Question about 2008 Saturn Outlook

Open Question

Location of 08 saturn outlook body control module

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: Installation Instructions for the Headlight Buld for 2008 Outlook

It is real hard to replace and some time the wiring harness inside of headlamp if burned if vehicle is still under 36000 miles take it to dealer to have repaired

Posted on May 12, 2009

  • 19 Answers

SOURCE: location of body control module on 2007 saturn ion

Bcm and fuse box are one piece, located in front of center console, just under the heater controls.  Remove side panels from console on both sides.

Posted on Aug 23, 2009

  • 543 Answers

SOURCE: body control module for 2003 saturn l300

the body control module or BCM is located on top of the inside of the glove box,remove the lower trim panel under the passenger foot well under the glove box,the the 4 screws that hold the glove box door on,,,then the screws that hold the box to the dash and the BCM is slid into the top of the box,,,,,,you are gonna need it programmed as it comes new blank,and the car will not start with out a program

Posted on Feb 27, 2010

  • 2 Answers

SOURCE: 08 saturn outlook headlight needs replaced

I was able to replace this bulb via the wheel well. There were 4 small screws holding the liner on. I was then able to bend the liner back + turn the light bulb dust cover and remove it. The bulb assembly also had to be turned to pull it out. I then removed the wireplug. My bulb was intact + the wire connecting to the bulb was the problem. I simply brushed off some of the carbon residue from the wireset overheating I reattached it + it worked long enough to buy a new wireset. I am very disapointed I had to do this basic repair on my fairly new outlook 500 miles out of a 36k warranty.

Posted on Jun 07, 2010

  • 1 Answer

SOURCE: bcm installation for saturn l series

The estimate for my 2000 Saturn LS-1 was around $500.00. I would suspect it should be around this much for your wagon since it is basically identical regarding the BCM. It is easy to get to the BCM so a relatively mechanically savvy person could change it on your own but it has to be programmed which will require the mechanic anyway.

The problem is that apparently, since Saturn has been dissolved the BCM's are getting hard to come by. The dealer is unable to order one for my car. You may have more luck with a 2003.

Posted on Jul 17, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is PCM located?

ECM= Body Control Module Can Be Found by battery, On The Back Of The Motor Above The Transmission
Where To Find The ECM Module 3 0 Litre Saturn Vue

Jan 28, 2016 | 2003 Saturn VUE

1 Answer

Bcm removal on 2008 saturn outlook

Component Name
Preliminary Procedure Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Body Control Module
  1. Disconnect the electrical connectors.
  2. Reprogram the module if replaced. Refer to Control Module References .
Push tab to release the body control module from the bracket.

Jul 22, 2015 | Saturn Cars & Trucks

1 Answer

Why do all my windows go down on my 09 Saturn Outlook and only go up with driver control?

go into the setting menu on the dash and make sure it has not been altered. there may be an internal fault with the auto express/window control module.

Feb 23, 2015 | 2009 Saturn Outlook

1 Answer

Saturn 2000 SL: won't start

The ignition control module ( Body Control Module ) is located above the glove box, you'll need to remove it , and its right there.

Sep 20, 2014 | 2000 Saturn SL

1 Answer

Lock pass system

These need to be checked:

Confirm the latest ignition switch is installed per TSB 04-08-45-005D.

2. Check the BCM PWR fuse.

3. If ok, check all of the door lock and unlock circuits for shorts to ground.

4. If ok, the Body Control Module (BCM) is defective.

Nov 16, 2013 | 2005 Saturn ION

1 Answer

Location of a MAP sensor on a 3.6L 2008 Saturn Outlook

It is attached to the throttle body of the intake manifold. See picture.

Jan 07, 2013 | 2008 Saturn Outlook

1 Answer

Ecu saturn ls1

it is not the ECU it is the body control module. it is located under the dash on the driver's side next to the steering coluum. it does need to be reprogrammed,but make sure the numbers match. all cars tday have a ECU.BCM.transmission module and alarm module and abs mudule

Dec 20, 2012 | 2000 Saturn Ls 4dr Sedan

1 Answer

Location of body control module on 2007 saturn ion

Bcm and fuse box are one piece, located in front of center console, just under the heater controls.  Remove side panels from console on both sides.

Aug 20, 2009 | 2006 Saturn ION

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

871 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides