Question about Acura TL

Open Question

Power steering not working at idle - TL Acura Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine stalls when turning


This car have 3 associated power switch for the power steering
power steering pressure switch. (Idle) speed power steering Cut-Out Switch and (Idle) pressure switch. Please check them.

Good Luck

Dec 19, 2013 | Chevrolet Cars & Trucks

1 Answer

98 freelander stalling fault


Explore the problem to see if its the power steering, or physical steering or engine:
Does it stall when its in neutral and you go to full lock?
If so its the power steering, or the engine isnt ticking over fast enough to generate the extra pump pressure needed when on full lock. Check pump belts are good and tension is correct. Then buy a used idle valve and swap it out.
Also do basic checks to see if wheels are catching on some part of car. Jack it up so front wheels are off ground, on full lock in neutral do the wheels turn freely, or catch on something? Slowly lower the vehicle down and check same as you do it. When its down put it in gear and see if it stalls.

Dec 15, 2013 | Cars & Trucks

3 Answers

1997 monte carlo ls steering wheel vibrates when idle


Go check your power steering fluid level and watch belt turn at idle to see if it is tight and turning smoothly.Pulley could be giving resistance.mAYBE BAD POWER STEERING PUMP OR LEAK.

Nov 27, 2012 | 1997 Chevrolet Monte Carlo

1 Answer

Power steering does not work at low rpm


What is the idling RPM of the engine when this is happening? There are many different types of power steering systems out there these days on vehilcles. It would make it a bit easier if we had a little more information before we give you advice. Year, Make Model, Milage, ect...Any other known issues with vehilce? Yes, the most likely culprit could be the pump because as time goes on the internal pump compoinents start to wear down and the tolerances become to great and at low rmp it cannot keep the proper pressure needed to give adequate power assist to the steering gear.
Hope this helps
Sincerely'
Roger

Feb 07, 2012 | 2000 Chevrolet Impala

1 Answer

Car stalls after turn or idle


Q; Is your service engine lamp on? This vehical has a power steering pressure switch,witch helps your engine maintane idle at parking lot monuvers. its next to your power steering pump.you can check if it works by starting your engine and let it warm up. then without tuching your gas pedal turn your steering wheel slowly , the engine should maintane its idle. if this works and your service eng. soon is not on then try cleaning your throttle plate. A dirty throttle is alot of stalling causes with all vehicals.

Jan 18, 2012 | 2000 Ford Focus

3 Answers

Power steering pump replaced, start to work ok, after 10 milles driving, steering wheel is hard, like pump is not working, under hood everything look ok.


YOU HAVE AIR IN THE POWER STEERING SYSTEM.YOU NEED TO BLEED POWER STEERING PUMP FIRST BEFORE DRIVING VECHICLE.CHECK POWER STEERING FLUID LEVEL ADD MORE POWER STEERING UNTIL REACH FULL COLD MARK..RAISE VECHICLE FRONT WHEELS OFF THE GROUND.START ENGINE LET IT IDLE WHILE TURNING STEERING WHEEL LEFT TO RIGHT NON STOP DONT LOCK OR STOP STEERING WHEEL KEEP TURNING IT SEVERAL TIMES CHECK POWER STEERING FLUID IF LOW ADD UNTIL YOU GET COLD MARK ON DIP STICK DONT OVER FILL POWER STEERING PUMP BLOW A SEAL.IF POWER STEERING FLUID LOOK TAN COLOR SYSTEM FULL OF AIR.TURN OFF IGNITION LET CAR SET FOR A WHILE CHECK FLUID LEVEL.IF STEERING WHEEL FEEL STIFF HARD TURNING DONT DRIVE CAR UNTIL YOU HAVE NORMAL STEERING.IF STILL HAVE AIR IN SYSTEM BLEED SYSTEM UNTIL AIR IS OUT.

Feb 25, 2011 | 2002 Chevrolet Avalanche

1 Answer

My 1996 nissan sentra runs good but when i come to a stop and turn steering wheel the idle drops and stalls a little , almost shuts down . Is there a quick solution ?


sounds like your power steering idle up switch is not working. Rpms should go up when you used your steering. Rhere is a switch built into the power steering system to raise rpms when you are turning steering wheel. It looks like it has a problem.

Jan 25, 2011 | 1996 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...