Question about Cars & Trucks

Open Question

Replacing mercedes benz c230 1998 front crankshaft seal

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 702 Answers

SOURCE: mercedes benz 230 w115

If it's the front seal, You have to remove the yoke and pull old seal out and tap in a new one. If it's the cover seal, remove bolts, drain fluid, clean off old gasket, install new gasket with a film of sealant and re-install.

Posted on Jun 12, 2008

  • 408 Answers

SOURCE: how do you remove the center console in a 1982 Mercedes benz 380S

hi,center console or center gear lever cover(wooden console)

  • remove radio,then remove control unit of aircon by pressing down the 2 latch,located in upper edge in radio hole.remove screw in upper part of console
  • remove black cover (look like astray)fold both side,remove screw
  • remove shifting lever
  • try to lift in the console,be careful,sometimes sticky

Posted on Mar 22, 2009

  • 75822 Answers

SOURCE: Mercedes-Benz Transmission Fluid question

the transmission on your MB is sealed with no way to check the trans fluid level,(no dipstick provided for) that is why the report says "sealed". MB did this to stop customers from overfilling there transmissions, which can cause severe damage if not done properly at the correct fluid temp, this requires special test scan tools.

Posted on Mar 30, 2009

  • 11 Answers

SOURCE: replacing the battery in a 2001 mercedes benz

Battery base has a device that clamps the battery on a step/notch on the side. Use a ratchet with an extension to loosen. Once it is loose you can remove the battery.

Posted on Apr 03, 2009

  • 6826 Answers

SOURCE: how to replace Honda front Crankshaft Seal

Have to take off the crankshaft pulley to get at the Crankshaft Seal.

Use a hooked seal remover to dig in and pull the seal out without damaging sealing surfaces.

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is crankshaft located on Mercedes e200, 2007?

if you seriously do not know where the crankshaft is on an engine then you will never have the skill to replace it. how do you know it needs replacing? It will mean a major overhaul of the engine which is very very costly and will need to be carried out by an engine reconditioning shop

Oct 03, 2012 | 2007 Mercedes-Benz E-Class

1 Answer

Sporadic oil leak

where if you spotted the leak comes from? If it comes from top side check whether the rockers cove gasket needs replacement.
If it is from the side of inlet manifold check whether the breather pipe either is hard and cracked and especially leaks when you have long distance drive and the oil that time is very thin and find the easiest place and weakest to leak.If is from front check the front crankshaft seal or the timing cover gasket.If is from rear check the rear crank shaft seal or the sump gasket or the automatic transmission - if it is- gasket or the side plug O rings. I hope that helps you.

Aug 10, 2012 | 1995 Mercedes-Benz E-Class

1 Answer

Adjustable Camshaft timing solenoid

In this case the solenoid needs to be replaced.The error code in this case is P1533.This code is many a times noticed on Mercedes Benz.
Click this link to go through the replacement procedure of adjustable solenoid:-----
-----------Also i recommend you to go through this additional help links for more help:-----Crankshaft and camshafts timing marks?
dual over cam timing mark details? to Inspect Camshaft?
camshaft Timing specifications?
Camshaft, Bearings & Lifters Replacing ? Damper Replacement? Position (CMP) Sensor replacing?
Crankshaft Front Seal?
How test cam shaft? Testing Car Camshaft?
Problem with cam synchronizer?
How to service Cam Shaft? Camshaft servicing?
How to replace Camshaft? Replacing Vehicles CamShaft Assembly? will help.Thanks.

Feb 16, 2012 | 1998 Mercedes-Benz C-Class

2 Answers

How to repair oil leak for 1995 C200 Mercedes Benz? Looks like the leak is dripping down from underneath the engine onto the oil drip pan.


May 30, 2011 | 1995 Mercedes-Benz C-Class

1 Answer

How to set the timing on a 1995 mercedes benz, Model C, CC Rating 1799, Engine no 11192022073897

rotate crankshaft to ot mark then find the 4mm hole on each cam pin it with a 4mm allen turn both cams outward till allens rest against head then grab the front of the exaust cam gear and ****** it you can do that by turning the front of the ex cam right 20 degreez

Aug 07, 2010 | 1995 Mercedes-Benz C-Class

2 Answers

I have oil leaking from in the front, bottom of my 1999 mercedes c280 sport car. what is the name of that gasket?

oil pan gasket is on the bottom, the one behind the crank pulley is the front crank seal

Feb 25, 2010 | 2007 Mercedes-Benz C230 Sedan

1 Answer

Oil filter location 99 mercedes s320

It should be on top of the engine, drivers side, under a black plastic cap in the front. These cars used a cartridge type filter, which is just the paper element and a seal ring.

Oct 26, 2009 | 1996 Mercedes-Benz Mercedes Benz S Class...

3 Answers

Crankshaft sensor Mercedes E320

i have mercedes 94 e320 was run ok .but after engine wash
first coil no sparking ,and a the second quit too ,running only whit the third coil ,,i changed all 3 coils but runnig a same,,no sparks on those front 2

Apr 22, 2009 | 2006 Mercedes-Benz CLS-Class

1 Answer

I Have an oil leak on front suspension, what could be causing this?

the only sure fire way to track down an oil leak is to have the engine steam cleaned or pressure washed and they drive it for a day and look for the leak, but it is likely that your leak is coming from the crankshaft front seal.

Apr 08, 2009 | 2003 Mercedes-Benz C-Class

1 Answer

Mercedes benz 230 w115

If it's the front seal, You have to remove the yoke and pull old seal out and tap in a new one. If it's the cover seal, remove bolts, drain fluid, clean off old gasket, install new gasket with a film of sealant and re-install.

Jun 11, 2008 | Mercedes-Benz 190-Class Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides