Question about SsangYong Rexton

2 Answers

After changing fan belt on my 2005 sangyong rexton the vehicle is not moving smooth?

Hi, Please help my mechanic changed the fan belt yesterday, since then the vehicle is jecking and after driving for say 1 km, the engine light is coming on on my ssangyong rexton 2.7 XDI with auto transmission.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Some vehicles require the pulleys to be aligned to top dead center before putting on the belt, if this is the case it would not run properly. take it back to the mechanic and tell him to fix it.

Posted on Oct 31, 2014

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • SsangYong Master
  • 12,223 Answers

Go to www.automecanico.com and translate this website amazing with your browser and fix it.
God bless you

Posted on Jul 23, 2013

Testimonial: "thanks for the response, however, can it be in english"

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 261 Answers

SOURCE: no auto drive after engine change (auto)

after changing the fly wheel did you re instal the torque converter before you hooked up the transfer case? 2 have you checked the trans fluid ??

Posted on Nov 24, 2008

  • 14585 Answers

SOURCE: The engine light went on

Could be anything. Stop an autoparts store and they will scan it for free. Let me know and we can go from there. Unless it's really simple, like a loose gas cap.
Randy

Posted on Nov 10, 2010

  • 61 Answers

SOURCE: 2005 RX330. P0018. new timing belt in vehicle(from

bad ecm

Posted on Jan 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i scan a rexton 2.7 and came back p0215 wath that is ? any body can help please?


P0215 Fuel Shut Off Solenoid -Circuit Malfunction

Hopes this helps as iam not familar with this vehicle

Oct 25, 2014 | 2005 SsangYong Rexton

1 Answer

Engine belt diagram ssangyong rexton


look under the hood for diagram....

May 27, 2014 | 2005 SsangYong Rexton

1 Answer

Ssang Yong RX 290


give me the diagram of the belt . for my car sangyong rexton rx 290

Mar 19, 2014 | SsangYong Rexton Cars & Trucks

2 Answers

Where is the oils filter located on a Diesel Sangyong Texton 2005 Merc DXi270


The oil filter for the diesel Rexton is behind the engine block on the passengers side. If you remove the plastic engine cover and stand next to the passengers mirror, you will see the casing next to the firewall.

Aug 17, 2012 | 2006 SsangYong Rexton 270

1 Answer

I have a Sangyong Rexton 270Xdi year 2004. The signal '4WD Check' coming out at the dash board. The gear position only show 'D' at all time.(Normally it will change from D1 to D5) The max speed hardly...


The most likely problem is the Throttle position sensor, which is attached to the side of the injector pump. If this sends the wrong signal it will be interpreted as a TCU fault.

It can be tested seperately with a volt meter and reset.

The electrical connections leading to the TPS and other parts of the gearbox should also be checked to make sure they are clean and well connected. This is a common fault with this type of vehicle.

I doubt if the TCU itself is faulty. Dont let the garage just throw parts at your car in the hope it will fix it.

Apr 20, 2011 | Mercedes-Benz M-Class Cars & Trucks

1 Answer

Is there any bad effects of blanking off the egr on my sangyong rexton 2.7 i have heard that the ecu recognices it as a fault


Hi,
yes, there will be a bad effect if you do that. The ECU will not be able to exercise it's engine management role correctly, and the performance of the car will be affected.

Good luck.

Jan 31, 2011 | 2006 Mercedes-Benz ML-Class

1 Answer

I would just like to know the process of changing the cam belt on my v70 2.4 xt v reg what tools do i need ect i am an agricultural mechanic so i should be capable of getting the job done


Hi:
Changing the timing belt isn't particularly difficult, but does take a little time and you do need some good instructions too. I have changed many of them, and I usually change the water pump and tensioner as well.
A good investment is to spend around $20 at:

www.alldatadiy.com and get a subscription to your particular vehicle. They have good pictures and instructions on almost all tasks on a vehicle, and have helped me tackle some tough jobs.
Hope this helps you get yours fixed too...

Jan 22, 2010 | 2005 Volvo V70

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

393 people viewed this question

Ask a Question

Usually answered in minutes!

Top SsangYong Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

terry stevens

Level 3 Expert

991 Answers

Are you a SsangYong Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...