Question about Cars & Trucks

Open Question

John deere 5420 hydraulic power steering

My 5429 model 2004 has been sitting in a garage for 3 weeks. when i parked it, it worked fine. when i started it today the power steering and hydraulic lift and transmission would not work. i increase my rpm but it only jumped on hydraulic left. the power steering could barely move. what is wrong? i changed filter and the oil level is good?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 99 Answers

SOURCE: Sluggish steering - 2005 Toyota Sienna

You probably do have a power steering leak. Check the fluid again, it's most likely low if you are having an increasing problem with it. As the fluid is drained slowly through the leak it allows air bubbles to enter the system and cause it to become sluggish or sticky. Get the leak fixed asap so you don't spend a huge amount on fluid and keep an eye on the fluid level.

Posted on Mar 01, 2009

Ad
  • 5 Answers

SOURCE: loss of power steering

If memory serves me correctly... the 05 deville is equipped with "Magnasteer" the electical connector at the rack and pinion is not a pressure sensor unless its on the line itself. The system operates by inducing voltage to magnets in the rack to make turning easier at lw speeds while adding resistance at higher speeds for added control and less drift. Check for any codes on your climate control by pushing "off and warmer" at the same time with the engine off, key on. Google the codes and see if any relate to the steering system and repost! I hope that helps!

Posted on Jun 04, 2009

  • 434 Answers

SOURCE: 2004 Silverado Power steering

Pump is starting to fail. Good news is that it isn't too hard to change. Hope this helps...

Posted on Sep 08, 2009

  • 111 Answers

SOURCE: Front whine when turning left and at whine when

Whine usually occurs on tight turns maximising pump output and/or pump may be worn and needs replacement. Leakage can be from pump reservor,connection, or power rack and pinion steering assy. Spray off any area with a sign of fluid with a brake clean or carb. cleaner and look for signs of leakage.

Posted on Oct 08, 2009

pappapumpdaf
  • 635 Answers

SOURCE: Fuel probelms

Try hitting the brake off and on to see if the rpm changes when you do that with the car in park. If it does, you may have a ruptured brake booster. A fluctuating rpm while your car is in park with the brake on indicates a vacuum loss. Other things may cause a vacuum leak including the air conditioner controls inside the vehicle. Other things that cause this may be cruise control or your Air Conditioners high idle solenoid.

Posted on Jul 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Haudraulick problems on John Deere 3350


Try disconnecting a hose from the steer cylinder. Place the hose end in a 5 gal. bucket and see if you have flow from steer motor. turn steering wheel to the opposite direction of open hose fitting to check for steer cylinder piston leakage. Piston leakage will pressurize both directions of steer cylinder at the same time resulting in no steer. Be careful not to overflow your bucket. Reuse your oil if bucket is clean

May 21, 2017 | Cars & Trucks

1 Answer

Where is pto over temp relay or sensor located on x495 john deere diesel engine


I worked for Kubota for 10 years and I am not familiar with a PTO temp sensor, John Deere or otherwise. The PTO function has nothing to do with engine other than slight increase in coolant temp when the PTO is under a load. Check for correct Hydraulic oil level(dipstick or sight glass in transaxel) and make sure grass or trash is not packed around the hydraulic oil cooler in front of the radiator. Remove the screen and use compressed air to clean it often. Change hydraulic oil filters every 100 hours

May 21, 2017 | Cars & Trucks

1 Answer

Steering wheels makes vibration noise when turning wheel while in park


I'm thinking your power steering rack needs servicing! may be air in the hydraulic lines. did it start right after you replaced the pump? did you run the fluid resivour dry by any chance?

Jun 15, 2014 | 2002 Dodge Grand Caravan

1 Answer

My 2007 Jaguar xk has been sitting in the garage for about 2 weeks. Today I noticed the action with the steering wheel was a bit stiff. As I pulled out of the garage I noticed a fluid on the garage floor....


Hello
I do not think that there is any thing to worry about as long as you have no leak.
But if it happens again , you might want to check the steering pump , as it could be going bad and starting to get stuck

May 17, 2017 | Jaguar XK Cars & Trucks

1 Answer

There is no parking brake, and "park" does not hold. it is a 1990 cruise air lll on a john deere chassis with a ford 460 engine.


The parking brake is activated by the shift lever. There is no parking paw in the transmission on these John Deere Chassis motor homes. The parking brake is the type that works a brake on the drive shaft. I ran into the same problem and just put a line lock on the brake line.

Sep 01, 2010 | Ford E-350 Super Duty Cars & Trucks

3 Answers

2004 mazda rx8 power steering


The Mazda RX8 has electric power steering there is no fluid. You may have a problem with you electronic power steering control moduel, or the power steering pump

Jan 17, 2009 | 2004 Mazda RX-8

1 Answer

My 2004 dodge stratus won't steer


Well it's one of three things:
1. The fluid has leaked out and you should check for leaks and check the fluid level.
2. If the level is fine your power steering pump could be bad.
3. If the level is fine your rack and pinion could be bad.

Dec 31, 2008 | 2004 Dodge Stratus

2 Answers

Fluid check


The 2002 thru 2007 do not have the traditional hydraulic power stering unit that requires fluid. In these models, power assist is provided by an electrical power steering unit. Nothing to check there but the battery.

Jul 13, 2008 | 2004 Saturn VUE

1 Answer

Nissan Maxima car repair ripoff


I'm wondering if your injectors are leaking. If they are, and the car sits for a period of time like you're saying, fuel would puddle up and the car would run extremely rich until the excess puddled fuel burned off. Did you (or do you) notice black smoke from the tailpipe during the time the car is running really rough? Take a look and see - rev the engine if you need to, and see if you see some. It'd take a few minutes to burn off, and once it did, as long as the rest of the car is working right, you'd run normally. If you shut the car off for a short time (ie, getting gas, renting a movie) the car likely wouldn't sit long enough for enough fuel to puddle up for the condition to recur. If you park it overnight, that's plenty of time for the injectors to leak enough fuel for the car to run rough on startup.

No guarantee of course, but that's what sounds like a worthwhile investigation to me.

Jul 04, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...