Question about 2006 Hummer H3

Open Question

Radiator removal for 2008 Hummer H3 - 2006 Hummer H3

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

carputers
  • 255 Answers

SOURCE: 2008 Hummer H3 The trackion failed light on

clean abs sensors at each wheel.

Posted on Sep 08, 2009

  • 507 Answers

SOURCE: oil filter part number hummer h3

K and N site part nos ...h3 k33hp2006..........h2k33hp1007,look on the site depends on engine,but good info,Kand N seems good enough,especially with High Perfrmance bikes, MX etc

Posted on Nov 05, 2009

  • 474 Answers

SOURCE: hummer H3 (2008) does not start and error message

your anti theft is activated. consualt owners manual

Posted on Nov 28, 2009

  • 2309 Answers

SOURCE: How often do i need to change my oil in my 2008 h3 hummer

follow the owners manual, usually 3 to 5 thousand miles, oil does not go bad but it absorbs contaminants, and can only do so much, also check any filters

Posted on May 05, 2010

  • 1 Answer

SOURCE: 2006 H3 Hummer fan problem

Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My hummer h3 2008,the oil pressure lindicator


The engine will shut down to protect itself,check the oil level and see whether the car has oil.The light comes on if the oil level is low or the oil pump is not pumping any oil.I replaced my engine hummer h3 two weeks ago due to a malfunctioning oil pump.Check if you oil pump is not malfunctioning.Good luck hope you have not damaged anything further like the bearings due to lack of oil.

Sep 17, 2014 | 2008 Hummer H3

1 Answer

Where is the inside fusebox located on a h3 hummer


The hummer H3 has only one fusebox which is inside the engine compartment behind the battery

May 22, 2014 | 2008 Hummer H3 Adventure

1 Answer

Were can i buy harness for hummer h3 2006 for blower motor resister


You could go to a wreckers or to a GM stealership however this problem with the harness burning is very common and a new harness will eventually burn up like yours now. I would just do the fix detailed in the link below. I followed the steps for my hummer an it was very easy. http://www.hummerforums.com/forum/hummer-h3-17/ac-blower-fix-19208/

Nov 25, 2012 | 2008 Hummer H3

1 Answer

Heater motor not working 2006 H3 hummer


Here is a link to the step by step instructions for the fix. Easy to do. I had the same problem with my 06 H3 and fixed it myself and saved some serious $$$ http://www.hummerforums.com/forum/hummer-h3-17/ac-blower-fix-19208/

12_22_2012_11_57_56_am.jpg

Nov 25, 2012 | 2008 Hummer H3

1 Answer

Where is the thermostat on a h3 hummer located ?


Follow the top radiator hose to the engine block. The thermostat sits under the housing that the radiator hose connects to. There should three bolts holding down the housing and it's easy to remove.

Jan 10, 2010 | 2006 Hummer H3

1 Answer

Remove dvd headrest and wiring to install in another hummer


how toremove a dvd headrest from seat in a H3 hummer 2007

Dec 13, 2009 | 2008 Hummer H3

1 Answer

Oil filter part number hummer h3


K and N site part nos ...h3 k33hp2006..........h2k33hp1007,look on the site depends on engine,but good info,Kand N seems good enough,especially with High Perfrmance bikes, MX etc

Nov 05, 2009 | 2008 Hummer H3

1 Answer

2008 Hummer H3 The trackion failed light on


clean abs sensors at each wheel.

Sep 08, 2009 | 2008 Hummer H3

Not finding what you are looking for?
2006 Hummer H3 Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...