Question about Cars & Trucks

Open Question

Flash all x999 wiring diagram - Cars & Trucks

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 explorer wont start, anti theft light is flashing fast

you need wiring diagram as it look's that some wire has been damaged and and locate the wire and the exact location from where the wire is damage go to the given link and the repair manual with diagram

Sep 18, 2017 | 2005 Ford Explorer

1 Answer

1995 holden barina wiring diagram

The flashing unit ...Where do I find it ? 1995 Holden Barina

Jun 25, 2012 | Cars & Trucks

1 Answer

Ford red light flashing

Its advisable to see the wiring diagram.See the first diagram to the left side.As per that wiring diagram,you can disconnect and reconnect the wires to reset the key switch.Click the link for wiring diagram:----

Feb 03, 2012 | 2004 Ford Freestar

1 Answer

It is Vitara sidekick 1997 model. Water temp sensor is replaced, the fault code erased, when I start the engine and drive, every thing looks nice, but when I switch off the Ig key and start the engine next...

you can get codes with out scan tool, this is done by counting the engine light flashes, for example a long flash is the first didgt and then faster blinks would be the next number, for example long flash long flash long flash= 3 then fast flash ,fast flash, fast flash, fast flash =4 which would be code 34, to get the codes look in the engine compartment in front of the battery is the connector, you will need a small wire to jump two terminals, jump terminals with wire then turn key on and count flashes, i will give you a diagram to locate connector and it will show you which terminals to jump look at connetor closely to make sure you are jumping the correct terminals, you can turn the key off and on to restart the codes again,this may take you a few trys to get the hang of it but you can restart the codes by just turning the key off and back on, when your done just remove the jumper wire,also a diagram is enclosed to show you how the flashes go, hope this helps ,good luck.

Mar 05, 2011 | 1993 Suzuki Sidekick

1 Answer

Radio wires cut in my car need code and or diagram for jvc-r300

this is easy to do and you musnt be scared.first find 12v permanent ,then 12v switchable,ground ,ignore electric aerial which is normally blue or yellow use a piece of twin flex connected to battery and flash speakers so you know which is where,good clue is speakers have same coloured wires but one has a black or white flash through it .And away you go music

Jan 27, 2009 | 2003 Hyundai Accent

1 Answer

I need to add a trailer light plug to my truck. i need the tail light wiring diagram for a 2005 toyota tacoma pickup.

The diagram will do you no good it you do not have amber turn signals on your trailer. What you need is a "black box" that, when wired correctly, interprets the amber turn signal on the truck into a pulsed flash to the red brake lamp on the trailer. If the trailer does not have amber turn signals, it is impossible to wire a harness with a diagram. Sorry.

Aug 08, 2008 | 1995 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides