Question about Cars & Trucks

Open Question

2007 chevy malibu wont start error reading on odometer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3640 Answers

SOURCE: dtc code p0121 and p2135 2007 chevy malibu

both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.

Posted on Feb 20, 2010

Ad
  • 46 Answers

SOURCE: my 2007 chevy malibu wont start but all lights and

I would say the battery, if not, then the ignition switch. Is there an antitheft lamp in the dash at all?

Posted on Nov 29, 2010

  • 3640 Answers

SOURCE: 2007 Chevy Malibu

its either a bad wire or ground to tank. or the sending unit in tank is sticking. have a good day !!

Posted on Dec 12, 2010

suarezelec20
  • 259 Answers

SOURCE: My 97 Chevy Malibu's odometer and trip read "error". How to fix?

You'll need to reset the Electronics Control Computer otherwise called the PCM/ECC/ or ECM. You can do this by unhooking the battery cable for about 15 minutes. If this does not reset it, you may have to do it for up to a day then try hooking the cables up again. See if this works.

Posted on Aug 27, 2012

Testimonial: "This did the trick! Thank you so much! "

  • 12154 Answers

SOURCE: 2007 Chevy Malibu won't start, odometer reads error

The odometer will display 'error' if an internal IPC memory failure is detected or if there is a serial data communication fault between the ECM and the BCM. IPC instrument panel cluster .
Circuit Description
The communication among control modules is performed through the GMLAN high speed serial data circuit and the GMLAN low speed serial data circuit. The modules that need real time communication are attached to the high speed GMLAN network. The body control module (BCM) is the gateway between the networks. The purpose of the gateway is to translate serial data messages between the GMLAN high speed buss and the GMLAN low speed buss. The gateway will interact with each network according to that network's transmission protocol. Refer to Body Control System Description and Operation for more information about the gateway.
Your best bet is to take your vehicle to the dealer , sorry !

Posted on Sep 25, 2016

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Chevy Malibu won't start, odometer reads error


The odometer will display 'error' if an internal IPC memory failure is detected or if there is a serial data communication fault between the ECM and the BCM. IPC instrument panel cluster .
Circuit Description
The communication among control modules is performed through the GMLAN high speed serial data circuit and the GMLAN low speed serial data circuit. The modules that need real time communication are attached to the high speed GMLAN network. The body control module (BCM) is the gateway between the networks. The purpose of the gateway is to translate serial data messages between the GMLAN high speed buss and the GMLAN low speed buss. The gateway will interact with each network according to that network's transmission protocol. Refer to Body Control System Description and Operation for more information about the gateway.
Your best bet is to take your vehicle to the dealer , sorry !

Sep 25, 2016 | 2007 Chevrolet Malibu

1 Answer

I have a 2007 Chevy Malibu it wont crank but is reading a error on the dashboard but if I turn the key but the lights will come on and that about it


Hello Delissa,

The first thing to check is your battery. If you have dash lights that doesn't confirm your battery has enough of a charge to turn the engine over.

Is the dash light your SES (Service Engine Soon) light? If so...diagnostics can be accessed via a OBDII code reader and provide a starting point to trouble shoot any registered faults. (Some automotive parts stores offer free code retrieval.)

May 28, 2016 | 2007 Chevrolet Malibu

1 Answer

My 97 Chevy Malibu's odometer and trip read "error". How to fix?


You'll need to reset the Electronics Control Computer otherwise called the PCM/ECC/ or ECM. You can do this by unhooking the battery cable for about 15 minutes. If this does not reset it, you may have to do it for up to a day then try hooking the cables up again. See if this works.

Aug 27, 2012 | Chevrolet Silverado 1500HD Cars & Trucks

1 Answer

Dtc code p0121 and p2135 2007 chevy malibu


both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.

Feb 14, 2010 | 2007 Chevrolet Malibu Maxx LTZ Hatchback

1 Answer

2007 chevy cobalt I went through water wont start


You're hydrolocked. Pull the sparkplugs out and crank the engine for 30-60 secs. there is a VERY GOOD CHANCE you could have done some major internal damage. Be prepared to replace your engine, but this might work.

Jun 24, 2009 | 2006 Chevrolet Malibu Maxx

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...