thomas Johnson Jul 26, 2013

    Thank you sir for your input on this situation.. he told me he was going to a junk yard because the new part would have been upwards of six hundred dollars.. he did not ask for all of my keys but he had my only one.. idk what eles it couild have beed if it wasnt that my wife just told me that when she got to the car after work it was dead she had left the lights on and a guy came to jump it but crossed the cables and she said something was smoking so i checked the fuses I knew of and they all looked fine so that is when i took it to Daves Auto in Warren PA. and he had it for a few hours and told me that it was the cpu... idk this makes me angery i wish there was a way for me to find out if the computer was really changed

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rockitman187
  • 2559 Answers

SOURCE: I'm having problems with my radio,interior dash lights, dome light, electric locks,horn,and electric trunk.

Under the hood on the fender well,Big black fuse box.Fuses are marked on the cover.

Posted on Jun 02, 2009

Mr Repair
  • 10 Answers

SOURCE: Remote car door opener got wet and won't work

Well first open it up completly. Remove the battery. Get a hair dryer and dry it out completly. Then let it stand for several hours to cool down. Make sure that the contacts where the battery fits are clean of any rust, or corrosion. Now install a new battery. It should work.

Posted on Jul 09, 2008

  • 49 Answers

SOURCE: where is the radio fuse located on 2003 chrysler T&C

According to the Haynes repair manual: "There is no fuse and relay box inside the passenger compartment.  However, there are a number of fuses, relays and circuit breakers in various locations under the dash.  The heated mirror circuits and the circuit for the lower instrument panel power outlet (in the floor console) are fused with self-resetting fuses that are only serviceable by an authorized dealer."  However, in the fusebox under the hood (a.k.a Integrated Power Module) there is a fuse RDO/IP IGN which is the fuse for the radio.  Check this fuse.  Both the radio and the Cigar Lighter are fused through the IPM.

Posted on Jan 25, 2009

  • 1 Answer

SOURCE: I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING

me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...

Posted on Jun 24, 2009

  • 1 Answer

SOURCE: 1998 Chrysler Sebring Car Stereo Radio Wiring

i have a 1997 chrysler sebring LX Coupe and i can't figure this out i got a aftermarket jvc cd player and i got the wiring harness for my car chrysler and i am not getting any sound please help me

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Okay so, i have a 2003 chrysler sebring, sedan 2.7L .. it all happened when i went to change my deck(the radio) for an after market one but noticed i didnt have the right cords.. so i just put the new deck...


So the plugs just matched or you cut a bunch of wires? Sorry to say, But the factory stereo has a data wire/s that interacts with all the computers on the car. You put voltage(12) to these wires (because there are a couple of them) And you blow circuits in other computers.

Dec 29, 2014 | 2003 Chrysler Sebring

1 Answer

Where is the fuse located for the trunk on a 2005 Chrysler Sebring


Fuse box is under the hood. You will have to remove the fuse box cover - and the label for which fuse is in which slot is on the inside of the fuse box lid.

Jun 04, 2014 | 2003 Chrysler Sebring

1 Answer

Dash gauges not working and the door lock and unlock doesn't work all at the same time


Sounds like one of the fuses. If you checked the ones in the dash, there are more in a box under the hood. You can find a lot of answers at the "Chrysler Sebring Convertible Club" on-line since they share the electronics with the sedan.

Sep 26, 2012 | 2000 Chrysler Sebring

2 Answers

Locked keys in trunk 2000 sebring how can i get to them


Here is how I done it with my 2002 Sebring LimitedIf the car has a release button on dashboard but you don't have keys to turn on ignition, (they locked in trunk) remove fuse cover (end of dash drivers side) remove fuse marked for dash lights and PRND1234 leave for 2 or 3 min then while holding trunk release button re-insert fuse and trunk release should work

May 09, 2010 | 2005 Chrysler Sebring Conv

1 Answer

I think I locked my keys in my trunk of my 2004 chrysler sebring convertibile? How can I get the trunk open. The trunk release button on the inside does not work.


Does the back seat fold down? If so you may be able to get into the trunk from the back seat. Check to see if a fuse is blown for the remote trunk latch. The owner's manual should help to see if there is a fuse for it.

Oct 17, 2009 | 2004 Chrysler Sebring

2 Answers

No power to interior lights, nopower to the radio, no power to the trunk, all amp fuses are not broken please respond.


conv, coupe, sedan? engine size????????? which lights, what in the trunk has no power????? which radio wih amp/ without amp/ cd???? which fuses have you checked, how did you ck them? are they getting power or not? ck fuses 20 22 23. if number 23 has no power ck ignition switch.

Sep 18, 2009 | 2004 Chrysler Sebring

2 Answers

I'm having problems with my radio,interior dash lights, dome light, electric locks,horn,and electric trunk.


Under the hood on the fender well,Big black fuse box.Fuses are marked on the cover.

Jun 02, 2009 | 2004 Chrysler Sebring

1 Answer

I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING


me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...

May 30, 2009 | 2004 Chrysler Sebring

Not finding what you are looking for?
2003 Chrysler Sebring Logo

863 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...