Question about Cars & Trucks

Open Question

How do I remove inner rear panel on my 2007 Chevrolet Cobalt LT coupe

Not the door panel but the inner rear driver side panel on a 2- door car. I'm trying to knock out a dent.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: How to remove rear door panel on 2003 Chevrolet Malibu?

not sure but have the same prob.

Posted on Aug 13, 2008

brandyspoile
  • 61 Answers

SOURCE: how to remove inner window crank on 2006 chev cobalt 2 dr

the handle part of the crank is held on by a small ring, you will need a small flat head screw driver- i used a butter knife, as it works better- push the door panel back just enough you can see behind the round part of the handle, you should be able to see the foot of the clip, push it off, make sure you don't do this in the grass, the ring will roll when it falls off. **please note this is a flat ring and only about the diameter of your little finger**

Posted on Nov 25, 2008

  • 295 Answers

SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora

The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.

Good luck

Posted on Mar 21, 2009

  • 69 Answers

SOURCE: How to remove/replace driver's side mirror on 96 blazer

remove door panel.. there should be access hole to get to the bolts.

Posted on Jul 31, 2009

  • 1986 Answers

SOURCE: door panel removal for 2002 9-5 on driver rear

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove rear seat bottom from a 2007 cobalt ls


Push the front of the seat rearward and upward to release the seat

Sep 06, 2016 | 2007 Chevrolet Chevrolet Cobalt LT

1 Answer

Here is the fuse box located on 2007 chevy cobolt


Where? There is one under the hood and there is one under the dash on the drivers side. Check the side of the dash with the door open on the drivers side.

May 07, 2014 | 2007 Chevrolet Cobalt Coupe

1 Answer

How do I change the rear turn signal on a 2007 cobalt?


pull away the panel in the back of the car , under it you'll see the wires that go to the rear lights, 1/4 turn and the bulb comes out, replace the bulb and return it the way it came out,, ( note, One of the tabs on the bulb socket holder is larger than the other 2 so make sure your installing it correctly

Aug 11, 2011 | 2007 Chevrolet Cobalt Coupe

1 Answer

I have a 2006 Chevy Cobalt that I bought used. Didn't have the remote for the door locks. I can unlock all of the doors from the driver's side, however I can't lock them. Any suggestions?


check the lock side of the switch, its not connecting, remove the switch and test it, if the doors will unlock its letting you know the plungers are working, and that to lock its not getting any power to reverse the action, ( check the individual doors, if they work both ways,, then its the drivers door switch that's faulty

Aug 10, 2011 | 2007 Chevrolet Cobalt Coupe

1 Answer

Where is the crankshaft position sensor located on a 2007 Chevrolet Cobalt SS/SC?


look on side cylinder block beside starter.you have to remove the starter to remove the crankshaft sensor.

Apr 17, 2011 | 2007 Chevrolet Cobalt Coupe

1 Answer

How to fix door handle on chevrolet cobalt 2008


Have to remove inner door panel and is usually 2 bolts around 10mm that hold handle in, but the rods must be removed first and these rods are only held in place by a spring steel clip that just flips out off the rod at the handle end.
To remove door panel - look for visible screws under and around the edges and or handles, remove all these. If window is winding type a horse-shoe clip holds the handle on and can be pushed off with a screw-driver if you push the panel away from handle and look behind the handle.
Then take a putty knife and or butter knives and insert between door and panel to pop plastic clips from door then lift on panel to remove from window jam.  Be careful of wires and plugs after this.  Remove plug clips and place panel aside.  Remove plastic and sound-proofing if any in the corner near the handle and a 10mm 1/4" drive ratchet to remove bolts on each side of handle.
This is a general answer but should work for the Cobalt as well.
East Coast Canada Rocks!!
:))

Jun 09, 2010 | 2008 Chevrolet Cobalt

1 Answer

Passenger door removal for radio speaker access.


YOU NEED A DOOR PANEL FLAT TOOL AND WINDOW CRANK CLIP TOOL IF YOU DONT HAVE POWER WINDOWS. A HAYNES REPAIR MANUAL TO SHOW YOU HOW TO REMOVE DOOR PANEL.

Apr 04, 2010 | 2007 Chevrolet Cobalt Coupe

1 Answer

Cobalt Engine


did you ck the oil if its full its probly a shield hitting aginst fly wheel need to have somone ck out

Nov 27, 2008 | 2007 Chevrolet Cobalt Coupe

1 Answer

Chevy cobalt lt 2007


It sounds like there is something very major wrong with your ride. I think it would have something wrong with the fuse box or computer system.

Aug 20, 2008 | 2007 Chevrolet Cobalt Coupe

2 Answers

2007 Chevy Cobalt LT Coupe


it is not a battery in our engine it is all the fuses i thought the same thing pull the black cover off and you will see there is only one battery and it is in the trunk

Jul 16, 2008 | 2007 Chevrolet Cobalt Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...