Question about 1996 Toyota Tacoma

1 Answer

Check engine light is blinking on 96 tacoma - 1996 Toyota Tacoma

Posted by on

1 Answer

What is the question?
Check lights have been on all
vehicles for 30 years,nothing
new there
I would assume you checked for codes
or a repair shop did & your on your way
to diagnosing the issue

Posted on Jul 25, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ourhowse
  • 2007 Answers

SOURCE: 96 Tayota Tacoma

1. air filter dirty. 2. bad engine ground. 3. fuel filter 4. loose connection in ignition system. 5.faulty idle control system.

Posted on Aug 30, 2009

  • 42 Answers

SOURCE: 2005 toyota tacoma check engine light

pull the E.F.I. fuse located under the hood on the drivers side, if there is more than 1 efi fuse pull them both along with the E.T.C.S. fuse (if there is one) for 1 minute or so. That should do it

Posted on Dec 23, 2008

  • 1 Answer

SOURCE: how to change the check engine light on a 2000 toyota tacoma

i had the same thing, i had it tested at auto zone and they said it was the obd2. i was told the o2 sensor was not a big deal so i reset the check engine light by holding down the trip meter button while starting her up and it has not been on since.

Posted on Jun 23, 2009

  • 2187 Answers

SOURCE: toyota tacoma 2003 check engine light is

If the car still runs then the problem is not major but may develop into one if unchecked. The sensors in the engine may have detected problems and should be stored in its ECU. If you have a scanner have it connected to the diagnostics it should give you a clue on what to check out.

Posted on Jul 08, 2009

Pointnino
  • 14 Answers

SOURCE: check engine light on 2003 toyota tacoma, O2 sensor?

An O2 sensor code is a tricky one. It could mean SEVERAL different things, and I know how bad it sucks to hear this, but your best bet is to take it in and have a diagnostic ran on it at either a dealer or a good mechanic shop with a computer they can hook up to it. I had an "O2" code come up a while back on another car I used to have, and literally spent weeks and hundreds of dollars trying to fix it, and never did. Finally out of desperation took it in, paid the $90, and they found the problem and fixed it in like 30 minutes. Something I would have never even thought of was causing it (can't remember off the top of my head). After that I stopped wating time and money on check engine lights. One comes on in my car, I take it to have it ran for free at and auto parts store just to make sure it's not a loose gas cap or something, just to get an idea of what I'm looking at, then go and make an appointment to have to hooked up to a diagnostic computer to track down the problem. Good luck, and hope this helps save you some time and money.

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinking check engine light 96 Toyota Tacoma


take it to auto zone and have the codes read they do it free . then get the problems fixed .

Nov 21, 2015 | Toyota Cars & Trucks

1 Answer

The engine light on my 96 merc cougar XR7 is on. Car shakes bad when i accelerate and engine light begins to blink. I'm embaressed to say my engine light has been on for sometime but was told it c


The check engine light needs to be addressed. Yes it could be a sensor but you need to know.
The light blinking means the problem is serious, such as a dead miss on one or more cylinders. The light being on means something is happening with the engine performance that could damage the catalytic converter.
Get the computer scanned - most auto parts stores will do it for free in hopes of selling you some parts. Once you have the codes research them online or here.

Sep 28, 2012 | 1996 Mercury Cougar XR7

1 Answer

96 Tacoma stalls when lights are turned on


check the voltage coming out of the alternater under load

Dec 11, 2011 | 1996 Toyota Tacoma

1 Answer

Oil light comes on


possible too much oil, drain all the oil out and put the correct amount back in and since you have the oil drained go ahead and change the oil filter.

Apr 17, 2010 | 2001 Toyota Tacoma

1 Answer

96 tayota tacoma, 2.7 4 wd, the engine is hard to start when the engine is hot. When cold the engine starts fine.


1. air filter dirty. 2. bad engine ground. 3. fuel filter 4. loose connection in ignition system. 5.faulty idle control system.

Aug 30, 2009 | 1997 Toyota Tacoma

1 Answer

96 Toyota Tacoma lacks take off power and stumbles


Any trouble light? Sounds like it might be misfiring during acceleration which is more related to ignition quality than timing. Check the spark plugs--if badly worn, replace them. Might need new spark plug wiring. Check the air cleaner. Replace the O2 sensor if the truck has a lot of miles. Look for loose or cracked vacuum hoses.

Jul 14, 2009 | 1996 Toyota Tacoma

1 Answer

96 tacoma, ran fine, parked it and now it won,t start. Has fuel, new fuel filter, new battery, acts like it wants to but will not completely fire up. HMMMM.


are you sure you getting fuel even though you have new fuel filter, check all fuses under the dash to fuel pump and relay under the hood, are you getting sparks? check rotor, cap, coil...make sure you getting 2 important items, gas and fuel to the engine. hope that help some

Jul 12, 2009 | 2001 Toyota Tacoma

1 Answer

How to change the check engine light on a 2000 toyota tacoma


i had the same thing, i had it tested at auto zone and they said it was the obd2. i was told the o2 sensor was not a big deal so i reset the check engine light by holding down the trip meter button while starting her up and it has not been on since.

May 25, 2009 | 2000 Toyota Tacoma PreRunner

1 Answer

96 Tacoma 4x4 2.7 engine cuts out randomly, like its trying to get air or fuel. just installed cold air intake, full tune up, fuel filter, mass air flow sensor, battery cable, hoses, tps(sensor), and...


dont look for air when the car cuts out its most likley spark or fuel when it cuts out ranomly its usually a sensor or relay that is faulty check fuel pump relay and camshaft or crankshaft sensors but first narrow it down to spark or fuel if possible also if check engine lite is on check codes

Mar 26, 2009 | 1997 Toyota Tacoma

Not finding what you are looking for?
1996 Toyota Tacoma Logo

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...