Question about Cars & Trucks
Need to change transmission fluid. What kind should I use?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: transmission fluid change
More than likely, like most automatic transmissions, yours does not have an oil plug. You need to drop the transmission oil pan to drain the old oil... You need to buy a transmission filter/pan gasket kit. The filter is located on the bottom of the tranny. You will see it when you remove the pan. Replace the filter, thoroughly remove any traces of old gasket material, clean the mating surfaces, and reinstall the pan with the new gasket. Torque the pan bolts to the manufacturers spec (you should be able to get this where you buy the filter/gasket kit). Refill the transmission through the dipstick (Capacity for the Voyager is 4 quarts, make sure to use ATF Plus (Type 7176) for your particular tranny, NOT Dexron, Mercon, or generic automatic transmission fluid, Chrysler transmissions do not like any other kind and tend to fail quite quickly with the wrong fluid). Fill to the full cold level. Start the engine, move the shifter through all gear ranges, and put it back in park. Leave the engine running and refill to cold full. Drive the car for 5-10 minutes and, with the engine still running and the car in park, fill to Hot full. You should be ready to go!
Posted on Aug 26, 2008
The trans don't have a dipstick, they have to be checked at a dealership with a vag tool, they have to be checked at a certian temperature of operation, as far as fluid i would use the audi recommended G-052-162-A2 atf fluid required
Posted on Dec 01, 2008
LISTEN CLOSE. THERE IS A PLUG ON PAN. REMOVE IT. WITH A SYRINGE TYPE CANISTER YOU NEED TO INJECT THE FLUID INTO IT UNTIL IT STARTS TO COME OUT. THEN CAREFULLY START VEHICLE AND INJECT ANOTHER 3/4 QUART UNLESS IT STARTS TO COME OUT OR EVEN A QUART.LET IT RUN FOR 5 MINUTES THEN CONTINUE TO INSERT UNTIL IT OVERFLOWS AND TIGHTEN THE PLUG BACK TO THE PAN. i WOULD ONLY USE AUDI VOLKSWAGON FLUID AND YES IT CAN RUN $14 TO $18 A LITER
Posted on Apr 06, 2009
Drain fluid with drain plug on bottom of pan.Remove pan and change filter. Reinstall pan with new gasket torque to factory spec.Have car on level ground.Remove fill plug on side of pan.Install new fluid with pump and hose. You can use old gear oil bottle and hose.Fill to bottom of fill hole. Put foot on brake with car running shift though all gears.Go back to fill plug and top off till it runs out hole.This should do it.
Posted on Sep 12, 2009
Tips for a great answer:
Feb 13, 2014 | 1997 Audi Cabriolet
Jan 29, 2014 | 2003 Audi A4 Cabriolet
Jan 22, 2011 | 1997 Audi A4
Nov 15, 2010 | 2008 Audi A8
Sep 11, 2010 | 1998 Audi Cabriolet
Jun 22, 2010 | 2003 Audi A4 Cabriolet
Feb 28, 2010 | 2005 Audi A4
Jun 25, 2009 | 1997 Audi A4
Nov 11, 2008 | 1997 Audi A4
37 people viewed this question
Usually answered in minutes!