Question about 2007 Peugeot 207 CC

Open Question

Peugeot 207 engine fan not working

Heat sensor was replaced because of guage going up even when cold. now the guage works fine but fan doesn't come on even when hot ?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 41 Answers

SOURCE: oil and handbrake lights flashing peugeot 106 s2

Hi, If you solve engine idle speed fault this will stop warning lights.
Oil preasure falls when engine not at norm rpm because oil pump is not turning fast enough.
Put car on diagnostics to check for any fault codes

Posted on Aug 04, 2009

  • 274 Answers

SOURCE: overheating saxo

i would also check for air locks in cooling system, there is a bleed in the top right corner of the engine bay looks like a dust cap off a tyre valve, there is also one on the stat housing on the left hand side of the head and possably one on the top of the radiator

Posted on Dec 02, 2009

  • 274 Answers

SOURCE: peugeot 406 110 cooling fans not cutting in nor

the problem may be with the 2 relays between the cooling fans the plug conectors corrode and damage the relays
recomend you replace connectors and relays

Posted on Dec 08, 2009

sidebarr2
  • 166 Answers

SOURCE: The service exclamation warning light

Get it code scanned at auto zone for free they will tell you what it is and reset codes,,,could be oil light sensor

Posted on Mar 16, 2011

  • 251 Answers

SOURCE: peugeot 307 1.4 2002 does not start when engine is

Engine is difficult to start when cold

  1. Check the battery condition, battery state of charge and starter motor current draw. Replace the battery if marginal and the starter motor if the current draw is beyond specification.
  2. Check the battery cable condition. Clean the battery terminals and replace corroded or damaged cables.
  3. Check the fuel system for proper operation. A fuel pump with insufficient fuel pressure or clogged injectors should be replaced.
  4. Check the engine's tune-up status. Note the tune-up specifications and check for items such as severely worn spark plugs; adjust or replace as needed. On vehicles with manually adjusted valve clearances, check for tight valves and adjust to specification.
  5. Check for a failed coolant temperature sensor, and replace if out of specification.
  6. heck the operation of the engine management systems for fuel and ignition; repair or replace failed components as necessary.
Engine is difficult to start when hot
  1. Check the air filter and air intake system. Replace the air filter if it is dirty or contaminated. Check the fresh air intake system for restrictions or blockage.
  2. Check for loose or deteriorated engine grounds and clean, tighten or replace as needed.
  3. Check for needed maintenance. Inspect tune-up and service related items such as spark plugs and engine oil condition, and check the operation of the engine fuel and ignition management system.

Posted on Jun 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Thermo fan


A condition of warranty is usually to not only have the car serviced at the correct intervals but also to be able to provide proof of that. If you go to the dealership and ask them to fix your fan they might not ask to see the proof. You might get away with it...

In Europe, vehicle manufacturers and dealers are forced by law to honour warranties as car owners have the right to use any independent garage or workshop, though it still should be documented and proof of genuine parts being used is good politics.

If the dealer refuses there is no reason to waste the journey - you could question a mechanic about the likely cause of the trouble, ask the parts guy if they have been selling a lot of something to do with your problem.

Mar 17, 2017 | Peugeot 207 Cars & Trucks

1 Answer

Peugeot 207 fan assembly not working


sound like engine coolant temperature sensor faulty also coolant level too low.

May 27, 2013 | Cars & Trucks

1 Answer

1992 olds cutlas 3.3litre a/c clutch comes on and off continuiously weather a/c is called for or not on the dash.engine cold or hot. rad fan also comes on when engine is cold and hot keeps cycling. when...


ok the ac will cycle even if its not on thats the way the factory has it set up.
the fan will also cycle the same way. but the temp of the motor has to do with
the thermostat thats whare i would be looking the thermostat may be bad
when you pick up a new one test it if it says 180 deg. that is when its wide
open check it with a temp guage a house hold type in a pot of boiling water
on your stove i have found 1 out fo 6 would be good go figure.
now the censors. one wire tells you temp guage 2 wires tells you its a
switch for the fan while the motor is running use the same house hold
guage a meat thermomiter will work just fine

i hope this helps you BOB !!!

Sep 23, 2011 | 1992 Oldsmobile Cutlass Ciera

1 Answer

TEMP GUAGE JUST QUIT WORKING. COOLANT LEVEL IS FINE, HOSES ARE FINE. EVERYTHING IS COOL TO THE TOUCH. TEMP GUAGE READS BELOW COLD, YET ELECTRIC COOLING FAN COME ON WHEN ENGINE IS SHUT DOWN.


your gage has just gone out and needs to be replace. the computer control the fan. so as long as the temp sensor is connected to the engine it will work fine but you will not know the temp of your vehicle.

Nov 30, 2010 | 2001 Chevrolet Malibu

1 Answer

2002 Peugeot Expert van. Low speed engine cooling fan doesn't work, light on dash next to temp gauge glows dimly. Engine gets over-heated when sat in traffic jams. Do I have a sensor problem please? Very...


try to give power srait to the fans if they work then it is a sensor problem...also try to find the sensor and un plug it and give power to the harnes if the fans go on the it really is the sensor

Sep 23, 2009 | Peugeot Liberte Cars & Trucks

2 Answers

Windscreen washer wont work in my 207 (56 plate)


I HAVE A 2007 207.THE FUSE BOX IS LOCATED ON THE RHS OF THE ENGINE COMPARTMENT.FUSE NO 3 10AMP.I REPLACED FUSE ON MINE AND WORKED FOR A COUPLE OF DAYS AND PACKED IN AGAIN.AM HAVING IT DONE TOMORROW UNDER WARRANTEE 13/1/09.THIS APPEARS TO BE A COMMON PROBLEM

Jan 04, 2009 | 2006 Peugeot 405

Not finding what you are looking for?
2007 Peugeot 207 CC Logo

Related Topics:

646 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...