Question about Cars & Trucks

Open Question

Free ford transmission diagrams 1999 f150 - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
PyroPCMan
  • 405 Answers

SOURCE: 1991 Ford Ranger manual transmission remove

444a343.jpg

  1. Disconnect the negative battery cable.
  2. Remove the gearshift lever assembly from the control housing.
  3. Cover the opening in the control housing with a cloth to prevent dirt from falling into the unit.
  4. Raise the vehicle and support it safely.
  5. On 2WD vehicles, matchmark the driveshaft to the rear axle flange. Position a drain pan under the tailend of the transmission. Remove the driveshaft-to-rear axle flange fasteners and pull the driveshaft rearward to disconnect it from the transmission.
  6. Disconnect the clutch hydraulic line a the clutch housing. Plug the lines.
  7. Disconnect the speedometer from the transfer case/extension housing.
  8. Disconnect the starter motor, back-up lamp and, if equipped, neutral sensing switch harness connector.
  9. Place a wood block on a service jack and position the jack under the engine oil pan.
  10. On 4WD vehicles, remove the transfer case from the vehicle.
  11. Remove the starter motor.
  12. Position a transmission jack, under the transmission.
  13. Remove the transmission-to-engine retaining bolts and washers.
  14. Remove the nuts and bolts attaching the transmission mount and damper to the crossmember.
  15. Remove the nuts and bolts attaching the crossmember to the frame side rails and remove the crossmember.
  16. Lower the engine jack slightly to angle the transmission assembly. Work the clutch housing off the locating dowels and slide the clutch housing and the transmission rearward until the input shaft clears the clutch disc.
  17. Lower the transmission jack and remove the transmission from the vehicle.
To install:
  1. Check that the mating surfaces of the clutch housing, engine rear and dowel holes are free of burrs, dirt and paint.
  2. Place the transmission on the transmission jack. Position the transmission under the vehicle, then raise it into position. Align the input shaft splines with the clutch disc splines and work the transmission forward into the locating dowels.
  3. Install the transmission-to-engine retaining bolts and washers. Tighten the retaining bolts to specifications. Remove the transmission jack.
  4. Install the starter motor. Tighten the attaching nuts.
  5. Raise the engine and install the rear crossmember, insulator and damper and attaching nuts and bolts. Tighten and torque the bolts to specification.
  6. On 4WD vehicles, install the transfer case.
  7. On 2WD vehicles, insert the driveshaft into the transmission extension housing and install the center bearing attaching nuts, washers and lockwashers. Connect the driveshaft to the rear axle drive flange.
  8. Connect the starter motor, back-up lamp and, if equipped, neutral sensing switch connectors.
  9. Connect the hydraulic clutch line and bleed the system.
  10. Install the speedometer cable.
  11. Check and adjust the fluid level.
  12. Lower the vehicle.
  13. Install the gearshift lever assembly. Install the boot cover and bolts.
  14. Reconnect the negative battery cable.
  15. Check for proper shifting and operation of the transmission.
The above was pulled frrom:
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800391da

hope this helps

Posted on Jul 02, 2008

Ad
  • 208 Answers

SOURCE: wiring

It is not downloadable, but the library will probably have a Mitchell repair manual with wiring diagrams.

Posted on Jul 21, 2008

outdoorsman5
  • 631 Answers

SOURCE: i need to know the firing diagram for my ford f150 1999

If you are standing at the front of your vehicle the left side would be the passenger side front is 1234....drivers side front to back 5678.
Firing order is as follows 13726548. If you don't understand this let me know and I will get you a pic.

