Question about Cars & Trucks

1 Answer

What is the estimated cost to replace 2001 Rodeo muffler, 2 gaskets and flex pipe? 3.2l ?

Posted by on

Ad

1 Answer

No one has price info
This is a world wide chat room
Don't know what country your in
There are no set prices for any repairs
& parts
Always ask the merchant your having to the work

Posted on Jul 24, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
sparky1500
  • 1066 Answers

SOURCE: OIl leak in 2001 Grand Cherokee Laredo

valve cover gasket is like $20 and a do it yourself job, just buy a manual like a chiltons from an auto parts store. if it was valve cover, the smoke would be coming from engine, not tailpipe.

rear seal is in between engine and tranny, this would cause oil to leak on ground, but not to burn

if smoke is coming from tailpipe, your piston rings might be going bad. that is an expensive repair, but switching to synthetic oil may give you several more years of life out of the piston rings, synthetic oil has a way of soaking into bad piston rings and temporarily making them like new again, unless they are already too far gone.

Posted on Nov 28, 2008

  • 102 Answers

SOURCE: 2001 suzuki swift - thermostat replace?

Suzuki thermostats, more often than not, tend to fail OPEN when they have been overheated - which is a good thing! If they failed shut, you would really cook the motor. Change the thermostat. Also, find the cause of the initial lack of coolant.

Posted on Sep 21, 2009

ginko
  • 19396 Answers

SOURCE: What is the estimated cost

Hi,

The hourly price and time employed to replace the ball joints may vary.

In USA the price to replace the four ball joints ranges from about $500 to $1000 .


A single ball joint for discovery can cost between $35 and $80, depending on model.The set will be less expensive, costing between $100 and $150. Here a list: land rover discovery ball joints.

After replacing the ball joints, the mechanic must do alignment procedure. Depending on the garage, this may be billed separately.

Posted on Jan 14, 2010

  • 94 Answers

SOURCE: 1996 Nissan Maxima exhaust replacements

Yes you can obtain the parts from after market. The Flex Pipe is installed on all cars hows engine is built in transverse. if you accelerate the engine tries to turn against the crankshaft rotation. W/o flex pipe your exhaust will be broken after a couple of minutes. The flex pipe acts like an accordion and eliminates this small "turns".

Posted on Jan 27, 2010

  • 4 Answers

SOURCE: 2005 Ford Focus flex pipe repair

Advance auto and auto zone sell just the flex pipe. You will need to have someone cut the old one out and weld the new one in. costs about $20 for part vs $300 for pipew/catalitic converter attached.

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Cost to replace egr valve on a 2001 isuzu rodeo. The ECM has detected too much flow on the EGR system. How much will it cost to replace the ER valve on a 2001 Isuzu Rodeo


just went on line to rodeo egr valve and the price is around $345.00AUD. + labour to replace.Probably 75% that if in USA

Dec 25, 2014 | 2001 Isuzu Rodeo

1 Answer

Convert dual exhaust on 99 sunfire gt to single?


You can cut out the Y pipe and replace it with a flex pipe from parts store, then clamp each end of the flex pipe, the pipe diameter will be 1-7/8 or 2 inch, also for the pipe replacement piece would work from a sunfire or cavalier from 1995 and up, might need to replace the muffler strap too. as it can break from rusting, if not already rusted and broken.

May 28, 2013 | 1995 Pontiac Sunfire

1 Answer

2000 passat wagon flex pipe needs replacement. I bought a new pipe. Do I need to replace muffler too?


I just had both flex pipes changed at a Midas shop. Five hours labor and $115 for the parts. My muffler was fine.

Sep 17, 2011 | 2003 Volkswagen Passat

1 Answer

Exhaust Flex Pipe; How to replace?


You can change the entire section of exhaust pipe that the flex pipe is in. It's usually bolted to the catalytic converter, on the back end, and to the exhaust manifold at the front end. It's just a matter of unbolting it and bolting on the new section of exhaust with new gaskets. You could also go to a muffler shop and have them cut out the old flex pipe and weld in a new piece of flex pipe in it's place. It's for you to decide which option is best for you, and for your wallet.

Feb 24, 2011 | 1994 Toyota Camry

2 Answers

Broken flex joint on exhaust


it would be the front pipe you can buy new at about 200-300 hundred or go to auto parts and ask for a flex tube they have 3 or 4 different sizes from 1 and a half inch to 2 and three quarters of inch it should costs 40 to 60 dollars and if you can weld with a mig welder you cut the pipe as close to the flex or weld as possible then install the new part and weld it or if you cant weld and no money is loose buy muffler clamps and tighten them on the pipe new part or find one in scrap yard that is better if theres a problem ask me i have done many

Jan 06, 2011 | 2002 Hyundai Accent

1 Answer

2000 Toyota MR2 Spyder Pipe (from muffler) connected to 2 flex pipes is sheared off at connection to flex pipe. need schematic and how can this be repaired


Replace the entire section before and after the flex. Be sure to look into excessive engine movement, that may have caused this failure. Welds will fail again, quickly.

Sep 03, 2010 | 2000 Toyota MR2 Spyder

1 Answer

2001 Hyundai Sonata Exhaust Front Pipe


You may be able to get it fixed reasonably by a welder if the problem is weldable.

Jun 22, 2017 | 2001 Hyundai Sonata

1 Answer

Exhaust Pipe broke/Rust on muffler


Flex pipe will work, or if it's a straight section of pipe you can buy a universal piece of exhaust tubing with flared ends, trim off the rusty ends on your original pipe with a hacksaw or Sawzall and slip in the new section. Clamp it with 2 muffler clamps and you're set. Total cost should be under $40.

Apr 10, 2010 | 2000 Saturn L-Series

3 Answers

Exhast pipe where it is braided is loud how do you replace it


I have seen a lot of muffler shops or reg shops just weld that thing together to stop the leak, because it does wear out fast, it is a flex joint, I think to replace it it, you have to get the whole section of pipes, crossovers, etc, whatever you have under there. Hope this helps.

Mar 03, 2010 | 2005 Kia Optima

4 Answers

Still loud


Have you checked the flex pipe section under the engine, and the gasket between the manifold and cat/flex pipe section? Those are two places they usually start to leak from either a blown gasket, or the flex section rusts out under the protective covering.

Mar 24, 2009 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...