Question about Cars & Trucks

Open Question

2006 volvo s60 running rough and check engine light on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
dsacco86
  • 1077 Answers

SOURCE: engine codes P0101 and P0170

P0101 Mass or Volume Air Flow Circuit Range/Performance Problem
Air flow sensor problem, maybe causing the second code to go off.
The air flow sensor should be right near your air filter box.
P0170 Fuel Trim Malfunction (Bank 1) Oxygen Sensor

Posted on Mar 27, 2009

Ad
Molson02536
  • 3854 Answers

SOURCE: check engine light code PO442

You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. 
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.

With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.

Good luck and hope this helps

Posted on May 07, 2009

  • 56 Answers

SOURCE: volvo s60 idle sensor

if you could get your hands on a scanner to read some live data it would help your plight,there is a cam position sensor when you take of the the plastic head cover at the timing belt end,did you check plugs,it also might help to clean the maf with some contact spray,sounds like plugs

Posted on May 27, 2009

  • 1 Answer

SOURCE: 2001 Volvo S60 2.4 won't start

try to start your car with the valet key instead of master should start right up problem is master key.

Posted on Jun 01, 2009

  • 18 Answers

SOURCE: Volvo S60 sensor ?

Sounds like an oxygen sensor (there are two). I had a recent problem where I had a rough idle and my S60 continued to stall out. Turned out to be the rear oxygen sensor. After replacement, car idles nicely and car drives normally.

Posted on Jun 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Volvo s60 shaking and check enjine light on


Have your car scanned for trouble codes and repair as necessary. More than likely you have a misfire due to worn ignition components: spark plugs, wires,etc.

Feb 07, 2016 | 2003 Volvo S60

1 Answer

Lately hard to start and idles roughly while cold


If it has not generated a "check engine " light, troubleshooting will be more difficult. You have a Cold Routine for starting that is triggered by temperature. It is possible that a temperature sensor is not good and therefore the Cold Routine is not cycling.

Contact Autozone, or Advance autoparts for a scan or talk about this part that you may need.

Dec 24, 2011 | 2001 Volvo S60

1 Answer

What to do when the maintenance light come on in the volvo s60 2006


You have to have it reset. This is done by Volvo after the car has been serviced.

However, all you need do is go to a workshop and pay them a small fee to connect your car to their equipment and reset the light.

Aug 13, 2010 | 2006 Volvo S60

1 Answer

Replaced rear wheel bearings 2006 Volvo S60 and ABS lite stays on


Make sure the abs sensor is plugged in all the way.. And also make sure that the abs ring.. was not damaged in the process of putting on the new bearing...

Mar 02, 2010 | 2006 Volvo S60

1 Answer

My 2002 Volvo S80 is running very rough and a light is on that says, "Engine System Service Required". Can someone help?


Hello. I recommend that you take your vehicle to an autozone, or other autoparts store, or a volvo dealership and get it scanned. That is the only way to pinpoint the issues that are generating the engine system service required message. I would do this ASAP so that you do not find yourself stranded somewhere. good luck with it. regards, Joe

Nov 20, 2009 | 2002 Volvo S60

1 Answer

Our 2004 volvo S60 is running really rough what


dirty air filter, fuel filter,fowled spark plugs,faulty ignition coils, faulty tps. sensor or maf. sensor, crank or cam sensors

Oct 03, 2009 | 2004 Volvo S60

4 Answers

Volvo S60 sensor ?


Sounds like an oxygen sensor (there are two). I had a recent problem where I had a rough idle and my S60 continued to stall out. Turned out to be the rear oxygen sensor. After replacement, car idles nicely and car drives normally.

Dec 16, 2008 | 2004 Volvo S80

1 Answer

Flashing Check Engine Light


sounds like a misfire issue or a boost control valve

Oct 02, 2008 | 2001 Volvo S60

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...