Posted on Aug 04, 2009

  • 5 Answers

SOURCE: 2002 ford f150 4.2l wiring diagram

The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5 ----------------------------------------------------------------- The engine cylinders / spark plugs are numbered : passenger side , front to rear , 1 , 2 , 3 -----drivers side , front to rear , 4 , 5 , 6 ------------------------------------------------------------------- The spark plug firing order is ( 1 -4 - 2 - 5 - 3 - 6 )

Posted on Aug 11, 2010

  • 158 Answers

SOURCE: transmission control solenoid location for 96 ford f150

whether it is the smaller (4R70w) or the bigger (E4OD), the solenoids are under the pan. The E4OD solenoids are in one big block where the other trans has them seperated

Posted on Aug 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 f150 4.6L 4r70w automatic transmission.truck will go in reverse goes into park and nutral but will no engage into drive. what is the problem?


Could be valve body problems, shift solenoid or the TCM. If all check out good then I'd overhaul the transmission.

Sep 27, 2016 | 1999 Ford F150 Regular Cab

1 Answer

Brake line diagram 1999 f150


Hey guys looking at that diagram, just below the Line #1 on this side there is a fitting installed into the block, actually three of them but the one closest to us looking at the diagram is leaking on my 99 Ford Lightning. Any ideas why or how to fix it?

Feb 01, 2012 | Ford Cars & Trucks

1 Answer

I need the fuse box diagram


Go to the link below to get the diagram page 150-151. That is the owners manual for the 1999 f150 truck.

http://www.motorcraftservice.com/pubs/content/~WOXF12/~MUS~LEN/36/99f12og1e.pdf

Good Luck

Nov 08, 2010 | 1999 Ford F150 Regular Cab

2 Answers

Firing order diagram for 1999 F150 5.4 l engine


1999 Ford F 150 Pickup 5.4 liter V-8 Prop SOHC VIN "Z"
and
1999 Ford F 150 Pickup 5.4 liter SOHC V-8 VIN "L"

e9208fe.gif


1999 Ford F 150 Pickup 5.4 liter SOHC V-8 VIN "3"

db1422a.gif


Hope helps (remember rated and comment this).

Aug 16, 2010 | 1999 Ford F150 Regular Cab

1 Answer

Serpentine belt configuration


For the 1991 Ford F150:

Click
on the following Free direct Link.
It has several Diagrams including the correct Belt Diagrams for you 1991 Ford F150 with your unspecified Engine Size and various Engine Options.


http://www.2carpros.com/car_repair_information/year/1991/make/ford/model/pickup/1991_ford_pickup_drive_belt_routing_diagram.htm

Apr 13, 2010 | 1991 Ford F150

1 Answer

Looking for diagram for fuse box for a 1999 Ford F150


Go to fleet.ford.com select the maintenance tab and select owners manuals fill in your info and you can download it for free. Hope this helps, let me know.

Apr 13, 2010 | 1999 Ford F150 Regular Cab

1 Answer

Ford f150 overdrive light flashes


This usually means there is a transmission related fault. There is probably a error code stored, and your transmission may be in limp mode; usually 2nd gear only. I don't know if Autozone can read trans codes. This may be a dealer only repair. Have you checked your transmission fluid?

Dec 19, 2009 | 1999 Ford F150 Regular Cab

1 Answer

I have a 1999 ford f150 with a 4.6l engine. My od


When you get that, it means you are nearing transmission failuer. If you have warranty on the truck, take it to the dealership. If not, swing on by AAMCO and have them inspect it....this is a free service and they will not perform maintenance on it without your consent. It also lets you know what item can be fixed.

Mar 15, 2009 | 1999 Ford F150 Regular Cab

1 Answer

Looking for a wiring diagram for a 1999 Ford F350 Diesel. Anyone got one???


1999 ford f250 diesel electrical system diagram free|Free eBook ... The 1999 ford f250 diesel electrical system diagram free Documents at ... That's a Ford Tractors wiring diagrams and Harnesses contributed by Neil Reitmeyer ...
www.ebooksquad.com/search/1999+ford+f250+diesel+electrical+system+diagram+free - 22k

Aug 10, 2008 | 1994 Ford F350 Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...