HOW TO PULL OFF OIL PUMP ON 1995 NISSAN ALTIMA

SOURCE: Location of oil filter on Nissan Altima 2005

The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom of the front of the engine facing toward the right front wheel. I do not have a picture at this time.

Hope this is helpful!


Nissan Scope Technician- 10+ years experience in Nissan dealership.

SOURCE: Nissan Altima 2000 - Engine oil leaking problem.

replace the front oil seal. first i would clean the engine with purple power (degrease etc.) then look at the engine and make sure the leak is not coming from above like possibly the valve cover gasket or from the oil sending unit. try to tighten the bolts on the valve cover and even the oil pan. you never know, you may get lucky. i don't know where you are but front seals are cheap but the labor on the job is what costs you.

ZJ Limited

• 17989 Answers
• Posted on Nov 27, 2009

SOURCE: Howm do I replace a starter on a 1995 Nissan

Nissan 240SX/Altima 1993-1998 Repair Guide

Altima
(see Figures 1, 2 and 3)



Fig. 1: The starter is located to the left of the oil filter housing on the engine block



Fig. 2: The starter motor is removed from the bottom side of the engine compartment



Fig. 3: When installing, be sure to align the starter's mounting bolt holes with those in the engine block

1. Disconnect the negative battery cable.
2. Raise and support the vehicle safely.
3. Remove the starter support bracket, as required.
4. Label and disconnect the starter electrical harness.
5. Support the starter from beneath the vehicle using a jackstand.
6. Remove the starter mounting bolts.
7. Carefully lower the starter from the vehicle.

1. Position the starter on the engine and support it using a jackstand.
2. Install the starter mounting bolts and tighten to 30-37 ft. lbs. (40-50 Nm).
3. Connect the starter electrical harness.
4. Install the starter support bracket, as required.
5. Lower the vehicle.
6. Connect the negative battery cable.

SOURCE: Nissan Altima tring to change my transmission fulid and filter

thats why you have to remove the frame and for this you need an engine support and the average mechanic will charge you arround 100 bucks to do it
some rental stores have them some dont good luck eithor way you go but for god sake be carefull

SOURCE: How to replace knock sensor in 1995 NISSAN ALTIMA?

Remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt covers, remove timing belt remove intake housing once you have remove all the above, your engine will look naked, you can see the location of the knock sensor is locate in the engine valle.