Question about Cars & Trucks

1 Answer

My dashboard gauges ate not working on my 1998 Lincoln continental how do i get it to work and light up

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Locate fuse boxes,check each fuse one by one,replace all bad or burnt fuses

Posted on Jul 24, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Diagram for 1998 lincoln continental

how do i ronte a serpentine engine belt on a 1998 lincoln continental

Posted on Sep 16, 2008

  • 136 Answers

SOURCE: dashboard gauges dont work, 1998 dodge caravan

These vehicles seem to have a problematic short, my grandfather has the same vehicle with the same problem, i found the short under the carpet on the driver side of the vehicle, under the gas pedal, sometimes wires can crack and break.

MIKE

Posted on Jun 01, 2009

  • 255 Answers

SOURCE: 1998 plymouth voyager gauges on dashboard not

well start by checking all fuses but it sounds like a bad ground wire somewhere on the car

Posted on Aug 15, 2009

  • 1986 Answers

SOURCE: replace rear brake light bulb 1998 lincoln continental

pop the trunk and right behind where the lights are pull the carpet down and their will be of the following depending on the trim.

You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.

If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk

Posted on Oct 26, 2009

  • 18 Answers

SOURCE: 1998 Ford Escort dashboard warning lights and gauges not working.

Sounds like possibly the ignition switch is going out. Try jiggling the key in the ignition in the on position and see if your lights come back on.

Posted on Feb 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 Lincoln Town Car Signature Series alternator was over charging I took the battery cable off while the car was running and the dashboard starting to smoke and none of my lights are working...


You'll probably need a shop manual to get all of the wiring diagrams.
It sounds like you fried several main wires in the harness.
The excessive voltage may have cooked the gauge cluster and fed back thru the headlight switch. The warning light on the dash provides the circuit to "turn on" the alternator when the engine starts.

Dec 02, 2014 | 1998 Lincoln Town Car

1 Answer

1997 Lincoln Continental - Speedometer Not Working


Does the odometer work? If so,you'll have to pull the gauge cluster out to send for repair.If the odometer doesn't work either,you may have a bad or disconnected VSS(vehicle speed sensor-located on the tailshaft housing of the transmission)

Oct 27, 2012 | 1997 Lincoln Continental

1 Answer

1986 lincoln continental dashboard lights won't work help??


what if nothing across the dashboard come up because the lighting does not work, can't see speed odometer or nothing?

Feb 07, 2012 | 1986 Lincoln Continental

2 Answers

Brake lights wont come on but the third brake light works


There is a separate switch for the third brake light.
Put on your flashers to ensure that your brake lights are working.
Then first look on your gas pedal linkage to locate the brake light switch.
Gary

Jul 21, 2011 | 1998 Lincoln Continental

2 Answers

My blinkers and hazard lights dont work on my 98 Lincoln Continental


Have you Checked the fuse ? And do you own a test light ? Regards, Lee

Aug 12, 2010 | 1998 Lincoln Continental

1 Answer

LOCATION OF TURN SIGNAL FLASHER ON A 1998 LINCOLN CONTINENTAL


It is located in the fuse panel under the dashboard on the drivers side. It will look to be about the diameter of a quarter and have 3 prongs when you pull it out. It will also be marked where it is located exactly on the underside of your fuse panel cover.

Aug 10, 2010 | 1998 Lincoln Continental

1 Answer

The AC is working an blowing but the heating is also blowing at the same time. What can fix this problem? It is 1998 Lincoln Continental Town Car.


Could be the vacuum motor blend door problem where the plastic door inside the dashboard is not properly being angled to direct cold air and to block hot air from coming into the cabin.

Aug 06, 2010 | 1998 Lincoln Continental

1 Answer

Compatible engines?


I think you can, I bought a 1998 engine for my 1999 Lincoln continental and they told me that i does not fit i also call the lincoln dealer and told me the same thing. but i took the engine and change over all the sensors and injectors and is working very smooth.

I hope this will help

Jun 14, 2009 | 1998 Lincoln Continental

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...