Question about Cars & Trucks

Open Question

U0101 speedo doesnt work now and trans wont shift out of first

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
shaggyrat
  • 1224 Answers

SOURCE: speedo quit working-- trans

your fluid is low and quite possible you seized your tranny up apply fluid and dont just rely on dipstick for this make sure the tranny is full of fluid

your linkage to transmission might have come apart another reason for no shifting

now for the speedo
there is a little device that connects speedo cable to the tranny and then the mechanical of tranny from there is called a speedo bullet
if you seized your tranny the speedo bullet would have gotten sheared off in side the speedo bullet is wrenched on and can be wrenched off replace the bullet speedo should start working again

Posted on May 30, 2008

Ad
  • 239 Answers

SOURCE: 99 f250 SD 7.3

Your speed sensor in your trans. needs to be checked out sounds like its not working or not getting a good signal until its generating enough power and speed to start until it reaches 30 MPH. Check that out sometimes it could just be some dirt on it. It all makes sense the ABS light is on because its not reading the speed of the tires, and the AOD light is on because It has no idea when to shift into overdrive without knowing how fast its going. I sure Hope that Helps You Out, And Thanks, Bear001

Posted on Jun 17, 2008

jschoon77
  • 55 Answers

SOURCE: Speedometer goes to 0 and trans downshifts

There are 2 speed sensors on the transaxle. One is for vehicle speed and one is for trans output shaft speed. My guess is that you replaced the one for output shaft speed.

Nissan Scope Technician- 10 years with Nissan

Posted on Oct 29, 2008

  • 33 Answers

SOURCE: 1995 buick lesabre Speedo inop

I would have the transmission shop check out the transmission.
The transmission may have a soleniod issue.

Posted on Feb 01, 2009

SOURCE: 1997 ford taurus 3.0 ltr trans wont shift into

Solenoid pack in trans. Position module,is just that. Wrong guess. What tran model do you have? You also have other sensors to consider but have to know the trans your working on and the computer and shift stratagy involved to solve this,even if your throwing parts at it.

Posted on Feb 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 chev 4x44l60 trans,np241c tcase,speedo stopped working trans immedeatly stopped shifting past 2 gear


FIX SPEEDO MAY NEED A SPEED SENSOR AND IT WILL NOT SHIFT IF IT DOES NOT SEE THE OUT PUT SPEED

Feb 21, 2013 | Cars & Trucks

1 Answer

Dodge avenger speedo sticks and doesnt seem to shift correctly after speedo sticks


Sticks? Where? Zero miles per hour, or a value above that? The problem is likely the speedo "head", the part immediately behind the speedometer that makes it work. And if the speedo is not working right, the trans will not either. It might be worthwhile to have it "scanned" to see if the computer can identify the cause of the fault.

Apr 18, 2011 | Dodge Avenger Cars & Trucks

1 Answer

I have a 2001 camaro that wont shift out of 1st gear and the speedo does not work either. i just put the engine and trans in out of a donor car (a 2000 camaro) both had 3800 series ll engines and 4l60e...


thats an interesting problem, i would be looking for either a pinched wire or i would also look at the plastic gear on the end of the vss they must be the same color and they should be interchangeable if the are not the same, and while you have the vss out look inside the hole where it goes and make sure the drive gear for the vss is still intact inside the tranny. The reason the tranny does not shift is because of the speedo not working the computer needs to know how fast the car is moving to determine the proper shift points for the tranny.Hope this helps

Sep 04, 2009 | Chevrolet Camaro Cars & Trucks

1 Answer

Won't shift out of first gear


good diagnosis that is correct if the vehicle speed sensor is not working the speedo doesnt work and the trans doesnt know when to shift

Jul 17, 2009 | 1998 Ford Windstar

1 Answer

Transmission not shifting


Sounds like a speedo gear in the transmission ... I think the tahoe one had a speedo cable the speed sensor is located in the speedo ... will cause all those to fail if speedo is not working as did in my Astrovan

Apr 17, 2009 | Chevrolet Tahoe Cars & Trucks

1 Answer

Car's Speedo wont work and tranny malf


inspect the throttle valve control rod. there could be a small part that has worn out, usually made of plastic and the size of a dime. if this part is missing out worn out it will make the trans shift at the wrong time. it happened to my lincoln once and i thought the trans was going out.

Feb 24, 2009 | 1996 Ford Taurus

1 Answer

2003 grand caravan transmission will not shift out of low


it sounds as though your transmission input and output sensors are faulty.they are located on the driver side of transmission.input at front of trans.output at rear of transmission. normally if input sensor is faulty trans will stay in limp mode. if output sensor is faulty speedo will not register. they both resemble temp sensors with elec connectors

Feb 12, 2009 | 2003 Dodge Grand Caravan AWD

1 Answer

1995 buick lesabre Speedo inop


I would have the transmission shop check out the transmission.
The transmission may have a soleniod issue.

Feb 01, 2009 | 1997 Buick LeSabre

1 Answer

Speedometer goes to 0 and trans downshifts


There are 2 speed sensors on the transaxle. One is for vehicle speed and one is for trans output shaft speed. My guess is that you replaced the one for output shaft speed.

Nissan Scope Technician- 10 years with Nissan

Oct 26, 2008 | 1999 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...