Question about Cars & Trucks

Open Question

Mitsubishi ml triton rear brakes

How to adjust handbrake on 2008 ML triton

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22246 Answers

SOURCE: handbrake adjustment?

you havent set the rear brakes up properly,slacken off handbrake cable first,remove the rear shoe any side first or both together ,firstly with a small angle grinder flaten the lip thats built up around the edge of the drum ,taking care not to catch the shiney facing.then look at at the handbrake pulling arm and make sure it right the way back onto the shoe .Next the hard part and this is adjusting the the automatic adjuster till as you put drum on their is a slight resistance sliding over shoes but the drum turns with a slight resistance and a bit of noise where the shoes are just catching,Do both side sides and adjust handbrake till you have 3 notches (clicks) .check wheels still turn ok with a slight noise of the shoes dragging .Now footbrake should be firmer and this car will lock back wheels up at 30mph ,and bounce out the brake tester at the annual mechanical inspection

Posted on Feb 04, 2009

Ad
  • 178 Answers

SOURCE: how do i adjust the

theres only two places a adjustment would be the easest way is to lift your handbrake three clicks either under the handle you will see a nut on a threaded bolt turn the nut in until the slack makes tighten hard dont over tighten push button drop handle back down now if the adjustment nut is not under the handle under the car you will see your rear cables going into a single cable all three joined by a adjustment bolt with nut hold with pliers three clicks up on handle turn nut in till slack is gone drop handle back down

Posted on Sep 13, 2008

Big Poppa Ma
  • 302 Answers

SOURCE: how to reset maintenance service indicator 2008 ML 320 CDI?

you could try unpluggin the negative battery cable from your battery for five minutes so it resets the computer

Posted on Dec 06, 2008

  • 5 Answers

SOURCE: replace rear brakes adjust handbrake

The hand brake hardly ever needs ajusting. See your hand brake mechanincly spreads your rear brake shose inside the drum. Therefore just replace your rear shoes and make sure there ajusted right and you should have no more problems with that part of your car. PS make sure you put some 3M paste on the contact points on your backing plate to avoid a squeak in the near future.

Posted on May 16, 2009

  • 1 Answer

SOURCE: handbrake adjustment required[rear brakes

hanbrake adjustment found and adjusted.

p.s not very impressed with your website or answers ,I could have been stranded on the road for all you care.

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Whats involed when installing a nudgr bar on a ML triton


seriously, is that installing a nuget bar on a triton? Give a better picture to the problem. WE can't read minds.

Aug 02, 2008 | Mitsubishi Pickup Cars & Trucks

1 Answer

How to adjust handbrake cable on touareg


Hi. This system is self adjusting. If it needs an adjustment then this normaly indicates that there is a problem that will need repair.

Apr 10, 2014 | 2008 Volkswagen Touareg

1 Answer

Mitsubishi ml triton


go to www.automecanico.com translate this web with your browser and fix it.
God bless you

Jul 25, 2013 | Cars & Trucks

1 Answer

Handbrake adjustment on 2009 Suzuki SX4


RTM?
https://suzukipitstopplus.com/category/3-suzuki-service-manuals.aspx

Feb 23, 2013 | 2008 Suzuki SX4

1 Answer

What maintenance needs to be done at 30,000 miles


general service oil,oil filter, air filter, fuel filter plugs leads and cambelt also check over brakes, handbrake discs and pads, adjust handbrake check accelerator cable etc

Apr 01, 2010 | 2008 Kia Spectra5

1 Answer

How do i tighten the handbrake on my mitsubishi triton ute 1994 4wd


Hi,
Inorder to tighten it you need to check to see if the side that is not holding if the primary shoe that the handbrake cable pulls on. If not then you may need to adjust the adjuster at the shoe. It may be too far retractor so when the handbrake is engaged, the shoe is not coming out far enough to grab the inside of the drum. There is most likely nothing wrong with the cable. You just need to adjust the shoes. When you pull the wheel off and inspect the shoes, you will see if they are not worn. To use the adjuster, pull see it will be near the retainer spring, the spring will connect from the top and bottom of the shoes to retract them. On the top side, where the upper spring is will be the mechanical adjuster, where you can adjust out the shoes to make them grab accordingly when engaged.

Let us know if you were looking for something more else please accept the suggestion.
Thank You for contacting Fixya.com

Feb 12, 2010 | Mitsubishi Pickup Cars & Trucks

1 Answer

How to adjust handbrake cable


HANDBRAKE CABLE ADJUSTMENT

1. Raise the vehicle and release the handbrake.
2. De-adjust the handbrake cable.
  • Remove the locking pin.
  • Slacken the adjuster locknut.
  • Slacken the adjuster until the levers on the callipers have returned to their stops.
3. Paint alignment lines on the lever and caliper
4. Tighten the adjuster until the caliper levers move from the alignment lines.
5. Apply the handbrake to equalise the cable.
6. Tighten the adjuster locknut to a minimum of three clicks and a maximum of six clicks.
7. Fit a new adjuster locking pin.
8. Lower the vehicle.

Jun 04, 2009 | 2002 Toyota MR2 Spyder

1 Answer

How to adjust handbrake 2001 hyundai grandeur xg


remove back wheels with screendriver adjust handbrake remove rubber plug from disc brake rotate disc brake down and look inside the disc with light;ask other people with ML (mercedes) ,JEEP,GM

Feb 26, 2009 | 2001 Hyundai XG300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

738 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...